Sanjeev Kumar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sanjeev Kumar has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Ajay Batish
2 shared publications- Rupinder Singh
Mechanical Engineering Department, National Institute of Technical Teachers Training and Research, Chandigarh, India
2 shared publications - Tejinder Paul Singh
Symbiosis Institute of Technology, Pune, India
2 shared publications Rajdeep Singh
Chandigarh Engineering College
1 shared publication
Latest Publications
- 26 September 2016
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 39 (7) , 2635-2648
Investigating surface properties of cryogenically treated titanium alloys in powder mixed electric discharge machining
- 26 September 2016
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 39 (7) , 2635-2648
Investigating surface properties of cryogenically treated titanium alloys in powder mixed electric discharge machining
- 24 January 2016
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 231 (11) , 2017-2024
Machining performance of cryogenically treated Ti–5Al–2.5Sn titanium alloy in electric discharge machining: A comparative study
In the present study, the effect of cryogenic treatment on the machining performance of Ti–5Al–2.5Sn alpha titanium alloy was investigated during electric discharge machining. Untreated, shallow cryogenically treated (−110 ℃), and deep cryogenically treated (−184 ℃) titanium alloys were machined by varying current and pulse-on-time. The machining performance was measured in terms of higher material removal rate and microhardness and low tool wear rate and surface roughness. The results showed a significant improvement in the machining performance with deep cryogenically treated alloy when compared with shallow and untreated alloy. Current and pulse-on-time also affected the machinability of titanium alloy. Higher material removal rate and microhardness were observed when titanium alloy was machined at high current and pulse-on-time. During machining, carbon was deposited on the machined surface due to the breakdown of hydrocarbon dielectric at high temperature thereby, affecting its properties.
- 24 January 2016
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 231 (11) , 2017-2024
Machining performance of cryogenically treated Ti–5Al–2.5Sn titanium alloy in electric discharge machining: A comparative study
In the present study, the effect of cryogenic treatment on the machining performance of Ti–5Al–2.5Sn alpha titanium alloy was investigated during electric discharge machining. Untreated, shallow cryogenically treated (−110 ℃), and deep cryogenically treated (−184 ℃) titanium alloys were machined by varying current and pulse-on-time. The machining performance was measured in terms of higher material removal rate and microhardness and low tool wear rate and surface roughness. The results showed a significant improvement in the machining performance with deep cryogenically treated alloy when compared with shallow and untreated alloy. Current and pulse-on-time also affected the machinability of titanium alloy. Higher material removal rate and microhardness were observed when titanium alloy was machined at high current and pulse-on-time. During machining, carbon was deposited on the machined surface due to the breakdown of hydrocarbon dielectric at high temperature thereby, affecting its properties.