Wendy Van Moer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Wendy Van Moer has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Yves Rolain
Vrije Univ. Brussel, Brussels
7 shared publications Johan Schoukens
Vrije Universiteit Brussel|Pleinlaan
3 shared publications- Kurt Barbe
Biostatistics and Medical Informatics (BISI) Research Group, Vrije Universiteit Brussel, Brussels, Belgium
3 shared publications - R. Pintelon
Department of Electrical Engineering, Vrije Universiteit Brussel, Brussels, Belgium
3 shared publications Yves Rolain
Vrije Universiteit Brussel (Dept. ELEC/TW); Pleinlaan 2; B-1050 Brussels (Belgium)
2 shared publications- Johan Schoukens
Vrije Universiteit Brussel, Brussels, Belgium
1 shared publication
Latest Publications
- 26 June 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 62 (11) , 2912-2921
Blind Spectrum Sensing for Cognitive Radios Using Discriminant Analysis: A Novel Approach
In this paper, we present a new spectrum sensing technique for cognitive radios based on discriminant analysis called spectrum discriminator. The presented technique uses the knowledge of the noise uncertainty and a probabilistic validation to overcome the limitations of the discriminant analysis. A comparative study between the proposed technique and the maximum-minimum eigenvalue detection has been performed based on two performance metrics: the probability of false alarm and the probability of detection. The spectrum discriminator has been further developed to a peel-off technique where all primary users can be detected. The performance of the spectrum discriminator and the peel-off technique has been tested on simulations and experimentally verified. The comparative study is based on simulations as well as measurements.
- 26 June 2013
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 62 (11) , 2912-2921
Blind Spectrum Sensing for Cognitive Radios Using Discriminant Analysis: A Novel Approach
In this paper, we present a new spectrum sensing technique for cognitive radios based on discriminant analysis called spectrum discriminator. The presented technique uses the knowledge of the noise uncertainty and a probabilistic validation to overcome the limitations of the discriminant analysis. A comparative study between the proposed technique and the maximum-minimum eigenvalue detection has been performed based on two performance metrics: the probability of false alarm and the probability of detection. The spectrum discriminator has been further developed to a peel-off technique where all primary users can be detected. The performance of the spectrum discriminator and the peel-off technique has been tested on simulations and experimentally verified. The comparative study is based on simulations as well as measurements.
- 9 November 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 60 (3) , 1061-1069
Automatic Detection, Estimation, and Validation of Harmonic Components in Measured Power Spectra: All-in-One Approach
The detection of periodic components buried in noise is a general problem in various engineering fields. The amplitudes in the frequency domain of a disturbed signal follow Rice distribution, which is fully described by two parameters. Most methods are restricted to automatically detecting the harmonic components. In this paper, we extend the methodology to detect significant harmonics in measured spectra such that, aside from detection, the magnitude of the harmonic component is also estimated, together with the probability that the harmonic component was incorrectly detected.
- 9 November 2010
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 60 (3) , 1061-1069
Automatic Detection, Estimation, and Validation of Harmonic Components in Measured Power Spectra: All-in-One Approach
The detection of periodic components buried in noise is a general problem in various engineering fields. The amplitudes in the frequency domain of a disturbed signal follow Rice distribution, which is fully described by two parameters. Most methods are restricted to automatically detecting the harmonic components. In this paper, we extend the methodology to detect significant harmonics in measured spectra such that, aside from detection, the magnitude of the harmonic component is also estimated, together with the probability that the harmonic component was incorrectly detected.
- 6 November 2009
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 20 (12)
Measuring source-pull free nonlinear distortions: a multisine approach
This paper presents a method to measure the nonlinear distortions generated by a device-under-test (DUT) out of the frequency band where the device operates. The method compensates for the nonlinear distortions present in the input signal of the DUT and, hence, results in a source-pull free level of the output nonlinear distortions. This is important when determining an accurate adjacent co-channel power ratio (ACPR). The proposed measurement technique is based on a vectorial network analyzer (PNA-X) combined with a broadband multisine excitation of the DUT. Results obtained from a microwave amplifier are reported.
- 6 November 2009
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 20 (12)
Measuring source-pull free nonlinear distortions: a multisine approach
This paper presents a method to measure the nonlinear distortions generated by a device-under-test (DUT) out of the frequency band where the device operates. The method compensates for the nonlinear distortions present in the input signal of the DUT and, hence, results in a source-pull free level of the output nonlinear distortions. This is important when determining an accurate adjacent co-channel power ratio (ACPR). The proposed measurement technique is based on a vectorial network analyzer (PNA-X) combined with a broadband multisine excitation of the DUT. Results obtained from a microwave amplifier are reported.
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 963-966
An Automatic, Statistical-based Detection of Outliers in an Inter-laboratory Comparison of Nonlinear Measurements
This paper describes the comparison of calibrated nonlinear Radio-Frequency (RF) measurements performed on a nonlinear device by five different measurement laboratories. The device-under-test is a nonlinear active semiconductor device that is designed to generate a maximum number of harmonic tones. The goal is to obtain a simple, automated method that allows detecting if some laboratory had measurement problems during the measurement campaign. The developed comparison method is based on the Analysis of Variance (ANOVA) technique.
- 1 October 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 963-966
An Automatic, Statistical-based Detection of Outliers in an Inter-laboratory Comparison of Nonlinear Measurements
This paper describes the comparison of calibrated nonlinear Radio-Frequency (RF) measurements performed on a nonlinear device by five different measurement laboratories. The device-under-test is a nonlinear active semiconductor device that is designed to generate a maximum number of harmonic tones. The goal is to obtain a simple, automated method that allows detecting if some laboratory had measurement problems during the measurement campaign. The developed comparison method is based on the Analysis of Variance (ANOVA) technique.
- 25 July 2008
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 19 (9)
Measuring the response of a voltage-controlled oscillator using the large-signal network analyser
In this paper, a method is proposed that allows for a direct measurement of the dynamic voltage-to- frequency transfer characteristic and the actual waveform of a Voltage Controlled Oscillator (VCO). Real-world measurements on a 1650 MHz unit over a 2 MHz frequency sweep show the applicability of the proposed technique.
- 25 July 2008
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 19 (9)
Measuring the response of a voltage-controlled oscillator using the large-signal network analyser
In this paper, a method is proposed that allows for a direct measurement of the dynamic voltage-to- frequency transfer characteristic and the actual waveform of a Voltage Controlled Oscillator (VCO). Real-world measurements on a 1650 MHz unit over a 2 MHz frequency sweep show the applicability of the proposed technique.
- 7 January 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 57 (2) , 395-400
Estimation and Validation of Semiparametric Dynamic Nonlinear Models
An approach for measurement-based modeling of nonlinear devices is proposed. The method that is commonly used for linear time-invariant systems, namely, parametric modeling and nonparametric verification, is hereby extended to a class of nonlinear systems. The applicability of the method is illustrated on the baseband modeling of a radio-frequency amplifier over a wide power and frequency range.
- 7 January 2008
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 57 (2) , 395-400
Estimation and Validation of Semiparametric Dynamic Nonlinear Models
An approach for measurement-based modeling of nonlinear devices is proposed. The method that is commonly used for linear time-invariant systems, namely, parametric modeling and nonparametric verification, is hereby extended to a class of nonlinear systems. The applicability of the method is illustrated on the baseband modeling of a radio-frequency amplifier over a wide power and frequency range.
- 17 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 56 (5) , 2051-2056
Determining the Reciprocity of Mixers Through Three-Port Large Signal Network Analyzer Measurements
In this paper, a method to determine the reciprocity of radio-frequency mixers is proposed based on fully calibrated three-port large signal network analyzer measurements. Besides revealing the reciprocity of the mixers, this type of measurement can also be used in yielding the match conditions at all ports as well as magnitude, phase, and group-delay response of the conversion loss of the mixer.
- 17 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 56 (5) , 2051-2056
Determining the Reciprocity of Mixers Through Three-Port Large Signal Network Analyzer Measurements
In this paper, a method to determine the reciprocity of radio-frequency mixers is proposed based on fully calibrated three-port large signal network analyzer measurements. Besides revealing the reciprocity of the mixers, this type of measurement can also be used in yielding the match conditions at all ports as well as magnitude, phase, and group-delay response of the conversion loss of the mixer.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007
- No. 10915281,p. 1-6
A Multisine based Calibration for Broadband Measurements
Classical calibration techniques use single sinewave measurements to maximize the signal-to-noise ratio. In large-signal characterisation, the large number of instrument states to calibrate results in unacceptably long calibration times. The proposed approach uses multisine excitation signals during the calibration, in order to reduce the calibration time, while having only a marginal influence on the measured device response.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007
- No. 10915281,p. 1-6
A Multisine based Calibration for Broadband Measurements
Classical calibration techniques use single sinewave measurements to maximize the signal-to-noise ratio. In large-signal characterisation, the large number of instrument states to calibrate results in unacceptably long calibration times. The proposed approach uses multisine excitation signals during the calibration, in order to reduce the calibration time, while having only a marginal influence on the measured device response.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007
- No. 10915281,p. 1-6
Measuring the Response of a Voltage Controlled Oscillator using the Large-Signal Network Analyser
In this paper, a method is proposed that allows for a direct measurement of the dynamic voltage-to-frequency transfer characteristic and the actual waveform of a voltage controlled oscillator (VCO). Real-world measurements on a 1650 MHz unit over a 2 MHz frequency sweep show the applicability of the proposed technique.
- 1 May 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2007 IEEE Instrumentation & Measurement Technology Conference IMTC 2007
- No. 10915281,p. 1-6
Measuring the Response of a Voltage Controlled Oscillator using the Large-Signal Network Analyser
In this paper, a method is proposed that allows for a direct measurement of the dynamic voltage-to-frequency transfer characteristic and the actual waveform of a voltage controlled oscillator (VCO). Real-world measurements on a 1650 MHz unit over a 2 MHz frequency sweep show the applicability of the proposed technique.
- 1 September 2003
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 36 (16) , 327-331
Estimation and validation of semi-parametric dynamic nonlinear models
- 1 September 2003
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 36 (16) , 327-331
Estimation and validation of semi-parametric dynamic nonlinear models