Stuart Kleinfelder
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Stuart Kleinfelder has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Allan Hallgren
Uppsala University Department of Physics and Astronomy, Regementsv?gen 1, SE-752 37 Uppsala, Sweden
1 shared publication - Andras Laszlo
HUN-REN Wigner Research Centre for Physics
1 shared publication - Anna Nelles
Deutsches Elektronen-Synchrotron DESY Platanenallee 6 15738 Zeuthen Germany
1 shared publication C. Persichilli
Dept. of Physics & Astronomy, University of California, 4129 Frederick Reines Hall, Irvine, CA 92697, U.S.A.
1 shared publication- Christian Glaser
Uppsala University
1 shared publication - Csaba Soos
CERN, 1211 Geneva 23, Switzerland
1 shared publication
Latest Publications
- 1 July 2018
- Published by IOP Publishing in Journal of Cosmology and Astroparticle Physics
- Vol. 2018 (07) , 055
Observation of classically `forbidden' electromagnetic wave propagation and implications for neutrino detection.
- 1 July 2018
- Published by IOP Publishing in Journal of Cosmology and Astroparticle Physics
- Vol. 2018 (07) , 055
Observation of classically `forbidden' electromagnetic wave propagation and implications for neutrino detection.
- Open Access
Design and Performance of the Data Acquisition System for the NA61/SHINE Experiment at CERN
This paper describes the hardware, firmware and software systems used in data acquisition for the NA61/SHINE experiment at the CERN SPS accelerator. Special emphasis is given to the design parameters of the readout electronics for the 40m^3 volume Time Projection Chamber detectors, as these give the largest contribution to event data among all the subdetectors: events consisting of 8bit ADC values from 256 timeslices of 200k electronic channels are to be read out with ~100Hz rate. The data acquisition system is organized in "push-data mode", i.e. local systems transmit data asynchronously. Techniques of solving subevent synchronization are also discussed.
Open AccessDesign and Performance of the Data Acquisition System for the NA61/SHINE Experiment at CERN
This paper describes the hardware, firmware and software systems used in data acquisition for the NA61/SHINE experiment at the CERN SPS accelerator. Special emphasis is given to the design parameters of the readout electronics for the 40m^3 volume Time Projection Chamber detectors, as these give the largest contribution to event data among all the subdetectors: events consisting of 8bit ADC values from 256 timeslices of 200k electronic channels are to be read out with ~100Hz rate. The data acquisition system is organized in "push-data mode", i.e. local systems transmit data asynchronously. Techniques of solving subevent synchronization are also discussed.
- Open Access
The SST Fully-Synchronous Multi-GHz Analog Waveform Recorder with Nyquist-Rate Bandwidth and Flexible Trigger Capabilities
The design and performance of a fully-synchronous multi-GHz analog transient waveform recorder I.C. ("SST") with fast and flexible trigger capabilities is presented. The SST's objective is to provide multi-GHz sample rates with intrinsically-stable timing, Nyquist-rate sampling and high trigger bandwidth, wide dynamic range and simple operation. Containing 4 channels of 256 samples per channel, the SST is fabricated in an inexpensive 0.25 micrometer CMOS process and uses a high-performance package that is 8 mm on a side. It has a 1.9V input range on a 2.5V supply, exceeds 12 bits of dynamic range, and uses ~128 mW while operating at 2 G-samples/s and full trigger rates. With a standard 50 Ohm input source, the SST exceeds ~1.5 GHz -3 dB bandwidth. The SST's internal sample clocks are generated synchronously via a shift register driven by an external LVDS oscillator running at half the sample rate (e.g., a 1 GHz oscillator yields 2 G-samples/s). Because of its purely-digital synchronous nature, the SST has ps-level timing uniformity that is independent of sample frequencies spanning over 6 orders of magnitude: from under 2 kHz to over 2 GHz. Only three active control lines are necessary for operation: Reset, Start/Stop and Read-Clock. When operating as common-stop device, the time of the stop, modulo 256 relative to the start, is read out along with the sampled signal values. Each of the four channels integrates dual-threshold trigger circuitry with windowed coincidence features. Channels can discriminate signals with ~1mV RMS resolution at >600 MHz bandwidth.
Open AccessThe SST Fully-Synchronous Multi-GHz Analog Waveform Recorder with Nyquist-Rate Bandwidth and Flexible Trigger Capabilities
The design and performance of a fully-synchronous multi-GHz analog transient waveform recorder I.C. ("SST") with fast and flexible trigger capabilities is presented. The SST's objective is to provide multi-GHz sample rates with intrinsically-stable timing, Nyquist-rate sampling and high trigger bandwidth, wide dynamic range and simple operation. Containing 4 channels of 256 samples per channel, the SST is fabricated in an inexpensive 0.25 micrometer CMOS process and uses a high-performance package that is 8 mm on a side. It has a 1.9V input range on a 2.5V supply, exceeds 12 bits of dynamic range, and uses ~128 mW while operating at 2 G-samples/s and full trigger rates. With a standard 50 Ohm input source, the SST exceeds ~1.5 GHz -3 dB bandwidth. The SST's internal sample clocks are generated synchronously via a shift register driven by an external LVDS oscillator running at half the sample rate (e.g., a 1 GHz oscillator yields 2 G-samples/s). Because of its purely-digital synchronous nature, the SST has ps-level timing uniformity that is independent of sample frequencies spanning over 6 orders of magnitude: from under 2 kHz to over 2 GHz. Only three active control lines are necessary for operation: Reset, Start/Stop and Read-Clock. When operating as common-stop device, the time of the stop, modulo 256 relative to the start, is read out along with the sampled signal values. Each of the four channels integrates dual-threshold trigger circuitry with windowed coincidence features. Channels can discriminate signals with ~1mV RMS resolution at >600 MHz bandwidth.
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 54-58
Monolithic Sensors for Charged-Particle Imaging using Per-Pixel Correlated Double Sampling
Monolithic CMOS cameras for direct imaging in electron microscopy and other radiation imaging applications have been developed, including complete cameras of up to 1 M-pixels, and have been used to capture images with superior resolution to that of commercial CCD-based systems. Optimizations for these sensors have been made via simulation and experiment, including studies of the impact of epitaxial silicon ionization region thickness, pixel pitch and diode size optimizations, and per-pixel correlated double sampling (CDS) technology. The per-pixel CDS scheme has demonstrated reductions in kT/C noise by a factor of four. It requires only one read instead of two reads plus pre- and post-integration subtraction, and is hence faster than alternate schemes. In addition, observation of Random Telegraph Signal noise (RTS) in small-capacitance pixels is demonstrated.
- 1 January 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1, 54-58
Monolithic Sensors for Charged-Particle Imaging using Per-Pixel Correlated Double Sampling
Monolithic CMOS cameras for direct imaging in electron microscopy and other radiation imaging applications have been developed, including complete cameras of up to 1 M-pixels, and have been used to capture images with superior resolution to that of commercial CCD-based systems. Optimizations for these sensors have been made via simulation and experiment, including studies of the impact of epitaxial silicon ionization region thickness, pixel pitch and diode size optimizations, and per-pixel correlated double sampling (CDS) technology. The per-pixel CDS scheme has demonstrated reductions in kT/C noise by a factor of four. It requires only one read instead of two reads plus pre- and post-integration subtraction, and is hence faster than alternate schemes. In addition, observation of Random Telegraph Signal noise (RTS) in small-capacitance pixels is demonstrated.