Gregor Kirbiš
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Gregor Kirbiš has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Iztok Kramberger
University of Maribor, Maribor, Slovenia
3 shared publications - David Selcan
Faculty of Electrical Engineering and Computer Science, University of Maribor, Maribor, Slovenia
2 shared publications Bojan Kotnik
SkyLabs d.o.o, Maribor, Slovenia
1 shared publicationDavid Selčan
SkyLabs d.o.o. (Slovenia)
1 shared publicationIztok Kramberger
Univ. of Maribor (Slovenia)
1 shared publication- Lorenzo Gonzales
Faculty of Electrical Engineering and Computer Science, University of Maribor, Maribor, Slovenia
1 shared publication
Latest Publications
- Open Access
- 8 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 72 (12) , 6516-6525
TID Characterization of COTS HEMT GaN Transistors: An In Situ Study of Static and Dynamic Parameters up to 100 krad of Co-60 Gamma Radiation
Gallium nitride (GaN) technology has emerged as a transformative solution in the semiconductor industry due to its exceptional performance in high-power and high-frequency applications. With its inherent radiation resilience, GaN is particularly suited for environments such as space electronics and nuclear instrumentation. While static parameter testing under radiation has been extensively studied, dynamic parameter degradation—including propagation delays, rise/fall times, and efficiency losses—remains underexplored. These dynamic characteristics are useful for applications requiring precise timing, signal integrity, and rapid response, such as satellite communication and nuclear systems. This study evaluates the radiation resilience of three commercially available GaN transistors during a 100-krad (Si) Co-60 gamma irradiation campaign, with a focus on both static and dynamic parameters. Static parameters, such as threshold voltage and on-state resistance, exhibited minimal degradation, while a larger change was observed in gate current. In contrast, dynamic parameters revealed smaller changes, including faster propagation delays and reduced efficiency, with variability observed across device types. The findings support a device-specific co-design of transistors and driver electronics for radiation-tolerant power stages.
- 8 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 72 (12) , 6516-6525
Open AccessTID Characterization of COTS HEMT GaN Transistors: An In Situ Study of Static and Dynamic Parameters up to 100 krad of Co-60 Gamma Radiation
Gallium nitride (GaN) technology has emerged as a transformative solution in the semiconductor industry due to its exceptional performance in high-power and high-frequency applications. With its inherent radiation resilience, GaN is particularly suited for environments such as space electronics and nuclear instrumentation. While static parameter testing under radiation has been extensively studied, dynamic parameter degradation—including propagation delays, rise/fall times, and efficiency losses—remains underexplored. These dynamic characteristics are useful for applications requiring precise timing, signal integrity, and rapid response, such as satellite communication and nuclear systems. This study evaluates the radiation resilience of three commercially available GaN transistors during a 100-krad (Si) Co-60 gamma irradiation campaign, with a focus on both static and dynamic parameters. Static parameters, such as threshold voltage and on-state resistance, exhibited minimal degradation, while a larger change was observed in gate current. In contrast, dynamic parameters revealed smaller changes, including faster propagation delays and reduced efficiency, with variability observed across device types. The findings support a device-specific co-design of transistors and driver electronics for radiation-tolerant power stages.
- Open Access
- 21 March 2025
- Published by SPIE-Intl Soc Optical Eng
- Vol. 13546, 126-1499
Reconfigurable high-performance CCSDS compliant X-band communication module for nanosatellites
This paper presents a novel design and implementation of a CCSDS-compliant communication module (X-COMM) in the X-band frequency range. It consists of an agile transceiver with an upconverter supported by a low-noise low-power local oscillator circuit to extend the operation to X-band frequency. In addition, a single board solution provides an output power of 5 W, with the power added efficiency of the power stage greater than 50%. By implementing an adjustable power supply to power the power amplifier stage, the output power can be decreased to 2 W without compromising efficiency. The highly efficient single-board implementation supports several modules' redundant/parallel operation simultaneously. Further, the module communicates with other systems via standard CAN, LVDS, and two Ethernet interfaces. The CAN interface collects telemetry data and system setup, while the LVDS and two Ethernet interfaces are used for high-speed data transfers. In addition, the X-COMM includes a dedicated virtual channel for transferring universal lossless compressed data instead of direct data transfer with a typical compression rate of 41%. The detailed system design is presented and focuses on the low-noise local oscillator and the power amplifier stage is more thorough.
- 21 March 2025
- Published by SPIE-Intl Soc Optical Eng
- Vol. 13546, 126-1499
Open AccessReconfigurable high-performance CCSDS compliant X-band communication module for nanosatellites
This paper presents a novel design and implementation of a CCSDS-compliant communication module (X-COMM) in the X-band frequency range. It consists of an agile transceiver with an upconverter supported by a low-noise low-power local oscillator circuit to extend the operation to X-band frequency. In addition, a single board solution provides an output power of 5 W, with the power added efficiency of the power stage greater than 50%. By implementing an adjustable power supply to power the power amplifier stage, the output power can be decreased to 2 W without compromising efficiency. The highly efficient single-board implementation supports several modules' redundant/parallel operation simultaneously. Further, the module communicates with other systems via standard CAN, LVDS, and two Ethernet interfaces. The CAN interface collects telemetry data and system setup, while the LVDS and two Ethernet interfaces are used for high-speed data transfers. In addition, the X-COMM includes a dedicated virtual channel for transferring universal lossless compressed data instead of direct data transfer with a typical compression rate of 41%. The detailed system design is presented and focuses on the low-noise local oscillator and the power amplifier stage is more thorough.
- 19 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 55 (1) , 95-107
High Performance Autonomous Charge Equalization in Series Connected Batteries
In this paper, a novel balancing circuit is proposed, which is well suited to aerospace electronics, as it allows for the use of off-the-shelf radiation tolerant components. The new design was examined analytically with and without a zero- voltage switching topology. Its performance was compared to other popular battery balancing circuits. Further, an equation was derived which can be used to estimate the time to balance. The proposed balancer circuit was evaluated using forward and several flyback transformer types, and with the use of static and dynamic testing, the design was also evaluated under fault conditions as it provides a short circuit protection. It was determined experimentally that the proposed design achieves an efficiency of up to 84%.
- 19 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 55 (1) , 95-107
High Performance Autonomous Charge Equalization in Series Connected Batteries
In this paper, a novel balancing circuit is proposed, which is well suited to aerospace electronics, as it allows for the use of off-the-shelf radiation tolerant components. The new design was examined analytically with and without a zero- voltage switching topology. Its performance was compared to other popular battery balancing circuits. Further, an equation was derived which can be used to estimate the time to balance. The proposed balancer circuit was evaluated using forward and several flyback transformer types, and with the use of static and dynamic testing, the design was also evaluated under fault conditions as it provides a short circuit protection. It was determined experimentally that the proposed design achieves an efficiency of up to 84%.
- 1 January 2015
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 48 (10) , 252-257
Software Reliability Validation and Verification Using Fault Injection Techniques on a Fault Tolerant Processor
- 1 January 2015
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 48 (10) , 252-257
Software Reliability Validation and Verification Using Fault Injection Techniques on a Fault Tolerant Processor