In-Bo Shim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
In-Bo Shim has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
- Chul Sung Kim
Department of Physics, Kookmin University, Seoul, Republic of Korea
13 shared publications - Jeffrey Pyun
Department of Chemistry and Biochemistry, The University of Arizona, 1306 East University Blvd, Tucson, Arizona 85721, United States
4 shared publications Jin Gyo Jung
Department of Physics, Kookmin University, Seoul, Korea
3 shared publicationsBae Soon Son
Kookmin University
2 shared publicationsBo Yun Kim
Department of Chemistry & Biochemistry, University of Arizona, 1306 E. University Blvd., Tucson, AZ, USA
2 shared publicationsChul Sung Kim
Kookmin University
2 shared publications
Latest Publications
- Open Access
A Study on Hollow Mesoporous Silica Nanoparticles with Long-Term Cycling
As electronic technologies continue to advance, the demand for high-performance and safe batteries has steadily increased. However, silicon-based anode materials experience severe volume expansion and poor structural stability during cycling, which limits their practical application. In this study, we synthesized hollow mesoporous silica to develop an anode material with long-term cycling stability. Electrochemical analysis revealed that the material exhibited low-capacity decay, decreasing from 125 mA·h·g−1 to 120 mA·h·g−1 at a C-rate of 20 C, and retained a 49 mA·h·g−1 after 500 charge–discharge cycles at a C-rate of 10 C. Furthermore, electrochemical impedance spectroscopy and Scanning Electron Microscopy analysis confirmed that the hollow mesoporous silica structure is long-term cycling stability in the anode.
Open AccessA Study on Hollow Mesoporous Silica Nanoparticles with Long-Term Cycling
As electronic technologies continue to advance, the demand for high-performance and safe batteries has steadily increased. However, silicon-based anode materials experience severe volume expansion and poor structural stability during cycling, which limits their practical application. In this study, we synthesized hollow mesoporous silica to develop an anode material with long-term cycling stability. Electrochemical analysis revealed that the material exhibited low-capacity decay, decreasing from 125 mA·h·g−1 to 120 mA·h·g−1 at a C-rate of 20 C, and retained a 49 mA·h·g−1 after 500 charge–discharge cycles at a C-rate of 10 C. Furthermore, electrochemical impedance spectroscopy and Scanning Electron Microscopy analysis confirmed that the hollow mesoporous silica structure is long-term cycling stability in the anode.
- 13 December 2021
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 3 (12) , 5641-5650
Domain Dynamics and Local Level Switching Behaviors of Sol–Gel Nanopowder-Derived Lead-Free Piezoelectric Bi0.5(Na0.78K0.22)0.5TiO3 Ceramics
- 13 December 2021
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 3 (12) , 5641-5650
Domain Dynamics and Local Level Switching Behaviors of Sol–Gel Nanopowder-Derived Lead-Free Piezoelectric Bi0.5(Na0.78K0.22)0.5TiO3 Ceramics
- 6 September 2021
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 79 (6) , 562-566
Crystallographic and magnetic properties of α-NaFeO2 using Mössbauer spectroscopy
- 6 September 2021
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 79 (6) , 562-566
Crystallographic and magnetic properties of α-NaFeO2 using Mössbauer spectroscopy
- 25 August 2021
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 79 (6) , 557-561
Mössbauer and magnetic properties of Ba2Co1.7Mg0.3Fe12O22
- 25 August 2021
- Published by Springer Nature in Journal of the Korean Physical Society
- Vol. 79 (6) , 557-561
Mössbauer and magnetic properties of Ba2Co1.7Mg0.3Fe12O22
- 5 June 2021
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 330 (2) , 433-437
Magnetic, Mössbauer and hyperthermia properties of Co1−xMnxFe2O4 nanoparticles
- 5 June 2021
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 330 (2) , 433-437
Magnetic, Mössbauer and hyperthermia properties of Co1−xMnxFe2O4 nanoparticles
- 1 July 2019
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 481, 136-139
Magnetocapacitance of magnetically strained multilayered thin films
- 1 July 2019
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 481, 136-139
Magnetocapacitance of magnetically strained multilayered thin films
- 1 July 2018
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 73 (1) , 86-89
Mossbauer Studies of Z-Type Sr3Co2Fe24O41 Strontium Ferrite
Sr3Co2Fe24O41 plocrystalline sample was synthesized by using a polymerizable complex method. We investigated the crystallographic and the magnetic properties of sample by using X-ray diffractometer, vibrating sample magnetometer, and Mossbauer spectrometer. Based on the Rietveld refinement, the crystal structure of the sample was found to be single-phased and to be hexagonal with space group of P6(3)/mmc. The hysteresis curves of sample were measured under 15 kOe at various temperatures ranging from 4.2 and 295 K. From the temperature dependence of the magnetization curves under 100 Oe at temperatures between 4.2 and 740 K, three temperature-dependent magnetic transitions were found to have occurred in the Sr3Co2Fe24O41 sample. The Mossbauer spectra of the samples were obtained at various temperatures ranging from 4.2 and 295 K.
- 1 July 2018
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 73 (1) , 86-89
Mossbauer Studies of Z-Type Sr3Co2Fe24O41 Strontium Ferrite
Sr3Co2Fe24O41 plocrystalline sample was synthesized by using a polymerizable complex method. We investigated the crystallographic and the magnetic properties of sample by using X-ray diffractometer, vibrating sample magnetometer, and Mossbauer spectrometer. Based on the Rietveld refinement, the crystal structure of the sample was found to be single-phased and to be hexagonal with space group of P6(3)/mmc. The hysteresis curves of sample were measured under 15 kOe at various temperatures ranging from 4.2 and 295 K. From the temperature dependence of the magnetization curves under 100 Oe at temperatures between 4.2 and 740 K, three temperature-dependent magnetic transitions were found to have occurred in the Sr3Co2Fe24O41 sample. The Mossbauer spectra of the samples were obtained at various temperatures ranging from 4.2 and 295 K.
- 19 January 2017
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 70 (1) , 81-84
Mössbauer studies of Ba3Zn2Fe24O41 Z-type hexaferrite
- 19 January 2017
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 70 (1) , 81-84
Mössbauer studies of Ba3Zn2Fe24O41 Z-type hexaferrite
- 1 June 2015
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 66 (12) , 1889-1894
Change of the magnetocapacitance ratio in ferromagnetic materials
The magnetostriction effect, the change in the mechanical properties of a magnetic material in an external magnetic field, has been studied for possible technological applications such as actuators. We present the fabrication of a multilayered magnetocapacitor containing magnetic layers of Ni0.98Co0.02Fe2O4 (NCFO) and compare it with our prior magnetocapacitor in which CoFe2O4 (CFO) and CoNiFe (CNF) were used as the magnetic layers. In particular, we measured the surface/interface microstructures and the change in the lattice constant of the BaTiO3 (BTO) film in NCFO/BTO/NCFO, CFO/BTO/CFO, and CNF/BTO/CNF multilayered thin films. Our study suggests that there is a correlation exists between the magnetocapacitance and the lattice constant of BTO, which varies with the type of ferromagnetic (FM) material embedded in the magnetic layer.
- 1 June 2015
- Published by Korean Physical Society in Journal of the Korean Physical Society
- Vol. 66 (12) , 1889-1894
Change of the magnetocapacitance ratio in ferromagnetic materials
The magnetostriction effect, the change in the mechanical properties of a magnetic material in an external magnetic field, has been studied for possible technological applications such as actuators. We present the fabrication of a multilayered magnetocapacitor containing magnetic layers of Ni0.98Co0.02Fe2O4 (NCFO) and compare it with our prior magnetocapacitor in which CoFe2O4 (CFO) and CoNiFe (CNF) were used as the magnetic layers. In particular, we measured the surface/interface microstructures and the change in the lattice constant of the BaTiO3 (BTO) film in NCFO/BTO/NCFO, CFO/BTO/CFO, and CNF/BTO/CNF multilayered thin films. Our study suggests that there is a correlation exists between the magnetocapacitance and the lattice constant of BTO, which varies with the type of ferromagnetic (FM) material embedded in the magnetic layer.
- Open Access
- 1 January 2014
- Published by Wiley in Journal of Nanomaterials
- Vol. 2014 (1)
Improving the Osteoblast Cell Adhesion on Electron Beam Controlled TiO2 Nanotubes
Here we investigate the osteogenesis and synostosis processes on the surface‐modified TiO2 nanotubes via electron beam irradiation. The TiO2 nanotubes studied were synthesized by anodization process under different anodizing voltage. For the anodization voltage of 15, 20, and 25 V, TiO2 nanotubes with diameters of 59, 82, and 105 nm and length of 115, 276, and 310 nm were obtained, respectively. MC3T3‐E1 osteoblast cell line was incubated on the TiO2 nanotubes to monitor the change in the cell adhesion before and after the electron beam irradiation. We observe that the electron beam irradiation affects the number of surviving osteoblast cells as well as the cultivation time. In particular, the high adhesion rate of 155% was obtained when the osteoblast cells were cultivated for 2 hours on the TiO2 nanotube, anodized under 20 V, and irradiated with 5,000 kGy of electron beam.
- 1 January 2014
- Published by Wiley in Journal of Nanomaterials
- Vol. 2014 (1)
Open AccessImproving the Osteoblast Cell Adhesion on Electron Beam Controlled TiO2 Nanotubes
Here we investigate the osteogenesis and synostosis processes on the surface‐modified TiO2 nanotubes via electron beam irradiation. The TiO2 nanotubes studied were synthesized by anodization process under different anodizing voltage. For the anodization voltage of 15, 20, and 25 V, TiO2 nanotubes with diameters of 59, 82, and 105 nm and length of 115, 276, and 310 nm were obtained, respectively. MC3T3‐E1 osteoblast cell line was incubated on the TiO2 nanotubes to monitor the change in the cell adhesion before and after the electron beam irradiation. We observe that the electron beam irradiation affects the number of surviving osteoblast cells as well as the cultivation time. In particular, the high adhesion rate of 155% was obtained when the osteoblast cells were cultivated for 2 hours on the TiO2 nanotube, anodized under 20 V, and irradiated with 5,000 kGy of electron beam.