Eun-Soo Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Eun-Soo Kim has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Jong-Seob Won
Department of Mechanical and Automotive Engineering, Jeonju University, Jeonju 55069, Republic of Korea
3 shared publications - Jin-Woo Kim
Department of Electrical and Electronics Engineering, Jeonju University, Jeonju 55069, Republic of Korea
2 shared publications - Jun-Hyoung Park
Research Institute of Engineering and Technology, Jeonju University, Jeonju 55069, Republic of Korea
2 shared publications Min-Ji Kim
Department of Electrical and Electronics Engineering, Jeonju University, Jeonju, Republic of Korea
2 shared publications- Beom-Su Park
Department of Electrical & Electronics Engineering, Jeonju University, Jeonju-si 561-756, Republic of Korea
1 shared publication Bong-Geon Chung
Electrical & Electronics Engineering, Jeonju University, 1200, Hyoja-dong 3-ga, Wansan-gu, Jeonju, 560-759, Korea
1 shared publication
Latest Publications
- Open Access
Three-Bridge LLC-LC Resonant Converter with Wide Output Voltage Control Ranges
This paper presents an enhanced three-bridge LLC-LC DC-DC converter featuring notch filters implemented with an LC parallel resonant circuit. The proposed topology enables seamless output voltage regulation from the rated output voltage down to 0 VDC. To ensure stable operation over a wide output voltage range while maintaining a limited switching frequency variation, the converter adopts five operating-mode transitions, allowing effective voltage regulation even with a relatively large magnetizing inductance. Furthermore, excessive current in the LC parallel resonant tank is significantly reduced by restricting the voltage applied to the resonant circuit to one-quarter of the input voltage, even when operating at the LC resonant frequency. The operating principles of the proposed converter are thoroughly analyzed, and its performance and feasibility are validated experimentally.
Open AccessThree-Bridge LLC-LC Resonant Converter with Wide Output Voltage Control Ranges
This paper presents an enhanced three-bridge LLC-LC DC-DC converter featuring notch filters implemented with an LC parallel resonant circuit. The proposed topology enables seamless output voltage regulation from the rated output voltage down to 0 VDC. To ensure stable operation over a wide output voltage range while maintaining a limited switching frequency variation, the converter adopts five operating-mode transitions, allowing effective voltage regulation even with a relatively large magnetizing inductance. Furthermore, excessive current in the LC parallel resonant tank is significantly reduced by restricting the voltage applied to the resonant circuit to one-quarter of the input voltage, even when operating at the LC resonant frequency. The operating principles of the proposed converter are thoroughly analyzed, and its performance and feasibility are validated experimentally.
- Open Access
Three-Bridge LLC Resonant Converter with 5 Operation Mode Transitions for Wide Output Voltage Control
This paper presents a 3-Bridge LLC resonant converter featuring wide output voltage gain characteristics and a novel control method. To achieve operation within a narrower frequency control range, the proposed converter introduces one additional operational mode compared to the previously suggested 3-bridge topology. The converter is configured to have five distinct operation modes, controlled by the switching patterns of the main switches, to enable wide-range output voltage regulation. In each mode, frequency modulation is employed for output voltage control. Furthermore, a morphing control strategy is utilized to ensure stable output voltage regulation during mode transitions. The validity and practical applicability of the proposed 3-bridge LLC resonant converter with five operation modes are verified through experimental results from a 6 kW prototype.
Open AccessThree-Bridge LLC Resonant Converter with 5 Operation Mode Transitions for Wide Output Voltage Control
This paper presents a 3-Bridge LLC resonant converter featuring wide output voltage gain characteristics and a novel control method. To achieve operation within a narrower frequency control range, the proposed converter introduces one additional operational mode compared to the previously suggested 3-bridge topology. The converter is configured to have five distinct operation modes, controlled by the switching patterns of the main switches, to enable wide-range output voltage regulation. In each mode, frequency modulation is employed for output voltage control. Furthermore, a morphing control strategy is utilized to ensure stable output voltage regulation during mode transitions. The validity and practical applicability of the proposed 3-bridge LLC resonant converter with five operation modes are verified through experimental results from a 6 kW prototype.
- Open Access
- 3 September 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (17) , 7769
Three-Phase Single-Stage AC-DC Converter Using Series–Series Compensation Circuit in Inductive-Power-Transfer-Based Small Wind Power Generation System
In this paper, a three-phase single-stage AC-DC converter for an IPT-based small wind power generation system (WPGS) with an S-S compensation circuit is proposed. It applies a three-phase single-stage AC-DC converter to improve the input power factor (PF), efficiency, and reliability in small WPGSs. Also, inductive power transfer (IPT) was applied to compensate for brush wear in the nacelle of small and medium-sized wind turbines while ensuring electrical safety. In conditions of the three-phase Permanent Magnet Synchronous Generator (PMSG) voltage (80~260 Vrms) for the wind turbine and the load (150~1000 W), it was verified that the desired output voltage below 3% can be controlled through the fixed link voltage (VLink) control without wireless communication. A 1 kW prototype was built and tested to demonstrate its applicability to the rotation of small and medium-sized wind turbine nacelles instead of brushes and slip rings.
- 3 September 2024
- Published by MDPI AG in Applied Sciences
- Vol. 14 (17) , 7769
Open AccessThree-Phase Single-Stage AC-DC Converter Using Series–Series Compensation Circuit in Inductive-Power-Transfer-Based Small Wind Power Generation System
In this paper, a three-phase single-stage AC-DC converter for an IPT-based small wind power generation system (WPGS) with an S-S compensation circuit is proposed. It applies a three-phase single-stage AC-DC converter to improve the input power factor (PF), efficiency, and reliability in small WPGSs. Also, inductive power transfer (IPT) was applied to compensate for brush wear in the nacelle of small and medium-sized wind turbines while ensuring electrical safety. In conditions of the three-phase Permanent Magnet Synchronous Generator (PMSG) voltage (80~260 Vrms) for the wind turbine and the load (150~1000 W), it was verified that the desired output voltage below 3% can be controlled through the fixed link voltage (VLink) control without wireless communication. A 1 kW prototype was built and tested to demonstrate its applicability to the rotation of small and medium-sized wind turbine nacelles instead of brushes and slip rings.
- 5 March 2021
- Published by Springer Nature in Journal of Power Electronics
- Vol. 21 (5) , 768-781
Single stage AC–DC converter for wireless power transfer operating within wide voltage control range
- 5 March 2021
- Published by Springer Nature in Journal of Power Electronics
- Vol. 21 (5) , 768-781
Single stage AC–DC converter for wireless power transfer operating within wide voltage control range
- 3 September 2020
- Published by Springer Nature in Journal of Power Electronics
- Vol. 20 (6) , 1420-1432
3-Bridge LLC resonant converter for achieving wide output voltage control range based on topology morphing
- 3 September 2020
- Published by Springer Nature in Journal of Power Electronics
- Vol. 20 (6) , 1420-1432
3-Bridge LLC resonant converter for achieving wide output voltage control range based on topology morphing
- Open Access
High-Efficiency Bidirectional LLC Resonant Converter with Primary Auxiliary Windings
In this paper, high-efficiency bidirectional LLC resonant converters with primary auxiliary windings in transformers of resonant circuits are proposed. Even though resonant capacitors are used on the primary and secondary sides, the proposed converter can operate, regardless of the direction of the power flow, with the high gain characteristics of the LLC resonant converter without the mutual coupling of resonant capacitors. The operation principles and gain characteristics of the proposed bidirectional DC–DC converters are described in detail. A 3.3 kW prototyped bidirectional LLC resonant converter for interfacing 750 VDC buses was built and tested to verify the effectiveness and applicability of this proposed converter.
Open AccessHigh-Efficiency Bidirectional LLC Resonant Converter with Primary Auxiliary Windings
In this paper, high-efficiency bidirectional LLC resonant converters with primary auxiliary windings in transformers of resonant circuits are proposed. Even though resonant capacitors are used on the primary and secondary sides, the proposed converter can operate, regardless of the direction of the power flow, with the high gain characteristics of the LLC resonant converter without the mutual coupling of resonant capacitors. The operation principles and gain characteristics of the proposed bidirectional DC–DC converters are described in detail. A 3.3 kW prototyped bidirectional LLC resonant converter for interfacing 750 VDC buses was built and tested to verify the effectiveness and applicability of this proposed converter.
- 1 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 956-961
A Single Stage AC-DC Converter for Wireless Power Transfer System
In the field of electric vehicles, researches on wireless power transfer (WPT)charging system have been developed recently because of environmental problems and convenience. In this paper, we proposed a wireless power transfer charging system using a single stage AC/DC converter that can be reduced in size and weight, as well as ensuring convenience. The proposed single-stage AC/DC converter can control the wide output voltage (250 V DC ~ 350 V DC ) by the link voltage and pulsewidth voltage applied to CLLC resonant circuit through the phase-shifted modulation at a fixed switching frequency. Also, the input power factor (PF)and the total harmonic distortion (THD i )by using the proposed converter can be improved. A 1 kW prototype was fabricated and validated through experimental results and analysis.
- 1 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 956-961
A Single Stage AC-DC Converter for Wireless Power Transfer System
In the field of electric vehicles, researches on wireless power transfer (WPT)charging system have been developed recently because of environmental problems and convenience. In this paper, we proposed a wireless power transfer charging system using a single stage AC/DC converter that can be reduced in size and weight, as well as ensuring convenience. The proposed single-stage AC/DC converter can control the wide output voltage (250 V DC ~ 350 V DC ) by the link voltage and pulsewidth voltage applied to CLLC resonant circuit through the phase-shifted modulation at a fixed switching frequency. Also, the input power factor (PF)and the total harmonic distortion (THD i )by using the proposed converter can be improved. A 1 kW prototype was fabricated and validated through experimental results and analysis.
- 1 February 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 1651-1656
Operating Characteristics in LCLC Resonant Converter with A Low Coupling Transformer
Conventionally, to transfer the power from the primary power to the secondary one, high frequency series resonant converter has been widely used for the contact-less power supply system. However, the high frequency series resonant converter has the disadvantages such as the low efficiency, the high voltage gain characteristics and deviation of the phase angle in the overall load range. To improve these disadvantages, in this paper, the characteristics of the high efficiency and unit voltage gain as well as in-phase between input and current waveform are obtained with the proposed three-level LCLC (Inductor-Capacitor- Inductor-Capacitor) resonant converter. The proposed system results are verified by the simulation based on the theoretical analysis and the 4kW experimental prototype.
- 1 February 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 1651-1656
Operating Characteristics in LCLC Resonant Converter with A Low Coupling Transformer
Conventionally, to transfer the power from the primary power to the secondary one, high frequency series resonant converter has been widely used for the contact-less power supply system. However, the high frequency series resonant converter has the disadvantages such as the low efficiency, the high voltage gain characteristics and deviation of the phase angle in the overall load range. To improve these disadvantages, in this paper, the characteristics of the high efficiency and unit voltage gain as well as in-phase between input and current waveform are obtained with the proposed three-level LCLC (Inductor-Capacitor- Inductor-Capacitor) resonant converter. The proposed system results are verified by the simulation based on the theoretical analysis and the 4kW experimental prototype.
- 1 February 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 1625-1629
A Novel Topology of Secondary LLC Series Resonant Converter
Recently, the isolated high frequency boost DC/DC converter has been used widely for PCS (Power Conditioning System) because of the requirements of small size and low cost. However, the high frequency isolated boost DC/DC converters applied the conventional voltage-fed converter and current-fed converter have some problems like high conduction losses and high surge voltage due to high circulating current and leakage inductance, respectively. To improve these problems, a novel secondary LLC (called SLLC) series resonant converter is proposed in this paper and its theoretical analysis, simulation and experimental results for a boost DC/DC converter using SLLC series resonant topology verifies the proposed topology. 1kW experimental prototype is designed and tested.
- 1 February 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10482334,p. 1625-1629
A Novel Topology of Secondary LLC Series Resonant Converter
Recently, the isolated high frequency boost DC/DC converter has been used widely for PCS (Power Conditioning System) because of the requirements of small size and low cost. However, the high frequency isolated boost DC/DC converters applied the conventional voltage-fed converter and current-fed converter have some problems like high conduction losses and high surge voltage due to high circulating current and leakage inductance, respectively. To improve these problems, a novel secondary LLC (called SLLC) series resonant converter is proposed in this paper and its theoretical analysis, simulation and experimental results for a boost DC/DC converter using SLLC series resonant topology verifies the proposed topology. 1kW experimental prototype is designed and tested.