Ruijun Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ruijun Wang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Gunther Roelkens
Photonics Research Group, Ghent University-imec, Technologiepark-Zwijnaarde 15 iGent, 9052 Ghent, Belgium
5 shared publicationsGerhard Boehm
Technische Universität München 3 Walter Schottky Institut Am Coulombwall 4, 85748 Garching, Germany
4 shared publicationsMarkus-Christian Amann
Technische Universität München 3 Walter Schottky Institut Am Coulombwall 4, 85748 Garching, Germany
4 shared publicationsRoel Baets
Ghent University-imec 1 Photonics Research Group Technologiepark-Zwijnaarde 15, B-9052 Ghent, Belgium
4 shared publicationsStephan Sprengel
Technische Universität München 3 Walter Schottky Institut Am Coulombwall 4, 85748 Garching, Germany
4 shared publicationsAditya Malik
Photonics Research Group, Ghent University-imec, Technologiepark-Zwijnaarde 15 iGent, 9052 Ghent, Belgium
3 shared publications
Latest Publications
- Open Access
- 7 December 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (25) , 28977-28986
Compact GaSb/silicon-on-insulator 20x μm widely tunable external cavity lasers
2.0x µm widely tunable external cavity lasers realized by combining a GaSb gain chip with a silicon photonics waveguide circuit for wavelength selection are demonstrated. Wavelength tuning over 58 nm from 2.01 to 2.07 µm is demonstrated. In the silicon photonic integrated circuit, laser feedback is realized by using a silicon Bragg grating and continuous tuning is realized by using two thermally tuned silicon microring resonators (MRRs) and a phase section. The uncooled laser has maximum output power of 7.5 mW and threshold current density of 0.8 kA/cm2. The effect of the coupling gap of the MRRs on tunable laser performance is experimentally assessed. A side mode suppression ratio better than 52 dB over the full tuning range and in the optimum operation point of more than 60 dB is achieved for the laser with weakly coupled MRRs.
- 7 December 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (25) , 28977-28986
Open AccessCompact GaSb/silicon-on-insulator 20x μm widely tunable external cavity lasers
2.0x µm widely tunable external cavity lasers realized by combining a GaSb gain chip with a silicon photonics waveguide circuit for wavelength selection are demonstrated. Wavelength tuning over 58 nm from 2.01 to 2.07 µm is demonstrated. In the silicon photonic integrated circuit, laser feedback is realized by using a silicon Bragg grating and continuous tuning is realized by using two thermally tuned silicon microring resonators (MRRs) and a phase section. The uncooled laser has maximum output power of 7.5 mW and threshold current density of 0.8 kA/cm2. The effect of the coupling gap of the MRRs on tunable laser performance is experimentally assessed. A side mode suppression ratio better than 52 dB over the full tuning range and in the optimum operation point of more than 60 dB is achieved for the laser with weakly coupled MRRs.
- 28 November 2016
- Published by AIP Publishing in Applied Physics Letters
- Vol. 109 (22) , 221111
Heterogeneously integrated III–V-on-silicon 2.3x μm distributed feedback lasers based on a type-II active region
We report on 2.3x μm wavelength InP-based type-II distributed feedback (DFB) lasers heterogeneously integrated on a silicon photonics integrated circuit. In the devices, a III–V epitaxial layer stack with a “W”-shaped InGaAs/GaAsSb multi-quantum-well active region is adhesively bonded to the first-order silicon DFB gratings. Single mode laser emission coupled to a single mode silicon waveguide with a side mode suppression ratio of 40 dB is obtained. In continuous-wave regime, the 2.32 μm laser operates close to room temperature (above 15 °C) and emits more than 1 mW output power with a threshold current density of 1.8 kA/cm2 at 5 °C. A tunable diode laser absorption measurement of CO is demonstrated using this source.
- 28 November 2016
- Published by AIP Publishing in Applied Physics Letters
- Vol. 109 (22) , 221111
Heterogeneously integrated III–V-on-silicon 2.3x μm distributed feedback lasers based on a type-II active region
We report on 2.3x μm wavelength InP-based type-II distributed feedback (DFB) lasers heterogeneously integrated on a silicon photonics integrated circuit. In the devices, a III–V epitaxial layer stack with a “W”-shaped InGaAs/GaAsSb multi-quantum-well active region is adhesively bonded to the first-order silicon DFB gratings. Single mode laser emission coupled to a single mode silicon waveguide with a side mode suppression ratio of 40 dB is obtained. In continuous-wave regime, the 2.32 μm laser operates close to room temperature (above 15 °C) and emits more than 1 mW output power with a threshold current density of 1.8 kA/cm2 at 5 °C. A tunable diode laser absorption measurement of CO is demonstrated using this source.
- Open Access
- 1 September 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (18) , 21081-21089
23 µm range InP-based type-II quantum well Fabry-Perot lasers heterogeneously integrated on a silicon photonic integrated circuit
Heterogeneously integrated InP-based type-II quantum well Fabry-Perot lasers on a silicon waveguide circuit emitting in the 2.3 µm wavelength range are demonstrated. The devices consist of a “W”-shaped InGaAs/GaAsSb multi-quantum-well gain section, III-V/silicon spot size converters and two silicon Bragg grating reflectors to form the laser cavity. In continuous-wave (CW) operation, we obtain a threshold current density of 2.7 kA/cm2 and output power of 1.3 mW at 5 °C for 2.35 μm lasers. The lasers emit over 3.7 mW of peak power with a threshold current density of 1.6 kA/cm2 in pulsed regime at room temperature. This demonstration of heterogeneously integrated lasers indicates that the material system and heterogeneous integration method are promising to realize fully integrated III-V/silicon photonics spectroscopic sensors in the 2 µm wavelength range.
- 1 September 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (18) , 21081-21089
Open Access23 µm range InP-based type-II quantum well Fabry-Perot lasers heterogeneously integrated on a silicon photonic integrated circuit
Heterogeneously integrated InP-based type-II quantum well Fabry-Perot lasers on a silicon waveguide circuit emitting in the 2.3 µm wavelength range are demonstrated. The devices consist of a “W”-shaped InGaAs/GaAsSb multi-quantum-well gain section, III-V/silicon spot size converters and two silicon Bragg grating reflectors to form the laser cavity. In continuous-wave (CW) operation, we obtain a threshold current density of 2.7 kA/cm2 and output power of 1.3 mW at 5 °C for 2.35 μm lasers. The lasers emit over 3.7 mW of peak power with a threshold current density of 1.6 kA/cm2 in pulsed regime at room temperature. This demonstration of heterogeneously integrated lasers indicates that the material system and heterogeneous integration method are promising to realize fully integrated III-V/silicon photonics spectroscopic sensors in the 2 µm wavelength range.
- Open Access
- 11 April 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (8) , 8480-8490
III-V-on-silicon 2-µm-wavelength-range wavelength demultiplexers with heterogeneously integrated InP-based type-II photodetectors
2-µm-wavelength-range silicon-on-insulator (SOI) arrayed waveguide gratings (AWGs) with heterogeneously integrated InP-based type-II quantum well photodetectors are presented. Low insertion loss (2.5-3 dB) and low crosstalk (−30 to −25 dB) AWGs are realized. The InP-based type-II photodetectors are integrated with the AWGs using two different coupling approaches. Adiabatic-taper-based photodetectors show a responsivity of 1.6 A/W at 2.35 µm wavelength and dark current of 10 nA at −0.5 V, while photodetectors using grating-assisted coupling have a responsivity of 0.1 A/W and dark current of 5 nA at −0.5 V. The integration of the photodetector array does not degrade the insertion loss and crosstalk of the device. The photodetector epitaxial stack can also be used to realize the integration of a broadband light source, thereby enabling fully integrated spectroscopic systems.
- 11 April 2016
- Published by Optica Publishing Group in Optics Express
- Vol. 24 (8) , 8480-8490
Open AccessIII-V-on-silicon 2-µm-wavelength-range wavelength demultiplexers with heterogeneously integrated InP-based type-II photodetectors
2-µm-wavelength-range silicon-on-insulator (SOI) arrayed waveguide gratings (AWGs) with heterogeneously integrated InP-based type-II quantum well photodetectors are presented. Low insertion loss (2.5-3 dB) and low crosstalk (−30 to −25 dB) AWGs are realized. The InP-based type-II photodetectors are integrated with the AWGs using two different coupling approaches. Adiabatic-taper-based photodetectors show a responsivity of 1.6 A/W at 2.35 µm wavelength and dark current of 10 nA at −0.5 V, while photodetectors using grating-assisted coupling have a responsivity of 0.1 A/W and dark current of 5 nA at −0.5 V. The integration of the photodetector array does not degrade the insertion loss and crosstalk of the device. The photodetector epitaxial stack can also be used to realize the integration of a broadband light source, thereby enabling fully integrated spectroscopic systems.
- Open Access
- 2 October 2015
- Published by Optica Publishing Group in Optics Express
- Vol. 23 (20) , 26834-26841
2 μm wavelength range InP-based type-II quantum well photodiodes heterogeneously integrated on silicon photonic integrated circuits
The heterogeneous integration of InP-based type-II quantum well photodiodes on silicon photonic integrated circuits for the 2 µm wavelength range is presented. A responsivity of 1.2 A/W at a wavelength of 2.32 µm and 0.6 A/W at 2.4 µm wavelength is demonstrated. The photodiodes have a dark current of 12 nA at −0.5 V at room temperature. The absorbing active region of the integrated photodiodes consists of six periods of a “W”-shaped quantum well, also allowing for laser integration on the same platform.
- 2 October 2015
- Published by Optica Publishing Group in Optics Express
- Vol. 23 (20) , 26834-26841
Open Access2 μm wavelength range InP-based type-II quantum well photodiodes heterogeneously integrated on silicon photonic integrated circuits
The heterogeneous integration of InP-based type-II quantum well photodiodes on silicon photonic integrated circuits for the 2 µm wavelength range is presented. A responsivity of 1.2 A/W at a wavelength of 2.32 µm and 0.6 A/W at 2.4 µm wavelength is demonstrated. The photodiodes have a dark current of 12 nA at −0.5 V at room temperature. The absorbing active region of the integrated photodiodes consists of six periods of a “W”-shaped quantum well, also allowing for laser integration on the same platform.