QWQing Wu

Qing Wu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Qing Wu has a total of 36 co-authors. Here are the top co-authors by number of shared publications:

  • Sen Peng

    School of Environmental Science and Engineering, Tianjin University, No. 135 Yaguan Road, Jinnan District, Tianjin, 300350, China

    9 shared publications
  • Xinhua Zhao

    School of Environmental Science and Engineering, Tianjin University, Tianjin 300350, China

    6 shared publications
  • Sen Peng

    School of Environmental Science and Engineering, Tianjin University, Tianjin 300350, China

    4 shared publications
  • Qiannan Li

    School of Environmental Science and Engineering, Tianjin University, Tianjin, China

    3 shared publications
  • Ruihan Wan

    School of Environmental Science and Engineering, Tianjin University, Tianjin, China

    3 shared publications
  • Xiaofei Zhao

    School of Environmental Science and Engineering, Tianjin University, Tianjin, China

    3 shared publications

Latest Publications

  • Open Access

    Burst Diagnosis Multi-Stage Model for Water Distribution Networks Based on Deep Learning Algorithms

    by Sen Peng, Yuxin Wang, Xu Fang, Qing Wu

    Pipe bursts in water distribution networks (WDNs) pose significant threats to the safety of distribution networks, driving attention to deep learning-based burst detection and localization. However, the applicability of different pressure features still needs to be compared and verified. A large number of nodes challenges deep learning with the excessive number of classification categories and low recognition accuracy. To address these problems, this paper extracts different burst pressure features, including pressure value, pressure difference, and pressure fluctuation ratio, and inputs one of these features into a Burst Diagnosis Multi-Stage Model (BDMM) based on three CS-LSTMs (a combination of the Cuckoo Search algorithm and a long short-term memory network). The first model addresses a binary classification problem, outputting labels indicating whether a pipe burst has occurred. The second one solves a multi-classification problem, outputting the label of the burst partition, and the third model also solves a multi-classification problem, outputting the ID of the bursting junction. The model is tested on a real network and outperforms ELM. For basic burst identification tasks using CS-LSTM, differences among the three features are minimal, while pressure difference and pressure fluctuation ratio exhibit superior performance to pressure value when resolving more complex problems like burst junction localization.


  • Cr(VI) reduction by Agrobacterium sp. Cr-1 and Lysinibacillus sp. Cr-2, novel Cr(VI)-reducing strains isolated from chromium plant soil

    by Qing Wu, Qiannan Li, Ying Zhang, Ruihan Wan, Sen Peng

    The bioremediation of Cr(VI)-contaminated soil is a promising strategy; however, the performance of Cr(VI)-reducing bacteria is limited by the toxicity of Cr(VI). In this study, two novel Cr(VI)-reducing bacteria were isolated from a Cr salt plant and identified as Agrobacterium sp. and Lysinibacillus sp. The Cr(VI) reduction conditions of the two strains were optimized. At a Cr(VI) concentration of 500 mg/L, Agrobacterium sp. Cr-1 reduced Cr(VI) with a removal rate of 96.91%, while that for Lysinibacillus sp. Cr-2 was 92.82%. First-order reaction kinetic equations simulated the positive relationship between time and Cr(VI) concentration during Cr(VI) reduction in these two strains. Agrobacterium sp. Cr-1 was further studied, and the effects of different cell components on Cr(VI) reduction were detected. The extracellular extracts of Agrobacterium sp. Cr-1 played a major role in Cr(VI) reduction, followed by intracellular extracts and cell membranes. The scanning electron microscope-energy dispersive spectrometer (SEM–EDS) images show that the precipitation was Cr. The high Cr(VI) reducing ability of Agrobacterium sp. Cr-1 suggests that this strain is promising for the remediation of Cr(VI)-contaminated sites.


  • Simultaneous treatment of chromium-containing wastewater and electricity generation using a plant cathode-sediment microbial fuel cell: investigation of associated mechanism and influencing factors

    by Qing Wu, Jieqiong Liu, Wenjun Mo, Qiannan Li, Ruihan Wan, Sen Peng

    A novel plant cathode-sediment microbial fuel cell (P-SMFC) was constructed to treat Cr-containing wastewater, and the effects of the plants used, initial concentrations of Cr(VI) employed, and the external resistance on the treatment of wastewater and generation of electricity were investigated. The results showed that the system achieved the best performance when Acorus calamus was the cathode plant, the external resistance was 2000 Ω, and the initial Cr (VI) concentration of the overlying water of is 230 mg/L. A maximum power density of 40.16 mW/m2 was reached, and Cr (VI) and COD removal efficiencies in the overlying water were 99.94% and 98.21%, respectively. The closed-circuit installation promoted the attachment of many microorganisms to the cathode, anode and sediment, increased species abundance, and reduced species diversity. The P-SMFC is inexpensive to construct, it consumes no energy, and it can generate bioelectricity; it thus has great application development value as a chromium-containing wastewater treatment method.


  • Open Access

    Effect of Electrode Distances on Remediation of Eutrophic Water and Sediment by Sediment Microbial Fuel Cell Coupled Floating Beds

    by Qing Wu, Jieqiong Liu, Qiannan Li, Wenjun Mo, Ruihan Wan, Sen Peng

    Efficient and sustainable technologies for cleaning of contaminated water and sediments are in urgent demand. In this study, a new type of sediment microbial fuel cell coupled floating bed (FB-SMFC) was developed to repair eutrophic water and sediment in a cleaner way. The effect of electrode spacing on the power generation capacity and the synchronous remediation of pollutants from eutrophic water and sediment were studied. When the electrode distance was 60 cm, the maximum power generation and pollutant removal effects were obtained. At the end of the experiment, the maximum output voltage was 0.4 V, and the chemical oxygen demand (CODCr, potassium dichromate method), total nitrogen (TN), and total phosphorus (TP) contents in the overlying water were 8 mg/L, 0.7 mg/L, and 0.39 mg/L. The corresponding removal rates were 88.2%, 78.8%, and 59.0%, respectively. The removal rates of organic matter and TN in the sediment were 12.8% and 86.4%, respectively, and the fixation rate of TP was 29.2%. Proteobacteria was the dominant phylum of bacteria in the sediment and anode. Many anaerobic bacteria were found in the overlying water, which facilitated denitrification. Overall, the results of this research revealed a highly efficient and reliable strategy for eutrophic water and sediment remediation, aquatic ecosystems restoration, and human health protection.


  • Open Access

    Transformation of Chromium Speciation during High Hexavalent Chromium-Contaminated Soil Remediation by CPS and Biostimulation

    by Qing Wu, Ruihan Wan, Qiannan Li, Wenjun Mo, Jieqiong Liu, Caiyun Zhao, Sen Peng

    To address the secondary pollution problem of chemical reduction and the defects of a long bioremediation period for the soil around a chromium (Cr) salt plant in China, calcium polysulfide (CPS) combined with biostimulation (adding nutrient solution with glucose and urea) was used to reduce and stabilize hexavalent chromium [Cr(VI)] in the soil. The results showed that the remediation effect of adding CPS and nutrient solution was better than that of CPS alone for Cr(VI)-contaminated soil. An amount of 2.15% CPS with the Cr(VI) concentration reduced to approximately 330.0 mg/kg was selected as the optimal reducing agent dosage. Following the addition of 11 g/kg glucose and 13 g/kg urea, the degradation rate of Cr(VI) reached over 92% after 3 days, and the water-soluble fraction decreased by 95.6% after 40 days. The stability of the Cr was significantly enhanced. The correlation and regression analyses of Cr speciation indicated that the water-soluble fraction had significant negative correlations with the iron-manganese (Fe-Mn) oxide-bound fraction and the organic matter-bound fraction. There were significant negative correlations between the exchangeable fraction and the carbonate-bound fraction as well as extremely significant positive correlations between the Fe-Mn oxide-bound fraction and the organic matter-bound fraction. It was speculated that both the Fe-Mn oxide-bound fraction and the organic matter-bound fraction were transformed from the water-soluble fraction, and the exchangeable fraction and the carbonate-bound fraction were mutually transformed. This study enables us to acquire more knowledge about the speciation transformation of Cr in soil and provides an efficient, low-cost, and low-risk technology for the remediation of high Cr(VI)-contaminated soil.


  • Open Access

    Pressure Sensor Placement in Water Supply Network Based on Graph Neural Network Clustering Method

    by Sen Peng, Jing Cheng, Xingqi Wu, Xu Fang, Qing Wu

    Pressure sensor placement is critical to system safety and operation optimization of water supply networks (WSNs). The majority of existing studies focuses on sensitivity or burst identification ability of monitoring systems based on certain specific operating conditions of WSNs, while nodal connectivity or long-term hydraulic fluctuation is not fully considered and analyzed. A new method of pressure sensor placement is proposed in this paper based on Graph Neural Networks. The method mainly consists of two steps: monitoring partition establishment and sensor placement. (1) Structural Deep Clustering Network algorithm is used for clustering analysis with the integration of complicated topological and hydraulic characteristics, and a WSN is divided into several monitoring partitions. (2) Then, sensor placement is carried out based on burst identification analysis, a quantitative metric named “indicator tensor” is developed to calculate hydraulic characteristics in time series, and the node with the maximum average partition perception rate is selected as the sensor in each monitoring partition. The results showed that the proposed method achieved a better monitoring scheme with more balanced distribution of sensors and higher coverage rate for pipe burst detection. This paper offers a new robust framework, which can be easily applied in the decision-making process of monitoring system establishment.


  • Microporous intermittent aeration vertical flow constructed wetlands for eutrophic water improvement

    by Qing Wu, Jingjing Xiao, Lijuan Fu, Mengxing Ma, Sen Peng

    To enhance eutrophic water improvement effect, three parallel lab-scale oxidation pond-vertical subsurface flow constructed wetland-stable pond combined systems with different microporous intermittent aeration positions were constructed. The purification effect of each system was determined, and the contribution rate of each part of the system was also calculated. The characters of bacterial community under different aeration positions were also analyzed. Microporous intermittent aeration rate of 5 mg/L was chosen as the aeration rate for follow-up experiment. The result showed that the best CODCr, total nitrogen, and total phosphorus removal efficiencies were achieved by the combined system with bottom microporous intermittent aeration, and the efficiencies were 71.04%, 79.52%, and 95.10%, respectively. The best ammonium nitrogen removal efficiency was 92.62% and was achieved by the combined system with surface microporous intermittent aeration. After analyses, 14 strains of bacteria associated with the removal of N elements were found and 8 strains of bacteria associated with P element cycle were found.