Szabolcs Beke
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Szabolcs Beke has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Alberto Diaspro
Istituto Italiano di Tecnologia
4 shared publications - Fernando Brandi
Istituto Italiano di Tecnologia
3 shared publications Ilaria Romano
Department of Nanophysics, Istituto Italiano di Tecnologia (IIT), Via Morego 30, 16163 Genova, Italy
3 shared publicationsBalazs Farkas
Department of Nanophysics, Istituto Italiano di Tecnologia (IIT), Via Morego 30, 16163 Genova, Italy
2 shared publicationsL. Kőrösi
Department of Biotechnology, Nanophage Therapy Center, Enviroinvest Corporation, Kertváros u. 2, H-7632 Pécs, Hungary
2 shared publicationsMarina Rodio
Department of Nanophysics, Istituto Italiano di Tecnologia (IIT), Via Morego 30, 16163 Genova, Italy
2 shared publications
Latest Publications
- Open Access
- 3 May 2016
- Published by Hindawi Limited in Journal of Chemistry
- Vol. 2016, 1-8
Ultrasmall, Ligand-Free Ag Nanoparticles with High Antibacterial Activity Prepared by Pulsed Laser Ablation in Liquid
Since ancient times, silver and its compounds have been known to have a broad spectrum of antimicrobial activities for bacteria, fungi, and viruses. Due to the increasing bacterial resistance to classic antibiotics, the investigations of Ag NPs have increased. Herein, we present the preparation of ligand-free Ag NPs with 3 and 20 nm sizes by applying picosecond laser ablation in liquid at 355 and 1065 nm. Our laser processing system allows a high control on particle sizes. The produced nanoparticles were characterized by means of transmission electron microscopy, UV-Vis spectroscopy, and X-ray diffraction. The size effect on the antibacterial activity of Ag NPs was tested againstE. coliandS. aureus. The growth curves of bacteria were monitored at 0–5 mg/L of Ag NPs by a multimode microplate reader. The size effects as well as the concentration of Ag NPs on their antibacterial activity are discussed.
- 3 May 2016
- Published by Hindawi Limited in Journal of Chemistry
- Vol. 2016, 1-8
Open AccessUltrasmall, Ligand-Free Ag Nanoparticles with High Antibacterial Activity Prepared by Pulsed Laser Ablation in Liquid
Since ancient times, silver and its compounds have been known to have a broad spectrum of antimicrobial activities for bacteria, fungi, and viruses. Due to the increasing bacterial resistance to classic antibiotics, the investigations of Ag NPs have increased. Herein, we present the preparation of ligand-free Ag NPs with 3 and 20 nm sizes by applying picosecond laser ablation in liquid at 355 and 1065 nm. Our laser processing system allows a high control on particle sizes. The produced nanoparticles were characterized by means of transmission electron microscopy, UV-Vis spectroscopy, and X-ray diffraction. The size effect on the antibacterial activity of Ag NPs was tested againstE. coliandS. aureus. The growth curves of bacteria were monitored at 0–5 mg/L of Ag NPs by a multimode microplate reader. The size effects as well as the concentration of Ag NPs on their antibacterial activity are discussed.
- Open Access
- 25 November 2015
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 6 (1) , 2217-2223
Fabrication of hybrid nanocomposite scaffolds by incorporating ligand-free hydroxyapatite nanoparticles into biodegradable polymer scaffolds and release studies
We report on the optical fabrication approach of preparing free-standing composite thin films of hydroxyapatite (HA) and biodegradable polymers by combining pulsed laser ablation in liquid and mask-projection excimer laser stereolithography (MPExSL). Ligand-free HA nanoparticles were prepared by ultrafast laser ablation of a HA target in a solvent, and then the nanoparticles were dispersed into the liquid polymer resin prior to the photocuring process using MPExSL. The resin is poly(propylene fumarate) (PPF), a photo-polymerizable, biodegradable material. The polymer is blended with diethyl fumarate in 7:3 w/w to adjust the resin viscosity. The evaluation of the structural and mechanical properties of the fabricated hybrid thin film was performed by means of SEM and nanoindentation, respectively, while the chemical and degradation studies were conducted through thermogravimetric analysis, and FTIR. The photocuring efficiency was found to be dependent on the nanoparticle concentration. The MPExSL process yielded PPF thin films with a stable and homogenous dispersion of the embedded HA nanoparticles. Here, it was not possible to tune the stiffness and hardness of the scaffolds by varying the laser parameters, although this was observed for regular PPF scaffolds. Finally, the gradual release of the hydroxyapatite nanoparticles over thin film biodegradation is reported.
- 25 November 2015
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 6 (1) , 2217-2223
Open AccessFabrication of hybrid nanocomposite scaffolds by incorporating ligand-free hydroxyapatite nanoparticles into biodegradable polymer scaffolds and release studies
We report on the optical fabrication approach of preparing free-standing composite thin films of hydroxyapatite (HA) and biodegradable polymers by combining pulsed laser ablation in liquid and mask-projection excimer laser stereolithography (MPExSL). Ligand-free HA nanoparticles were prepared by ultrafast laser ablation of a HA target in a solvent, and then the nanoparticles were dispersed into the liquid polymer resin prior to the photocuring process using MPExSL. The resin is poly(propylene fumarate) (PPF), a photo-polymerizable, biodegradable material. The polymer is blended with diethyl fumarate in 7:3 w/w to adjust the resin viscosity. The evaluation of the structural and mechanical properties of the fabricated hybrid thin film was performed by means of SEM and nanoindentation, respectively, while the chemical and degradation studies were conducted through thermogravimetric analysis, and FTIR. The photocuring efficiency was found to be dependent on the nanoparticle concentration. The MPExSL process yielded PPF thin films with a stable and homogenous dispersion of the embedded HA nanoparticles. Here, it was not possible to tune the stiffness and hardness of the scaffolds by varying the laser parameters, although this was observed for regular PPF scaffolds. Finally, the gradual release of the hydroxyapatite nanoparticles over thin film biodegradation is reported.
- 1 October 2015
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 55, 14-21
Four-order stiffness variation of laser-fabricated photopolymer biodegradable scaffolds by laser parameter modulation
- 1 October 2015
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 55, 14-21
Four-order stiffness variation of laser-fabricated photopolymer biodegradable scaffolds by laser parameter modulation
- 1 November 2014
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 44, 38-43
Improved cell activity on biodegradable photopolymer scaffolds using titanate nanotube coatings
- 1 November 2014
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 44, 38-43
Improved cell activity on biodegradable photopolymer scaffolds using titanate nanotube coatings
- 1 May 2013
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 33 (4) , 2460-2463
Titanate nanotube coatings on biodegradable photopolymer scaffolds
- 1 May 2013
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 33 (4) , 2460-2463
Titanate nanotube coatings on biodegradable photopolymer scaffolds