Patricia K. Lebow
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Patricia K. Lebow has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Stan T. Lebow
Department of Agriculture Forest Service Forest Products Laboratory Research United States
4 shared publications - Steven A. Halverson2 shared publications
- A. B. Bishell
USDA-FS Forest Products Laboratory, One Gifford Pinchot Dr., Madison, WI 53726 (;;) and
1 shared publication - Bessie M. Woodward
Department of Agriculture Forest Service Forest Products Laboratory Research United States
1 shared publication - Grant T. Kirker
USDA-FS Forest Products Laboratory, Madison, WI 53726, USA
1 shared publication - Henry Spelter
Department of Agriculture Forest Service Forest Products Laboratory Research United States
1 shared publication
Latest Publications
- 23 January 2019
- Published by Society of Wood Science and Technology in Wood and Fiber Science
- Vol. 51 (1) , 74-87
Laboratory Immersion Method for Accelerated Prediction of Preservative Leaching from Pressure-Treated Wood Exposed to Precipitation
Laboratory Immersion Method for Accelerated Prediction of Preservative Leaching from Pressure-Treated Wood Exposed to Precipitation
- 23 January 2019
- Published by Society of Wood Science and Technology in Wood and Fiber Science
- Vol. 51 (1) , 74-87
Laboratory Immersion Method for Accelerated Prediction of Preservative Leaching from Pressure-Treated Wood Exposed to Precipitation
Laboratory Immersion Method for Accelerated Prediction of Preservative Leaching from Pressure-Treated Wood Exposed to Precipitation
- 22 October 2015
- Published by Oxford University Press (OUP) in Journal of Economic Entomology
- Vol. 109 (1) , 259-266
Laboratory Evaluations of Durability of Southern Pine Pressure Treated With Extractives From Durable Wood Species
Extracts from sawdust of four naturally durable wood species [Alaskan yellow cedar, AYC, Cupressus nootkanansis D. Don 1824; eastern red cedar, ERC, Juniperus virginiana L.; honey mesquite, HM, Prosopis glandulosa Torr.; and black locust, BL, Robinia pseudoacacia L.] were used to treat southern pine, Pt, Pinus taeda L. sapwood blocks. Extractive treated blocks were evaluated for decay resistance in standard soil bottle fungal assays challenged with brown and white rot decay fungi. Results showed that extractives did impart some improvement to decay resistance of Pt blocks. BL- and HM-treated Pt blocks were also used in choice and no-choice assays to determine feeding preference and damage by eastern subterranean termites (Reticulitermes flavipes) Kollar. Minimal feeding on treated blocks was seen in both choice and no-choice assays. In choice assays, there was similar mortality between HM and BL arenas; however, in no-choice assays, complete mortality was recorded for HM-treated Pt and high mortality was seen with BL-treated Pt. Subsequent dose mortality termite assays showed HM to be effective in killing R. flavipes at low concentrations. Both HM and BL show promise as deterrents or termiticidal protectants and will be further evaluated in field studies.
- 22 October 2015
- Published by Oxford University Press (OUP) in Journal of Economic Entomology
- Vol. 109 (1) , 259-266
Laboratory Evaluations of Durability of Southern Pine Pressure Treated With Extractives From Durable Wood Species
Extracts from sawdust of four naturally durable wood species [Alaskan yellow cedar, AYC, Cupressus nootkanansis D. Don 1824; eastern red cedar, ERC, Juniperus virginiana L.; honey mesquite, HM, Prosopis glandulosa Torr.; and black locust, BL, Robinia pseudoacacia L.] were used to treat southern pine, Pt, Pinus taeda L. sapwood blocks. Extractive treated blocks were evaluated for decay resistance in standard soil bottle fungal assays challenged with brown and white rot decay fungi. Results showed that extractives did impart some improvement to decay resistance of Pt blocks. BL- and HM-treated Pt blocks were also used in choice and no-choice assays to determine feeding preference and damage by eastern subterranean termites (Reticulitermes flavipes) Kollar. Minimal feeding on treated blocks was seen in both choice and no-choice assays. In choice assays, there was similar mortality between HM and BL arenas; however, in no-choice assays, complete mortality was recorded for HM-treated Pt and high mortality was seen with BL-treated Pt. Subsequent dose mortality termite assays showed HM to be effective in killing R. flavipes at low concentrations. Both HM and BL show promise as deterrents or termiticidal protectants and will be further evaluated in field studies.
- 1 January 2010
- Published by Forest Products Society in Forest Products Journal
- Vol. 60 (1) , 13-22
Penetration of Boron from Topically Applied Borate Solutions
Borate penetration relies on diffusion when borate and glycol-borate preservatives are applied to the surface of wood. This study evaluated the extent of borate penetration in framing lumber as a function of preservative formulation, wood moisture content, and diffusion time after treatment. In Phase I of the study, end-matched specimens were conditioned to target average moisture contents of 15, 25, or 35 percent, briefly immersed in borate formulations, and then placed into wooden frames to minimize air exchange during diffusion. Penetration in these specimens was generally less than 5 mm (or 35% of the cross section) regardless of treatment solution, target moisture content at time of treatment, or diffusion period (2, 4, or 8 wk). Assay of boron concentrations after 8 weeks of diffusion also indicated that the boron was concentrated in the outer 5 mm of the wood. Diffusion appeared to have been limited by the relatively rapid drying of the specimens, even with the restricted air movement within the wooden frames. In Phase II of the study, specimens were conditioned to a target average moisture content of 20 percent prior to dip immersion and then placed in a room that maintained an equilibrium moisture content of 19 to 21 percent. Penetration in these specimens was assessed after 6, 13, and 26 weeks of diffusion. After 6 weeks of diffusion, average boron penetration exceeded 5 mm, and after 26 weeks of diffusion, penetration exceeded 11 mm, or over 70 percent of the cross section. Little difference in diffusion was observed between the types of borate formulations evaluated in either phase of this study. The results of this study indicate that rapid drying conditions may limit penetration of boron from spray applications; however, in situations where high humidity is maintained in a structure, substantial diffusion is possible.
- 1 January 2010
- Published by Forest Products Society in Forest Products Journal
- Vol. 60 (1) , 13-22
Penetration of Boron from Topically Applied Borate Solutions
Borate penetration relies on diffusion when borate and glycol-borate preservatives are applied to the surface of wood. This study evaluated the extent of borate penetration in framing lumber as a function of preservative formulation, wood moisture content, and diffusion time after treatment. In Phase I of the study, end-matched specimens were conditioned to target average moisture contents of 15, 25, or 35 percent, briefly immersed in borate formulations, and then placed into wooden frames to minimize air exchange during diffusion. Penetration in these specimens was generally less than 5 mm (or 35% of the cross section) regardless of treatment solution, target moisture content at time of treatment, or diffusion period (2, 4, or 8 wk). Assay of boron concentrations after 8 weeks of diffusion also indicated that the boron was concentrated in the outer 5 mm of the wood. Diffusion appeared to have been limited by the relatively rapid drying of the specimens, even with the restricted air movement within the wooden frames. In Phase II of the study, specimens were conditioned to a target average moisture content of 20 percent prior to dip immersion and then placed in a room that maintained an equilibrium moisture content of 19 to 21 percent. Penetration in these specimens was assessed after 6, 13, and 26 weeks of diffusion. After 6 weeks of diffusion, average boron penetration exceeded 5 mm, and after 26 weeks of diffusion, penetration exceeded 11 mm, or over 70 percent of the cross section. Little difference in diffusion was observed between the types of borate formulations evaluated in either phase of this study. The results of this study indicate that rapid drying conditions may limit penetration of boron from spray applications; however, in situations where high humidity is maintained in a structure, substantial diffusion is possible.
- 1 January 2009
- Published by USDA Forest Service
- Vol. 655, 1-11
Efficacy of a borax-copper preservative in exposed applications
- 1 January 2009
- Published by USDA Forest Service
- Vol. 655, 1-11
Efficacy of a borax-copper preservative in exposed applications
- 1 January 2004
- Published by USDA Forest Service
- Vol. 620
Variability in evaluating environmental impacts of treated wood.
Preservative-treated wood contains components that may be toxic to non-target organisms if released into the environment in sufficient quantities. Numerous studies have been conducted to determine the rate of preservative release from treated wood and/or the extent of their subsequent accumulation in the environment. These studies have produced a wide range of results, with a corresponding range of interpretations and recommendations. This paper reviews research on wood preservative leaching and environmental accumulation and discusses sources of the variability in research findings. Variables such as wood properties, pressure treatment techniques, construction practices, exposure conditions, and site conditions are discussed.
- 1 January 2004
- Published by USDA Forest Service
- Vol. 620
Variability in evaluating environmental impacts of treated wood.
Preservative-treated wood contains components that may be toxic to non-target organisms if released into the environment in sufficient quantities. Numerous studies have been conducted to determine the rate of preservative release from treated wood and/or the extent of their subsequent accumulation in the environment. These studies have produced a wide range of results, with a corresponding range of interpretations and recommendations. This paper reviews research on wood preservative leaching and environmental accumulation and discusses sources of the variability in research findings. Variables such as wood properties, pressure treatment techniques, construction practices, exposure conditions, and site conditions are discussed.
- Open Access
- 1 January 2003
- Published by USDA Forest Service
- Vol. 614
FPL-PELPS : a price endogenous linear programming system for economic modeling, supplement to PELPS III, version 1.1.
- 1 January 2003
- Published by USDA Forest Service
- Vol. 614
Open AccessFPL-PELPS : a price endogenous linear programming system for economic modeling, supplement to PELPS III, version 1.1.
- Open Access
- 1 January 2001
- Published by USDA Forest Service
- Vol. 128
Derivation of nominal strength for wood utility poles
- 1 January 2001
- Published by USDA Forest Service
- Vol. 128
Open AccessDerivation of nominal strength for wood utility poles