Freydoon Vafaie
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Freydoon Vafaie has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Vahid Hadipour
Department of Environmental Engineering, Faculty of Civil Engineering, K.N. Toosi University of Technology, Tehran, Iran
2 shared publications - Hamed Khodadoust
Department of Civil and Environmental Engineering, University of New Hampshire, Durham, NH, 03824, USA
1 shared publication - Hosein Abolghasemi
K.N. Toosi University of Technology
1 shared publication - I. Batmanghelichi
Khajeh Nasir Toosi University of Technology, Department of Civil Engineering, Vali e Asr Ave.-Mirdamad Crossing-Tehran-Iran, Postal Code: 1996715433,
1 shared publication - Kaveh Deilami
Centre for Urban Research, School of Global, Urban and Social Studies, RMIT University, GPO Box 2476, Melbourne, VIC 3001, Australia
1 shared publication - Mohammad Hasan Aliyar Zanjani
Department of Civil and Environmental Engineering, K.N. Toosi University of Technology, Tehran, Iran, Tel. +98 21 88779474 5; Fax: +98 21 88779476
1 shared publication
Latest Publications
- 22 October 2025
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 222 (Pt 3) , 118865
Evaluating shoreline vulnerability to oil spills using multi-criteria approaches: The case of Bushehr Province, Iran
- 22 October 2025
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 222 (Pt 3) , 118865
Evaluating shoreline vulnerability to oil spills using multi-criteria approaches: The case of Bushehr Province, Iran
- 13 May 2025
- Published by Springer Nature in Water Conservation Science and Engineering
- Vol. 10 (2) , 1-16
Comparative Life Cycle Assessment of Two Urban Wastewater Treatment Plants: A Case Study for Iran
- 13 May 2025
- Published by Springer Nature in Water Conservation Science and Engineering
- Vol. 10 (2) , 1-16
Comparative Life Cycle Assessment of Two Urban Wastewater Treatment Plants: A Case Study for Iran
- Open Access
Coastal Flooding Risk Assessment Using a GIS-Based Spatial Multi-Criteria Decision Analysis Approach
Coastal areas are expected to be at a higher risk of flooding when climate change-induced sea-level rise (SLR) is combined with episodic rises in sea level. Flood susceptibility mapping (FSM), mostly based on statistical and machine learning methods, has been widely employed to mitigate flood risk; however, they neglect exposure and vulnerability assessment as the key components of flood risk. Flood risk assessment is often conducted by quantitative methods (e.g., probabilistic). Such assessment uses analytical and empirical techniques to construct the physical vulnerability curves of elements at risk, but the role of people’s capacity, depending on social vulnerability, remains limited. To address this gap, this study developed a semiquantitative method, based on the spatial multi-criteria decision analysis (SMCDA). The model combines two representative concentration pathway (RCP) scenarios: RCP 2.6 and RCP 8.5, and factors triggering coastal flooding in Bandar Abbas, Iran. It also employs an analytical hierarchy process (AHP) model to weight indicators of hazard, exposure, and social vulnerability components. Under the most extreme flooding scenario, 14.8% of flooded areas were identified as high and very high risk, mostly located in eastern, western, and partly in the middle of the City. The results of this study can be employed by decision-makers to apply appropriate risk reduction strategies in high-risk flooding zones.
Open AccessCoastal Flooding Risk Assessment Using a GIS-Based Spatial Multi-Criteria Decision Analysis Approach
Coastal areas are expected to be at a higher risk of flooding when climate change-induced sea-level rise (SLR) is combined with episodic rises in sea level. Flood susceptibility mapping (FSM), mostly based on statistical and machine learning methods, has been widely employed to mitigate flood risk; however, they neglect exposure and vulnerability assessment as the key components of flood risk. Flood risk assessment is often conducted by quantitative methods (e.g., probabilistic). Such assessment uses analytical and empirical techniques to construct the physical vulnerability curves of elements at risk, but the role of people’s capacity, depending on social vulnerability, remains limited. To address this gap, this study developed a semiquantitative method, based on the spatial multi-criteria decision analysis (SMCDA). The model combines two representative concentration pathway (RCP) scenarios: RCP 2.6 and RCP 8.5, and factors triggering coastal flooding in Bandar Abbas, Iran. It also employs an analytical hierarchy process (AHP) model to weight indicators of hazard, exposure, and social vulnerability components. Under the most extreme flooding scenario, 14.8% of flooded areas were identified as high and very high risk, mostly located in eastern, western, and partly in the middle of the City. The results of this study can be employed by decision-makers to apply appropriate risk reduction strategies in high-risk flooding zones.
- Open Access
- 1 May 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (21) , 9679-9689
Investigation of petroleum-contaminated groundwater remediation using multi-stage pilot system: physical and biological approach
In this paper, a pilot-scale system including various process steps was investigated in order to treat contaminated groundwater supplies which have been exposed to oil pollutants for a long time as they are located near the Tehran oil refinery company (TORC). For achieving this goal, a combination of dissolved air flotation unit that is followed by activated sludge bioreactors (ASBRs) and an activated carbon filter was chosen. The crude oil combined with tap water was applied to synthesize contaminated groundwater. Activated sludge taken from wastewater treatment plant at TORC was used to supply oil-degrading bacteria. Besides, the solution of mineral salts was added to the bioreactor as nutrients amendment. The optimum design parameters such as hydraulic retention time, return activated sludge rate of the ASBRs, and total residence time for all steps were 14 h, 100%, and 21 h, respectively. The operation of the pilot system which was implemented in different initial crude oil concentrations (206 ± 1,412 ± 3,1590 ± 10 mg l−1) finally led to total petroleum hydrocarbons removal of 97, 97.25, and 98.57%, respectively. The reduction efficiency of chemical oxygen demand during the experiment was more than 97%. Furthermore, the quality of the treated groundwater was clearly improved, as the turbidity reduction through the experiment exceeded 90%. According to the results of the study, this treatment system can be considered as a reliable and efficient approach that is recommended to be used in case of extremely contaminated groundwater.
- 1 May 2016
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (21) , 9679-9689
Open AccessInvestigation of petroleum-contaminated groundwater remediation using multi-stage pilot system: physical and biological approach
In this paper, a pilot-scale system including various process steps was investigated in order to treat contaminated groundwater supplies which have been exposed to oil pollutants for a long time as they are located near the Tehran oil refinery company (TORC). For achieving this goal, a combination of dissolved air flotation unit that is followed by activated sludge bioreactors (ASBRs) and an activated carbon filter was chosen. The crude oil combined with tap water was applied to synthesize contaminated groundwater. Activated sludge taken from wastewater treatment plant at TORC was used to supply oil-degrading bacteria. Besides, the solution of mineral salts was added to the bioreactor as nutrients amendment. The optimum design parameters such as hydraulic retention time, return activated sludge rate of the ASBRs, and total residence time for all steps were 14 h, 100%, and 21 h, respectively. The operation of the pilot system which was implemented in different initial crude oil concentrations (206 ± 1,412 ± 3,1590 ± 10 mg l−1) finally led to total petroleum hydrocarbons removal of 97, 97.25, and 98.57%, respectively. The reduction efficiency of chemical oxygen demand during the experiment was more than 97%. Furthermore, the quality of the treated groundwater was clearly improved, as the turbidity reduction through the experiment exceeded 90%. According to the results of the study, this treatment system can be considered as a reliable and efficient approach that is recommended to be used in case of extremely contaminated groundwater.
- 7 January 2015
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 73 (12) , 8345-8355
Assessment of sharp-interface approach for saltwater intrusion prediction in an unconfined coastal aquifer exposed to pumping
- 7 January 2015
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 73 (12) , 8345-8355
Assessment of sharp-interface approach for saltwater intrusion prediction in an unconfined coastal aquifer exposed to pumping
- 22 April 2010
- Published by American Society of Civil Engineers (ASCE)
- p. 141-151
Evaluation of Wave Reflection Coefficient from Dynamically Stable Reshaping Berm Breakwaters
In this research the effect of wave and structural characteristics on the irregular wave reflection from the reshaping rubble-mound berm breakwaters is investigated. Method of research was based on physical modeling. Experiments are performed for cross section of berm breakwaters in scales of 1/40 and 1/50 with two different berm widths. The wave flume equipped with a modern DHI spectral wave generation system, which contains paddle, power pack and hardware and software divisions. The hydraulic responses were investigated by changing the wave parameters such as significant wave heights, mean wave periods and storm durations. Data collection and acquisition is performed with both observation and measurement during each experiment and water level fluctuations, measured by four wave height meter sensors with 40 Hz data collection frequency. Collected results are offered in the designing graphs and a new formula for evaluation of reflection coefficient from dynamically stable berm breakwaters, considering effective wave characteristics is presented.
- 22 April 2010
- Published by American Society of Civil Engineers (ASCE)
- p. 141-151
Evaluation of Wave Reflection Coefficient from Dynamically Stable Reshaping Berm Breakwaters
In this research the effect of wave and structural characteristics on the irregular wave reflection from the reshaping rubble-mound berm breakwaters is investigated. Method of research was based on physical modeling. Experiments are performed for cross section of berm breakwaters in scales of 1/40 and 1/50 with two different berm widths. The wave flume equipped with a modern DHI spectral wave generation system, which contains paddle, power pack and hardware and software divisions. The hydraulic responses were investigated by changing the wave parameters such as significant wave heights, mean wave periods and storm durations. Data collection and acquisition is performed with both observation and measurement during each experiment and water level fluctuations, measured by four wave height meter sensors with 40 Hz data collection frequency. Collected results are offered in the designing graphs and a new formula for evaluation of reflection coefficient from dynamically stable berm breakwaters, considering effective wave characteristics is presented.