Jindaporn Jamradloedluk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jindaporn Jamradloedluk has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Chalida Niamnuy
Center of Advanced Studies in Industrial Technology Department of Chemical Engineering Faculty of Engineering Kasetsart University Bangkok Thailand
1 shared publication- Charoenporn Lertsatitthanakorn
King Mongkut's University of Technology Thonburi
1 shared publication M. Rungsiyopas
Burapha University
1 shared publicationMali Nachaisin
Faculty of Engineering Mahasarakham University Kantarawichai Maha Sarakham 44150 Thailand
1 shared publicationSakorn Inthachai
Mahasrakham Univ, Fac Engn, Solar Energy & Energy Resources Res Unit, Khamriang 44150, Thailand
1 shared publication- Somporn Hongkong
Solar Energy and Energy Resources Research Unit, Faculty of Engineering, Mahasarakham University, Mahasarakham, Thailand
1 shared publication
Latest Publications
- Open Access
- 1 January 2021
- Published by Tech Science Press in Journal of Renewable Materials
- Vol. 9 (10) , 1685-1697
Fabrication and Simulation of TE Modules for a Feasibility Study on Harvesting Solar Heat Energy from Roof Tiles
A novel roof tile thermoelectric generator (RT-TEG) was used to harvest electrical energy from a solar heat source. The RT-TEG was fabricated and simulated by flat and curved thermoelectric modules consisting of p-n junctions of p-Sb2Te3 and n-Bi2Te3, with an Al2O3 substrate at the top and bottom for heat absorption and heat rejection. The RT-TEG was installed in a roof tile to act as a generator. The electrical voltage and power values of the curved thermoelectric modules were higher than those of the flat thermoelectric module by 0.44 V and 80 mW, at a temperature difference (ΔT) of 100 K. In field tests, the RT-TEG produced a maximum electrical voltage of 33.70 mV and an electrical power of 46.24 μW at ΔT~7 K under a load resistance of 1 Ω under good sunshine at 13.00 hours. The energy conversion efficiency of RT-TEG was found to be 2.24 × 10−4.
- 1 January 2021
- Published by Tech Science Press in Journal of Renewable Materials
- Vol. 9 (10) , 1685-1697
Open AccessFabrication and Simulation of TE Modules for a Feasibility Study on Harvesting Solar Heat Energy from Roof Tiles
A novel roof tile thermoelectric generator (RT-TEG) was used to harvest electrical energy from a solar heat source. The RT-TEG was fabricated and simulated by flat and curved thermoelectric modules consisting of p-n junctions of p-Sb2Te3 and n-Bi2Te3, with an Al2O3 substrate at the top and bottom for heat absorption and heat rejection. The RT-TEG was installed in a roof tile to act as a generator. The electrical voltage and power values of the curved thermoelectric modules were higher than those of the flat thermoelectric module by 0.44 V and 80 mW, at a temperature difference (ΔT) of 100 K. In field tests, the RT-TEG produced a maximum electrical voltage of 33.70 mV and an electrical power of 46.24 μW at ΔT~7 K under a load resistance of 1 Ω under good sunshine at 13.00 hours. The energy conversion efficiency of RT-TEG was found to be 2.24 × 10−4.
- 21 September 2019
- Published by Taylor & Francis in International Journal of Sustainable Energy
- Vol. 39 (2) , 176-189
A technique for evaluation of sky luminance distribution in tropical climate: a case study of Northeastern Thailand
Sky luminance distribution (SLD) is an important index for building design. This article proposes an alternative technique for evaluation of sky luminance in a tropical climate without using a sky scanner. The SLD was calculated from the zenith luminance (Lz) and diffuse luminance (Dv). Four consecutive years record of Lz and Dv were used to generate all sky functions. The obtained sky luminance models were validated with the CIE-standard model. Accuracy indexes in terms of MBE, RMSE and R2 were presented. The obtained results indicated that MBE, RMSE and R2 were in the ranges of −16.02% to 5.92%, 4.56–21.46 and 0.96–0.99, respectively. It was suggested that the model proposed in this study would be an effective alternative method for measuring SLD.
- 21 September 2019
- Published by Taylor & Francis in International Journal of Sustainable Energy
- Vol. 39 (2) , 176-189
A technique for evaluation of sky luminance distribution in tropical climate: a case study of Northeastern Thailand
Sky luminance distribution (SLD) is an important index for building design. This article proposes an alternative technique for evaluation of sky luminance in a tropical climate without using a sky scanner. The SLD was calculated from the zenith luminance (Lz) and diffuse luminance (Dv). Four consecutive years record of Lz and Dv were used to generate all sky functions. The obtained sky luminance models were validated with the CIE-standard model. Accuracy indexes in terms of MBE, RMSE and R2 were presented. The obtained results indicated that MBE, RMSE and R2 were in the ranges of −16.02% to 5.92%, 4.56–21.46 and 0.96–0.99, respectively. It was suggested that the model proposed in this study would be an effective alternative method for measuring SLD.
- 27 May 2015
- Published by Wiley in Journal of Food Process Engineering
- Vol. 39 (3) , 306-318
Application of Combined Far‐Infrared Radiation and Air Convection for Drying of Instant Germinated Brown Rice
Shorter drying time and reduced energy consumption for instant germinated brown rice drying were evaluated to ensure that the quality of the final product was not compromised. Energy consumption, moisture content, color, morphology, rehydration, texture and sensory evaluation were determined during drying with a combination of far‐infrared radiation and hot air. Far‐infrared intensities from 1 to 5 kW/m2 were combined with a 40C temperature and 1 m/s air velocity. Drying rate increased with far‐infrared intensity, hence reducing the total drying time. The mathematical model was validated by comparing the simulated results with temperature and moisture content to described the drying behavior of instant germinated brown rice (R2 = 0.999). The total color difference (ΔE) varied from 2.9 to 4.2. Increasing far‐infrared intensity decreased hardness, chewiness and gumminess, but increased the rehydration of instant germinated brown rice. The effective moisture diffusivity increased with the far‐infrared intensity varying from 0.39 × 10−11 to 3.6 × 10−10 m2/s. The specific energy consumption at 5 kW/m2 far‐infrared intensity was 2.90 kWh/kg of water removed, resulting in a 66% energy saving when compared to 1 kW/m2 far‐infrared intensity.Practical Applications: As an excellent source of nutrients, germinated brown rice has gained more attention than white rice. However, information on instant rice obtained from germinated brown rice is scarce. An alternative technique about instant germinated brown rice preparation was therefore proposed in this work. This study gives a method for the preparation for instant germinated brown rice, which would be a good choice for production of instant germinated brown rice in the industry.
- 27 May 2015
- Published by Wiley in Journal of Food Process Engineering
- Vol. 39 (3) , 306-318
Application of Combined Far‐Infrared Radiation and Air Convection for Drying of Instant Germinated Brown Rice
Shorter drying time and reduced energy consumption for instant germinated brown rice drying were evaluated to ensure that the quality of the final product was not compromised. Energy consumption, moisture content, color, morphology, rehydration, texture and sensory evaluation were determined during drying with a combination of far‐infrared radiation and hot air. Far‐infrared intensities from 1 to 5 kW/m2 were combined with a 40C temperature and 1 m/s air velocity. Drying rate increased with far‐infrared intensity, hence reducing the total drying time. The mathematical model was validated by comparing the simulated results with temperature and moisture content to described the drying behavior of instant germinated brown rice (R2 = 0.999). The total color difference (ΔE) varied from 2.9 to 4.2. Increasing far‐infrared intensity decreased hardness, chewiness and gumminess, but increased the rehydration of instant germinated brown rice. The effective moisture diffusivity increased with the far‐infrared intensity varying from 0.39 × 10−11 to 3.6 × 10−10 m2/s. The specific energy consumption at 5 kW/m2 far‐infrared intensity was 2.90 kWh/kg of water removed, resulting in a 66% energy saving when compared to 1 kW/m2 far‐infrared intensity.Practical Applications: As an excellent source of nutrients, germinated brown rice has gained more attention than white rice. However, information on instant rice obtained from germinated brown rice is scarce. An alternative technique about instant germinated brown rice preparation was therefore proposed in this work. This study gives a method for the preparation for instant germinated brown rice, which would be a good choice for production of instant germinated brown rice in the industry.
- 23 March 2013
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 42 (7) , 2119-2126
Thermal Modeling of a Hybrid Thermoelectric Solar Collector with a Compound Parabolic Concentrator
- 23 March 2013
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 42 (7) , 2119-2126
Thermal Modeling of a Hybrid Thermoelectric Solar Collector with a Compound Parabolic Concentrator