Carl C. Koch
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Carl C. Koch has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Alexander J. Zaddach
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907, USA
1 shared publicationChangning Niu
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907, USA
1 shared publicationDouglas L. Irving
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695-7907, USA
1 shared publication- Khaled M. Youssef
Materials Science and Technology Graduate Program, Department of Physics and Materials Science, Qatar University, Doha 2713, Qatar
1 shared publication
Latest Publications
- Top Cited PapersOpen Access
- 9 December 2014
- Published by Taylor & Francis in Materials Research Letters
- Vol. 3 (2) , 95-99
A Novel Low-Density, High-Hardness, High-entropy Alloy with Close-packed Single-phase Nanocrystalline Structures
A low-density, nanocrystalline high-entropy alloy, Al20Li20Mg10Sc20Ti30 was produced by mechanical alloying. It formed a single-phase fcc structure during ball milling and transformed to single-phase hcp upon annealing. The alloy has an estimated strength-to-weight ratio that is significantly higher than other nanocrystalline alloys and is comparable to ceramics. High hardness is retained after annealing.
- 9 December 2014
- Published by Taylor & Francis in Materials Research Letters
- Vol. 3 (2) , 95-99
Top Cited PapersOpen AccessA Novel Low-Density, High-Hardness, High-entropy Alloy with Close-packed Single-phase Nanocrystalline Structures
A low-density, nanocrystalline high-entropy alloy, Al20Li20Mg10Sc20Ti30 was produced by mechanical alloying. It formed a single-phase fcc structure during ball milling and transformed to single-phase hcp upon annealing. The alloy has an estimated strength-to-weight ratio that is significantly higher than other nanocrystalline alloys and is comparable to ceramics. High hardness is retained after annealing.