FDFelix Dyrna

Felix Dyrna

*This is an algorithmically generated author record based on publicly available information.

Felix Dyrna has a total of 99 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    The 2026 ESSKA‐ESA formal consensus on partial‐thickness posterosuperior rotator cuff tears (Part 2): Treatment strategies, rehabilitation, return to sport and complications

    by Jean Kany, Miguel Ruiz Iban, Emilio Calvo, Claudio Rosso, Chris Peach, Carlos Maia Dias, Pierre Métais, Maristella Francesca Saccomanno, Berte Bøe, Emmanouil Brilakis, et al.

    Purpose: To establish evidence‐based consensus recommendations for the management of partial‐thickness posterosuperior rotator cuff tears (PT‐PS‐RCTs). This second part addresses treatment strategies, rehabilitation, return to sport and complications. Methods: This European Society for Sports Traumatology, Knee Surgery and Arthroscopy–European Shoulder Associates (ESSKA‐ESA) Formal Consensus was conducted according to the ESSKA Formal Consensus Methodology. A Steering Group (13 shoulder surgeons) developed 33 questions and statements based on a standardized literature review and assigned recommendation grades (A–D) according to the level of evidence. Statements were evaluated by an independent Rating Group (20 shoulder surgeons) through a three‐round consensus process. Results: Twenty‐one Question–Statement (Q–S) pairs achieved strong agreement, generating 30 individual recommendations (1 Grade A, 6 Grade B, 10 Grade C and 13 Grade D). Grade A evidence identified an increased risk of postoperative stiffness after trans‐tendon repair of articular‐sided PT‐PS‐RCTs compared with tear completion. Grade B evidence supported conservative treatment for at least 6 months, platelet‐rich plasma injections and management of stiffness before surgery; both trans‐tendon/in‐situ repair and tear‐completion‐and‐repair showed similar return‐to‐sport rates, although tear‐completion‐and‐repair had slightly higher retear rates. The most commonly reported patient‐reported outcome measures were the American Shoulder and Elbow Surgeons, Constant–Murley and visual analogue scale scores. Conclusion: Management should be individualized according to patient characteristics (activity level, sports participation), symptoms, tear morphology and tissue quality rather than based on a single treatment algorithm. Non‐surgical treatment is the preferred initial approach, whereas no surgical technique has demonstrated consistent superiority across all clinical scenarios. These recommendations provide clinicians with a practical framework to guide treatment decisions and standardize the management of PT‐PS‐RCTs in daily clinical practice. Level of Evidence: Level I, formal consensus.

  • Open Access

    The 2026 ESSKA‐ESA formal consensus on partial‐thickness posterosuperior rotator cuff tears (Part 1): Definitions, classifications, etiologies, natural history and diagnosis

    by Jean Kany, Miguel Angel Ruiz Iban, Claudio Rosso, Chris Peach, Pierre Métais, Carlos Maia Dias, Emilio Calvo, Maristella Francesca Saccomanno, Berte Bøe, Emmanouil Brilakis, et al.

    Purpose: To establish evidence‐based consensus recommendations regarding the diagnosis and treatment of partial‐thickness posterosuperior rotator cuff tears (PT‐PS‐RCTs). This part addresses the definition, classification, natural history and diagnosis of these controversial conditions in shoulder surgery. Methods: This official European Society of Sports Medicine, Knee Surgery and Arthroscopy–European Shoulder Associates (ESSKA‐ESA) Formal Consensus was conducted according to the ESSKA Formal Consensus Methodology. A Steering Group developed 33 questions, followed by a standardized literature search and evidence review. For each question, a consensus statement was drafted and assigned recommendation grades (A–D) according to the level of evidence. An independent Rating Group evaluated all statements until strong agreement was achieved. Results: Twelve recommendations were generated with three Grade A, three Grade B, two Grade C, five Grade D and strong agreement. Grade A was found for the use of multiple classification systems in unison to characterize these injuries and for the distinction between acute and chronic tears. Scientific presumption level (Grade B) was found for the increased incidence of articular injuries in overhead and contact athletes and for the absence of a link between calcifying tendinitis and PT‐PS‐RCTs. Grade C was found to define the risk and timeframe of tear progression and the ideal imaging modality. Conclusion: This ESSKA‐ESA Formal Consensus recommends that PT‐PS‐RCTs should be classified according to tear location, depth and tendon involvement. The aetiology of these injuries is multifactorial, and their progression is unpredictable. Current imaging modalities have limitations in characterizing these lesions. The present consensus provides clinicians with a practical evidence‐based framework for the diagnosis and classification of PT‐PS‐RCTs while identifying key priorities for future clinical research. Level of Evidence: Level I formal consensus.


  • The journey from Open to Scope

    by Lena-Maria Watzke, Felix Dyrna

  • AGA-Umfrage: Aktuelle Aspekte der Versorgung mit Zell- und Gewebetherapien in DE/AT/CH

    by Bernhard Waibl, Peter Angele, Wolfgang Hackl, Michael T. Hirschmann, Stefan Nehrer, Amir Steinitz, Johannes Zellner, Philipp Niemeyer, Felix Dyrna

  • Open Access

    Biomechanical Value of a Protective Proximal Humeral Cerclage in Reverse Total Shoulder Arthroplasty

    by Philipp A. Michel, J. Christoph Katthagen, Benedikt Schliemann, Sina Wilkens, Andre Frank, Lukas F. Heilmann, Felix Dyrna, Michael J. Raschke

    Reverse shoulder arthroplasty (RSA) is a commonly performed salvage procedure for failed proximal humeral fracture fixation. The rate of intraoperative periprosthetic fractures is higher compared to primary RSA. The goal of this study was to investigate the biomechanical value of a protective cerclage during stem impaction in a revision surgery setting. Twenty-eight fresh-frozen human humeri were used to assess different configurations for steel wire and FiberTape cerclages. A custom-built biomechanical test setup simulated the mallet strikes during the stem impaction process with the Univers Revers prothesis stem. The mallet energy until the occurrence of a first crack was not different between groups. The total energy until progression of the fracture distally to the cerclage was significantly higher in the cerclage groups compared to the native humerus (9.5 J vs. 3.5 J, respectively; p = 0.0125). There was no difference between the steel wire and FiberTape groups (11.4 J vs. 8.6 J, respectively; p = 0.2695). All fractures were located at the concave side of the stem at the metaphyseal calcar region. This study demonstrates that a protective cerclage can successfully delay the occurrence of a fracture during stem impaction in reverse shoulder arthroplasty. A FiberTape cerclage is biomechanically equally efficient compared to a steel wire cerclage.


  • Open Access

    Metacarpal shaft fixation: a biomechanical comparison of dorsal plating, lag screws, and headless compression screws

    by Felix G. E. Dyrna, Daniel M. Avery, Ryu Yoshida, David Lam, Simon Oeckenpöhler, Mark P. Cote, Elifho Obopilwe, Craig M. Rodner, Augustus D. Mazzocca

    Background: Metacarpal shaft fractures are common and can be treated nonoperatively. Shortening, angulation, and rotational deformity are indications for surgical treatment. Various forms of treatment with advantages and disadvantages have been documented. The purpose of the study was to determine the stability of fracture fixation with intramedullary headless compression screws in two types of metacarpal shaft fractures and compare them to other common forms of rigid fixation: dorsal plating and lag screw fixation. It was hypothesized that headless compression screws would demonstrate a biomechanical stronger construct. Methods: Five matched paired hands (age 60.9 ± 4.6 years), utilizing non-thumb metacarpals, were used for comparative fixation in two fracture types created by an osteotomy. In transverse diaphyseal fractures, fixation by headless compression screws (n = 7) and plating (n = 8) were compared. In long oblique diaphyseal fractures, headless compression screws (n = 8) were compared with plating (n = 8) and lag screws (n = 7). Testing was performed using an MTS frame producing an apex dorsal, three point bending force. Peak load to failure and stiffness were calculated from the load-displacement curve generated. Results: For transverse fractures, headless compression screws had a significantly higher stiffness and peak load to failure, means 249.4 N/mm and 584.8 N, than plates, means 129.02 N/mm and 303.9 N (both p < 0.001). For long oblique fractures, stiffness and peak load to failure for headless compression screws were means 209 N/mm and 758.4 N, for plates 258.7 N/mm and 518.5 N, and for lag screws 172.18 N/mm and 234.11 N. There was significance in peak load to failure for headless compression screws vs plates (p = 0.023), headless compression screws vs lag screws (p < 0.001), and plates vs lag screws (p = 0.009). There was no significant difference in stiffness between groups. Conclusion: Intramedullary fixation of diaphyseal metacarpal fractures with a headless compression screw provides excellent biomechanical stability. Coupled with lower risks for adverse effects, headless compression screws may be a preferable option for those requiring rapid return to sport or work. Level of evidence: Basic Science Study, Biomechanics.


  • Anterior shoulder instability

    by J. Christoph Katthagen, Felix Dyrna, Benedikt Schliemann

  • Open Access

    Labral lesions in first-time traumatic anterior shoulder dislocation: it’s more than just Bankart …

    by B. Schliemann, F. Dyrna, V. Kravchenko, M. J. Raschke, J. C. Katthagen

    Introduction: Traumatic anterior shoulder dislocation occurs frequently and usually affects young, active male patients. Detachment of the anteroinferior labrum, known as the Bankart lesion, is a common result. However, more extensive entities including bony lesions and disruptions of the labral ring can also be found. The aim of the present work was to analyze all cases of first-time traumatic anterior shoulder dislocation at a level‑1 trauma center with regard to the type of labral lesion. Focus was placed on the frequency and distribution of complex lesions and the extent of the surgical repair.Patients and methods: The clinical database of a level‑1 trauma center with a specialized shoulder unit was searched to identify all patients with first-time anterior shoulder dislocation treated between 2015 and 2019. Of 224 patients, 110 underwent primary surgical repair after first-time dislocation (mean age 40 years).Results: A total of 62% of patients had only a soft tissue injury, while 38% (n = 40) showed a bony Bankart lesion/fracture of the glenoid fossa with a mean defect size of 26%. In only 31% of patients (n = 34), a classicBankart repair was performed, whereas the remaining 69% underwent additional procedures.Conclusion: In this series of surgically treated first-time traumatic anterior shoulder dislocations, the majority of cases presented with more complex lesions than an isolated classic Bankart lesion. The risk for bony involvement and associated pathologies, such as cuff tears and greater tuberosity fracture, increases with age and requires a more extensive surgical approach. Disruption of the labral ring was frequently found in both soft tissue and bony lesions and directly affected the surgical procedure.