Blaise Souffaché
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Blaise Souffaché has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Alain Tabbagh
Sorbonne Université, CNRS, EPHE, UMR 7619 METIS Paris France
2 shared publications A. Tabbagh
Université Pierre et Marie Curie, UMR Sisyphe 4 place Jussieu Paris 75252 cedex 05 France
1 shared publication- Aida Mendieta
Sorbonne Universite
1 shared publication - Alexis Maineult
Laboratoire de Géologie, Ecole Normale Supérieure / CNRS UMR 8538, PSL Research University , F-75005 Paris
1 shared publication C. Camerlynck
Sorbonne Université, CNRS, EPHE, UMR 7619 METIS Paris France
1 shared publication- Cyril Schamper
Sorbonne Université, CNRS, EPHE, UMR 7619 METIS Paris France
1 shared publication
Latest Publications
- Open Access
- 27 May 2024
- Published by Wiley in Near Surface Geophysics
- Vol. 22 (4) , 468-481
Experimental and numerical analysis of dielectric polarization effects in near‐surface earth materials in the 100 Hz–10 MHz frequency range: First interpretation paths
- 27 May 2024
- Published by Wiley in Near Surface Geophysics
- Vol. 22 (4) , 468-481
Open AccessExperimental and numerical analysis of dielectric polarization effects in near‐surface earth materials in the 100 Hz–10 MHz frequency range: First interpretation paths
- 5 June 2021
- Published by Wiley in Near Surface Geophysics
- Vol. 19 (5) , 573-582
Laboratory study of the electrical properties of Lutetian limestones in the 100 Hz to 10 MHz frequency range
Lutetian limestones have been widely used in historical monuments within the Paris Basin during the course of the medieval and modern periods. Among the physical properties that can be used to assess the evolution of the limestonesin situin the buildings and their present health, the complex effective permittivity in the 10–100 kHz frequency range is easy to measure and reflects the internal structure of the stone along with the dependence on the water content. To improve our knowledge about this property, a laboratory study on four samples collected in the relevant quarries has been undertaken using measurements in the 100 Hz–10 MHz frequency range. Except close to zero water content, the observed results exhibit a quasi‐absence of variation of the real effective permittivity with the water content. The frequency variation fits fairly well with a model taking into account a Jonscher's decrease, a direct current conductivity, a high‐frequency dielectric permittivity and losses, and a relaxation phenomenon. When fitted by a Cole–Cole model, the magnitude of the corresponding relative permittivity change always stays close to 30, but the time constant varies from 1.0 μs to 0.1 μs as the water content increases.
- 5 June 2021
- Published by Wiley in Near Surface Geophysics
- Vol. 19 (5) , 573-582
Laboratory study of the electrical properties of Lutetian limestones in the 100 Hz to 10 MHz frequency range
Lutetian limestones have been widely used in historical monuments within the Paris Basin during the course of the medieval and modern periods. Among the physical properties that can be used to assess the evolution of the limestonesin situin the buildings and their present health, the complex effective permittivity in the 10–100 kHz frequency range is easy to measure and reflects the internal structure of the stone along with the dependence on the water content. To improve our knowledge about this property, a laboratory study on four samples collected in the relevant quarries has been undertaken using measurements in the 100 Hz–10 MHz frequency range. Except close to zero water content, the observed results exhibit a quasi‐absence of variation of the real effective permittivity with the water content. The frequency variation fits fairly well with a model taking into account a Jonscher's decrease, a direct current conductivity, a high‐frequency dielectric permittivity and losses, and a relaxation phenomenon. When fitted by a Cole–Cole model, the magnitude of the corresponding relative permittivity change always stays close to 30, but the time constant varies from 1.0 μs to 0.1 μs as the water content increases.
- 2 November 2015
- Published by Wiley in Archaeometry
- Vol. 58 (5) , 705-721
First Investigations of In Situ Electrical Properties of Limestone Blocks of Ancient Monuments
In situ rapid electrostatic investigations on calcareous stones of monuments provide information that strongly correlates with the geological characteristics of the stone and proves to be efficient for provenance identification and successive restoration. With a portable device, it is now possible to scan several thousand blocks on a face of a monument in a few hours. The evolution of the religious building construction practices between the 13th and the 17th centuries is studied. From the petrophysics point of view, the results clearly indicate a marked linear correlation between electrical conductivity and dielectric permittivity. This fact, which agrees with Maxwell–Wagner polarization modelling, confirms the part played by the clay content in the electric properties of the dry carbonate rocks constituting the monument stones. A first test using X‐ray scattering analysis shows the part played by the relative content of illite, which is correlated with a decrease of the resistivity.
- 2 November 2015
- Published by Wiley in Archaeometry
- Vol. 58 (5) , 705-721
First Investigations of In Situ Electrical Properties of Limestone Blocks of Ancient Monuments
In situ rapid electrostatic investigations on calcareous stones of monuments provide information that strongly correlates with the geological characteristics of the stone and proves to be efficient for provenance identification and successive restoration. With a portable device, it is now possible to scan several thousand blocks on a face of a monument in a few hours. The evolution of the religious building construction practices between the 13th and the 17th centuries is studied. From the petrophysics point of view, the results clearly indicate a marked linear correlation between electrical conductivity and dielectric permittivity. This fact, which agrees with Maxwell–Wagner polarization modelling, confirms the part played by the clay content in the electric properties of the dry carbonate rocks constituting the monument stones. A first test using X‐ray scattering analysis shows the part played by the relative content of illite, which is correlated with a decrease of the resistivity.