V. L. Granatstein
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
V. L. Granatstein has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
J. Rodgers
10 shared publicationsY. Carmel
University of Maryland
10 shared publicationsB. Levush
7 shared publicationsW. W. Destler
Institute for Plasma Research, University of Maryland, College Park, Maryland 20742-3511
7 shared publicationsW.W. Destler
7 shared publications- Thomas M. Antonsen
University of Maryland
6 shared publications
Latest Publications
- 24 August 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 162-163
Experimental development of a free-electron laser amplifier at 94 GHz
- 24 August 2005
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 162-163
Experimental development of a free-electron laser amplifier at 94 GHz
- 25 June 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Progress in experimental studies of frequency-doubling gyro-amplifiers
Summary form only given, as follows. We report on the status of two ongoing, frequency-doubling gyro-amplifier experiments: a relativistic, 4 cavity, gyroklystron and a 3 stage, wideband, hybrid gyro-amplifier. Initial operation of the gyroklystron has been achieved using 460 keV, 510 A, 1 microsecond, electron beam pulses. Frequency doubling and amplification of the 8.6 GHz input signal was observed but the parameter range for stable operation was very limited. We are now investigating methods for suppressing the instabilities as a step toward realizing the design values of 57 dB gain and 35% efficiency. This amplifier is being developed to test the accelerating gradient limits in an experimental linac. Lower power but wider bandwidth are of interest for millimeter-wave radar applications. The 3-stage, wideband, hybrid gyro-amplifier with output frequency in Ka band aims to improve on results previously obtained with a 2-stage, frequency-doubling gyro-TWT by adding a 4-unit, TE mode cluster-cavity between the traveling wave input stage and the traveling wave output stage. We expect the addition of the cluster-cavity stage will improve electron phase punching and increase output efficiency without degradation of bandwidth. The three-stage amplifier has been fabricated and is currently undergoing vacuum conditioning. Its successful operation will correspond to the first use of a cluster-cavity in a gyrotron.
- 25 June 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Progress in experimental studies of frequency-doubling gyro-amplifiers
Summary form only given, as follows. We report on the status of two ongoing, frequency-doubling gyro-amplifier experiments: a relativistic, 4 cavity, gyroklystron and a 3 stage, wideband, hybrid gyro-amplifier. Initial operation of the gyroklystron has been achieved using 460 keV, 510 A, 1 microsecond, electron beam pulses. Frequency doubling and amplification of the 8.6 GHz input signal was observed but the parameter range for stable operation was very limited. We are now investigating methods for suppressing the instabilities as a step toward realizing the design values of 57 dB gain and 35% efficiency. This amplifier is being developed to test the accelerating gradient limits in an experimental linac. Lower power but wider bandwidth are of interest for millimeter-wave radar applications. The 3-stage, wideband, hybrid gyro-amplifier with output frequency in Ka band aims to improve on results previously obtained with a 2-stage, frequency-doubling gyro-TWT by adding a 4-unit, TE mode cluster-cavity between the traveling wave input stage and the traveling wave output stage. We expect the addition of the cluster-cavity stage will improve electron phase punching and increase output efficiency without degradation of bandwidth. The three-stage amplifier has been fabricated and is currently undergoing vacuum conditioning. Its successful operation will correspond to the first use of a cluster-cavity in a gyrotron.
- 22 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 229
A long pulse (<1 μsec) field emission electron gun with stable cross section for HPM sources
Summary form only given. Field emission guns, such as those used in many HPM devices, are effected by the plasma formed on both the cathode and anode surfaces by the high voltage pulse. Both the gun impedance and the electron beam cross-section change during the pulse because the plasma rapidly expands (>2 mm//spl mu/sec). This may reduces the beam-wave interaction efficiency since the beam is no longer at the correct position for optimum RF interaction, and may lead to beam interception and early termination of the microwave pulse. Intense, relativistic, long pulse electron guns designed to minimize these effects is therefore a major issue in the development of long pulse HPM sources. We report the results of a foil-less, long pulse (1 /spl mu/sec), relativistic field emission gun with a stable beam cross section. The gun is immersed in a magnetic field of unique geometry. The figure demonstrates the temporal stability of the beam cross section by showing the radial distribution of the electron beam current density J(r) [kA/cm/sup 2/] vs. time [nsec].
- 22 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 229
A long pulse (<1 μsec) field emission electron gun with stable cross section for HPM sources
Summary form only given. Field emission guns, such as those used in many HPM devices, are effected by the plasma formed on both the cathode and anode surfaces by the high voltage pulse. Both the gun impedance and the electron beam cross-section change during the pulse because the plasma rapidly expands (>2 mm//spl mu/sec). This may reduces the beam-wave interaction efficiency since the beam is no longer at the correct position for optimum RF interaction, and may lead to beam interception and early termination of the microwave pulse. Intense, relativistic, long pulse electron guns designed to minimize these effects is therefore a major issue in the development of long pulse HPM sources. We report the results of a foil-less, long pulse (1 /spl mu/sec), relativistic field emission gun with a stable beam cross section. The gun is immersed in a magnetic field of unique geometry. The figure demonstrates the temporal stability of the beam cross section by showing the radial distribution of the electron beam current density J(r) [kA/cm/sup 2/] vs. time [nsec].
- 1 June 1996
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 375 (1) , 160-163
Experimental study of high-power, saturated amplification in a sheet-beam, small-period-wiggler FEL (with applications to magnetic fusion research)
- 1 June 1996
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 375 (1) , 160-163
Experimental study of high-power, saturated amplification in a sheet-beam, small-period-wiggler FEL (with applications to magnetic fusion research)
- 1 June 1996
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 24 (3) , 905-917
Electromagnetic properties of corrugated and smooth waveguides filled with radially inhomogeneous plasma
- 1 June 1996
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 24 (3) , 905-917
Electromagnetic properties of corrugated and smooth waveguides filled with radially inhomogeneous plasma
- 14 March 1994
- Published by AIP Publishing in Applied Physics Letters
- Vol. 64 (11) , 1439-1441
Experimental realization of millimeter-wave amplification by a sheet beam free electron laser
We report an observation of millimeter‐wave (94 GHz) amplification in a sheet beam, short period, planar wiggler, free electron laser amplifier. The observed gain is about 5 dB for a 530 keV, 4 A beam through a 54 cm wiggler. Wave energy absorption was also observed when the beam energy is off‐resonance. Experimental results are in good agreement with numerical simulation. This amplifier configuration has potential for producing equally high output power but at relatively low voltage compared with longer period free electron lasers.
- 14 March 1994
- Published by AIP Publishing in Applied Physics Letters
- Vol. 64 (11) , 1439-1441
Experimental realization of millimeter-wave amplification by a sheet beam free electron laser
We report an observation of millimeter‐wave (94 GHz) amplification in a sheet beam, short period, planar wiggler, free electron laser amplifier. The observed gain is about 5 dB for a 530 keV, 4 A beam through a 54 cm wiggler. Wave energy absorption was also observed when the beam energy is off‐resonance. Experimental results are in good agreement with numerical simulation. This amplifier configuration has potential for producing equally high output power but at relatively low voltage compared with longer period free electron lasers.
- 1 July 1992
- Published by AIP Publishing in Physics of Fluids B: Plasma Physics
- Vol. 4 (7) , 2286-2292
Relativistic plasma microwave electronics: Studies of high-power plasma-filled backward-wave oscillators
The area of relativistic plasma microwave electronics has only recently generated renewed interest. New experimental data are presented demonstrating that the presence of a low‐density background plasma in a relativistic backward‐wave oscillator leads to several beneficial effects, including (a) enhanced interaction efficiency (40%), (b) operation at very low and possibly zero guiding magnetic field, (c) tunability by controlling the plasma density, (d) high degree of spectral coherency, and (e) operation well above the vacuum limiting current.
- 1 July 1992
- Published by AIP Publishing in Physics of Fluids B: Plasma Physics
- Vol. 4 (7) , 2286-2292
Relativistic plasma microwave electronics: Studies of high-power plasma-filled backward-wave oscillators
The area of relativistic plasma microwave electronics has only recently generated renewed interest. New experimental data are presented demonstrating that the presence of a low‐density background plasma in a relativistic backward‐wave oscillator leads to several beneficial effects, including (a) enhanced interaction efficiency (40%), (b) operation at very low and possibly zero guiding magnetic field, (c) tunability by controlling the plasma density, (d) high degree of spectral coherency, and (e) operation well above the vacuum limiting current.