Mogens H. Greve
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mogens H. Greve has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Barry J. Allred
USDA/ARS Soil Drainage Research Unit, 590 Woody Hayes Drive, Columbus, OH 43210, USA
1 shared publication - Bo Vangsø Iversen
Department of Agroecology Aarhus University Tjele Denmark
1 shared publication - Ellen Van De Vijver
Department of Geology, Ghent University, Krijgslaan 281-S8, 9000 Ghent, Belgium
1 shared publication - Jørgen Ringgaard
Rambøll, Hannemanns Allé 53, 2300 Copenhagen, Denmark
1 shared publication - Kabindra Adhikari
USDA‐ARS Grassland Soil and Water Research Laboratory Temple Texas USA
1 shared publication - Maria Knadel
Department of Agroecology, Faculty of Science and Technology, Aarhus University, Blichers Allé 20, P.O. Box 50, DK-8830 Tjele, Denmark
1 shared publication
Latest Publications
- Open Access
Mapping of Agricultural Subsurface Drainage Systems Using a Frequency-Domain Ground Penetrating Radar and Evaluating Its Performance Using a Single-Frequency Multi-Receiver Electromagnetic Induction Instrument
Subsurface drainage systems are commonly used to remove surplus water from the soil profile of a poorly drained farmland. Traditional methods for drainage mapping involve the use of tile probes and trenching equipment that are time-consuming, labor-intensive, and invasive, thereby entailing an inherent risk of damaging the drainpipes. Effective and efficient methods are needed in order to map the buried drain lines: (1) to comprehend the processes of leaching and offsite release of nutrients and pesticides and (2) for the installation of a new set of drain lines between the old ones to enhance the soil water removal. Non-invasive geophysical soil sensors provide a potential alternative solution. Previous research has mainly showcased the use of time-domain ground penetrating radar, with variable success, depending on local soil and hydrological conditions and the central frequency of the specific equipment used. The objectives of this study were: (1) to test the use of a stepped-frequency continuous wave three-dimensional ground penetrating radar (3D-GPR) with a wide antenna array for subsurface drainage mapping and (2) to evaluate its performance with the use of a single-frequency multi-receiver electromagnetic induction (EMI) sensor in-combination. This sensor combination was evaluated on twelve different study sites with various soil types with textures ranging from sand to clay till. While the 3D-GPR showed a high success rate in finding the drainpipes at five sites (sandy, sandy loam, loamy sand, and organic topsoils), the results at the other seven sites were less successful due to the limited penetration depth of the 3D-GPR signal. The results suggest that the electrical conductivity estimates produced by the inversion of apparent electrical conductivity data measured by the EMI sensor could be a useful proxy for explaining the success achieved by the 3D-GPR in finding the drain lines.
Open AccessMapping of Agricultural Subsurface Drainage Systems Using a Frequency-Domain Ground Penetrating Radar and Evaluating Its Performance Using a Single-Frequency Multi-Receiver Electromagnetic Induction Instrument
Subsurface drainage systems are commonly used to remove surplus water from the soil profile of a poorly drained farmland. Traditional methods for drainage mapping involve the use of tile probes and trenching equipment that are time-consuming, labor-intensive, and invasive, thereby entailing an inherent risk of damaging the drainpipes. Effective and efficient methods are needed in order to map the buried drain lines: (1) to comprehend the processes of leaching and offsite release of nutrients and pesticides and (2) for the installation of a new set of drain lines between the old ones to enhance the soil water removal. Non-invasive geophysical soil sensors provide a potential alternative solution. Previous research has mainly showcased the use of time-domain ground penetrating radar, with variable success, depending on local soil and hydrological conditions and the central frequency of the specific equipment used. The objectives of this study were: (1) to test the use of a stepped-frequency continuous wave three-dimensional ground penetrating radar (3D-GPR) with a wide antenna array for subsurface drainage mapping and (2) to evaluate its performance with the use of a single-frequency multi-receiver electromagnetic induction (EMI) sensor in-combination. This sensor combination was evaluated on twelve different study sites with various soil types with textures ranging from sand to clay till. While the 3D-GPR showed a high success rate in finding the drainpipes at five sites (sandy, sandy loam, loamy sand, and organic topsoils), the results at the other seven sites were less successful due to the limited penetration depth of the 3D-GPR signal. The results suggest that the electrical conductivity estimates produced by the inversion of apparent electrical conductivity data measured by the EMI sensor could be a useful proxy for explaining the success achieved by the 3D-GPR in finding the drain lines.
- Open Access
- 9 December 2016
- Published by MDPI AG in Remote Sensing
- Vol. 8 (12) , 1003
Digital Mapping of Toxic Metals in Qatari Soils Using Remote Sensing and Ancillary Data
After decades of mining and industrialization in Qatar, it is important to estimate their impact on soil pollution with toxic metals. The study utilized 300 topsoil (0–30 cm) samples, multi-spectral images (Landsat 8), spectral indices and environmental variables to model and map the spatial distribution of arsenic (As), chromium (Cr), nickel (Ni), copper (Cu), lead (Pb) and zinc (Zn) in Qatari soils. The prediction model used condition-based rules generated in the Cubist tool. In terms of R2 and the ratio of performance to interquartile distance (RPIQ), the models showed good predictive capabilities for all elements. Of all of the prediction results, Cu had the highest R2 = 0.74, followed by As > Pb > Cr > Zn > Ni. This study found that all of the models only chose images from January and February as predictors, which indicates that images from these two months are important for soil toxic metals’ monitoring in arid soils, due to the climate and the vegetation cover during this season. Topsoil maps of the six toxic metals were generated. The maps can be used to prioritize the choice of remediation measures and can be applied to other arid areas of similar environmental/socio-economic conditions and pollution causes.
- 9 December 2016
- Published by MDPI AG in Remote Sensing
- Vol. 8 (12) , 1003
Open AccessDigital Mapping of Toxic Metals in Qatari Soils Using Remote Sensing and Ancillary Data
After decades of mining and industrialization in Qatar, it is important to estimate their impact on soil pollution with toxic metals. The study utilized 300 topsoil (0–30 cm) samples, multi-spectral images (Landsat 8), spectral indices and environmental variables to model and map the spatial distribution of arsenic (As), chromium (Cr), nickel (Ni), copper (Cu), lead (Pb) and zinc (Zn) in Qatari soils. The prediction model used condition-based rules generated in the Cubist tool. In terms of R2 and the ratio of performance to interquartile distance (RPIQ), the models showed good predictive capabilities for all elements. Of all of the prediction results, Cu had the highest R2 = 0.74, followed by As > Pb > Cr > Zn > Ni. This study found that all of the models only chose images from January and February as predictors, which indicates that images from these two months are important for soil toxic metals’ monitoring in arid soils, due to the climate and the vegetation cover during this season. Topsoil maps of the six toxic metals were generated. The maps can be used to prioritize the choice of remediation measures and can be applied to other arid areas of similar environmental/socio-economic conditions and pollution causes.