Harold Kirk
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Harold Kirk has a total of 93 co-authors. Here are the top co-authors by number of shared publications:
K.T. McDonald
4 shared publicationsJ. Fischer
Brookhaven Nat. Lab., Upton, NY, USA
3 shared publications- R. C. Fernow
Brookhaven National Laboratory
3 shared publications R.B. Palmer
3 shared publicationsS. Ulc
Brookhaven Nat. Lab., Upton, NY, USA
3 shared publicationsH. Ludewig
2 shared publications
Latest Publications
- Open Access
- 5 March 2009
- Published by Office of Scientific and Technical Information (OSTI)
FY2009 R&D Plan: Neutrino Factory and Muon Collider Collaboration
The U.S. Department of Energy's Office of Scientific and Technical Information
- 5 March 2009
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessFY2009 R&D Plan: Neutrino Factory and Muon Collider Collaboration
The U.S. Department of Energy's Office of Scientific and Technical Information
- 15 February 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19444680,p. 3745-3747
A High-Power Target Experiment
We describe an experiment designed as a proof-of-principle test for a target system capable of converting a 4-MW proton beam into a high-intensity muon beam suitable for incorporation into either a neutrino factory complex or a muon collider. The target system is based on exposing a free mercury jet to an intense proton beam in the presence of a high-strength solenoidal magnetic field.
- 15 February 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19444680,p. 3745-3747
A High-Power Target Experiment
We describe an experiment designed as a proof-of-principle test for a target system capable of converting a 4-MW proton beam into a high-intensity muon beam suitable for incorporation into either a neutrino factory complex or a muon collider. The target system is based on exposing a free mercury jet to an intense proton beam in the presence of a high-strength solenoidal magnetic field.
- 15 February 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19444680,p. 333-335
Post-Irradiation Properties of Candidate Materials for High-Power Targets
The desire of the high-energy-physics community for more intense secondary particle beams motivates the development of multi-megawatt, pulsed proton sources. The targets needed to produce these secondary particle beams must be sufficiently robust to withstand the intense pressure waves arising from the high peak-energy deposition which an intense pulsed beam will deliver. In addition, the materials used for the targets must continue to perform in a severe radiation environment. The effect of the beam-induced pressure waves can be mitigated by use of target materials with high-yield strength and/or low coefficient of thermal expansion (CTE) [1, 2, 3]. We report here first results of an expanded study of the effects of irradiation on several additional candidate materials with high strength (AlBeMet, beryllium, Ti-V6-Al4) or low CTE (a carbon-carbon composite, a new Toyota” gum” metal alloy [4], Super-Invar).
- 15 February 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19444680,p. 333-335
Post-Irradiation Properties of Candidate Materials for High-Power Targets
The desire of the high-energy-physics community for more intense secondary particle beams motivates the development of multi-megawatt, pulsed proton sources. The targets needed to produce these secondary particle beams must be sufficiently robust to withstand the intense pressure waves arising from the high peak-energy deposition which an intense pulsed beam will deliver. In addition, the materials used for the targets must continue to perform in a severe radiation environment. The effect of the beam-induced pressure waves can be mitigated by use of target materials with high-yield strength and/or low coefficient of thermal expansion (CTE) [1, 2, 3]. We report here first results of an expanded study of the effects of irradiation on several additional candidate materials with high strength (AlBeMet, beryllium, Ti-V6-Al4) or low CTE (a carbon-carbon composite, a new Toyota” gum” metal alloy [4], Super-Invar).
- 8 July 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Progress in designing a muon cooling ring with lithium lenses
We discuss particle tracking simulations in a storage ring with lithium lens inserts designed for the six-dimensional phase space cooling of muons by the ionization cooling. The ring design contains one or more lithium lens absorbers for transverse cooling that transmit the beam with very small beta-function values, in addition to liquid- hydrogen wedge-shaped absorbers in dispersive locations for longitudinal cooling. Such a ring could comprise the final component of a cooling system for use in a muon collider. The beam matching between dipole-quadrupole lattices and the lithium lenses is of particular interest.
- 8 July 2004
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Progress in designing a muon cooling ring with lithium lenses
We discuss particle tracking simulations in a storage ring with lithium lens inserts designed for the six-dimensional phase space cooling of muons by the ionization cooling. The ring design contains one or more lithium lens absorbers for transverse cooling that transmit the beam with very small beta-function values, in addition to liquid- hydrogen wedge-shaped absorbers in dispersive locations for longitudinal cooling. Such a ring could comprise the final component of a cooling system for use in a muon collider. The beam matching between dipole-quadrupole lattices and the lithium lenses is of particular interest.
- 7 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Operational status of the Brookhaven National Laboratory Accelerator Test Facility
The design and operation of a 50-MeV electron linear accelerator utilizing a low emittance ( gamma epsilon =5 to 10 mm-mrad) radio-frequency gun operating at an output energy of 5 MeV and a charge of 1 nC are described. Design calculations, early radio-frequency measurements, and operational experience with the electron gun utilizing a dummy cathode in place of the proposed photocathode emitter are given. The dynamics of the electron beam coming off the photocathode has been modeled with the programs PARMELA and MASK. General agreement as to the expected characteristics of the electron beam at the RF-gun exit has been obtained using the two programs. It was also verified that, with proper matching of the transverse beam, no increase of the transverse normalized emittance occurs at the linac due to the fundamental RF mode.
- 7 January 2003
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Operational status of the Brookhaven National Laboratory Accelerator Test Facility
The design and operation of a 50-MeV electron linear accelerator utilizing a low emittance ( gamma epsilon =5 to 10 mm-mrad) radio-frequency gun operating at an output energy of 5 MeV and a charge of 1 nC are described. Design calculations, early radio-frequency measurements, and operational experience with the electron gun utilizing a dummy cathode in place of the proposed photocathode emitter are given. The dynamics of the electron beam coming off the photocathode has been modeled with the programs PARMELA and MASK. General agreement as to the expected characteristics of the electron beam at the RF-gun exit has been obtained using the two programs. It was also verified that, with proper matching of the transverse beam, no increase of the transverse normalized emittance occurs at the linac due to the fundamental RF mode.
- 1 January 1995
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 337 (1) , 94
Status of the BNL-MIT-SLAC cluster klystron project
A general description is given of the status of the cluster klystron project. This paper is chiefly concerned with the mechanical design, magnetic field, plasma wavelength analyses, and beam dynamics. Finally, an idea for a new type of output window is presented.
- 1 January 1995
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 337 (1) , 94
Status of the BNL-MIT-SLAC cluster klystron project
A general description is given of the status of the cluster klystron project. This paper is chiefly concerned with the mechanical design, magnetic field, plasma wavelength analyses, and beam dynamics. Finally, an idea for a new type of output window is presented.
- 29 October 1989
- Published by Office of Scientific and Technical Information (OSTI)
Proposal for a study of laser acceleration of electrons using micrograting structures at ATF (Phase 1)
We propose to investigate new methods of particle acceleration using a short-pulse CO{sub 2} laser as the power source and grating-like structures as accelerator cavities''. Phase I of this program is intended to demonstrate the principle of the method. We will focus the laser light to a 3 mm line on the surface of the microstructure. The structure is used to transform the electric field pattern of the incoming transversely polarized laser beam to a mode which has a component along the electron beam direction in the vicinity of the surface. With 6 mJ of laser energy and a 6 ps pulse length, the electric field in the spot will be around 1 GV/m. The electron beam from the Brookhaven Accelerator Test Facility (ATF) will be focused transversely within the few micron transverse dimension of the microstructure. The maximum expected acceleration for a 1 GV/m field and a 3 mm acceleration length is 3 MeV. 17 refs., 11 figs., 2 tabs.
- 29 October 1989
- Published by Office of Scientific and Technical Information (OSTI)
Proposal for a study of laser acceleration of electrons using micrograting structures at ATF (Phase 1)
We propose to investigate new methods of particle acceleration using a short-pulse CO{sub 2} laser as the power source and grating-like structures as accelerator cavities''. Phase I of this program is intended to demonstrate the principle of the method. We will focus the laser light to a 3 mm line on the surface of the microstructure. The structure is used to transform the electric field pattern of the incoming transversely polarized laser beam to a mode which has a component along the electron beam direction in the vicinity of the surface. With 6 mJ of laser energy and a 6 ps pulse length, the electric field in the spot will be around 1 GV/m. The electron beam from the Brookhaven Accelerator Test Facility (ATF) will be focused transversely within the few micron transverse dimension of the microstructure. The maximum expected acceleration for a 1 GV/m field and a 3 mm acceleration length is 3 MeV. 17 refs., 11 figs., 2 tabs.
- 1 August 1985
- Published by American Physical Society (APS) in Physical Review D
- Vol. 32 (3) , 531-540
Opposite-sign dilepton production ininteractionsWe report on a high-statistics bubble-chamber experiment using the Fermilab 15-ft bubble chamber filled with a heavy neon/hydrogen mixture exposed to a wide-band neutrino beam. In a sample of 106 000 &>0.3 GeV/c) and a negative muon were observed. After corrections, the rate for opposite-sign dilepton production for charged-current events is (0.52±0.09)%. The dependence of this rate from threshold to ≊200 GeV is presented. The kinematic distributions and strange-particle content of the dilepton events are consistent with those expected from charm-particle production in neutrino interactions. A total of 58 neutral strange particles (Λ→p, → ) are observed in these events, where less than 16 are expected from conventional charged-current interactions. The presence of a significant excess of Λ’s is evidence for substantial charmed-baryon production.- 1 August 1985
- Published by American Physical Society (APS) in Physical Review D
- Vol. 32 (3) , 531-540
Opposite-sign dilepton production ininteractionsWe report on a high-statistics bubble-chamber experiment using the Fermilab 15-ft bubble chamber filled with a heavy neon/hydrogen mixture exposed to a wide-band neutrino beam. In a sample of 106 000 &>0.3 GeV/c) and a negative muon were observed. After corrections, the rate for opposite-sign dilepton production for charged-current events is (0.52±0.09)%. The dependence of this rate from threshold to ≊200 GeV is presented. The kinematic distributions and strange-particle content of the dilepton events are consistent with those expected from charm-particle production in neutrino interactions. A total of 58 neutral strange particles (Λ→p, → ) are observed in these events, where less than 16 are expected from conventional charged-current interactions. The presence of a significant excess of Λ’s is evidence for substantial charmed-baryon production.