MTMingsi Tong

Mingsi Tong

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mingsi Tong has a total of 8 co-authors. Here are the top co-authors by number of shared publications:

  • Daniel Ott

    CREOL, The College of Optics and Photonics, Univ. of Central Florida (United States)

    1 shared publication
  • Hao Zhang

    Semiconductor and Dimensional Metrology Division, National Institute of Standards and Technology, Gaithersburg, MD 20899, USA

    1 shared publication
  • John Song

    Semiconductor and Dimensional Metrology Division, National Institute of Standards and Technology, Gaithersburg, MD 20899, USA

    1 shared publication
  • John Song

    Physical Measurement Laboratory, National Institute of Standards and Technology (NIST), Gaithersburg, MD 20899, USA

    1 shared publication
  • Wei Chu

    Semiconductor and Dimensional Metrology Division, National Institute of Standards and Technology, Gaithersburg, MD 20899, USA

    1 shared publication
  • Wei Chu

    National Institute of Standards and Technology, Gaithersburg, MD 20899 USA

    1 shared publication

Latest Publications

  • A Normalized Congruent Matching Area Method for the Correlation of Breech Face Impression Images

    by Zhe Chen, John Song, Wei Chu, Mingsi Tong, XueZeng Zhao

    The congruent matching cells (CMC) method was invented at the National Institute of Standards and Technology (NIST) for firearm evidence identification and error rate estimation. The CMC method divides the correlated image pairs into cells and uses four parameters to quantify topography similarity and pattern congruency of the correlated cell pairs in firearm breech face impressions on fired cartridge cases. A preliminary conservative numerical identification criterion of C = 6 CMCs was suggested for identifying images of cartridge cases fired from the same firearm. The CMC method was validated by correlations using both three-dimensional (3D) topography images and two-dimensional (2D) optical images from a set of 40 cartridge cases fired from a firearm set composed of 10 consecutively manufactured pistol slides. However, in the original CMC method, due to the difference in the effective data area of the correlated cells, final CMCs obtained from an image pair presented different data quantity (or validity level), and thus the empirical criterion C = 6 CMCs did not remain optimal for identification when the correlated cell size changed. In this study, a normalized congruent matching area (NCMA) method that considers the difference in the data area in each correlated cell pair was developed. Based on the NCMA method, an optimal range of cell sizes for breech face identification with granular characteristics was determined. A binomial model was used to fit the known nonmatching NCMA probability distribution ΨNCMA, and a beta-binomial model was used to fit the known matching NCMA probability distribution ΦNCMA. An experimental improvement in the normalized identification criterion C of around 6 % was observed in the validation tests when the cell sizes were in the optimal range.


  • Open Access

    Applications of the spline filter for areal filtration

    by Mingsi Tong, Hao Zhang, Daniel Ott, Wei Chu, John Song

    This paper proposes a general use isotropic areal spline filter. This new areal spline filter can achieve isotropy by approximating the transmission characteristic of the Gaussian filter. It can also eliminate the effect of void areas using a weighting factor, and resolve end-effect issues by applying new boundary conditions, which replace the first order finite difference in the traditional spline formulation. These improvements make the spline filter widely applicable to 3D surfaces and extend the applications of the spline filter in areal filtration.