Canato Matteo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Canato Matteo has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
Collivignarelli Maria Cristina
Department of Civil Engineering and Architecture (DICar), University of Pavia, via Ferrata, 1, 27100 Pavia, PV, Italy
1 shared publicationCrotti Barbara Marianna
ASMia s.r.l, via Vecellio, 540, 27036 Mortara, PV, Italy
1 shared publication- Sabrina Sorlini
Department of Civil, Environmental, Architectural Engineering and Mathematics, University of Brescia, via Branze 43, 25123 Brescia, Italy
1 shared publication
Latest Publications
- 1 December 2016
- Published by IWA Publishing in Water Practice & Technology
- Vol. 11 (4) , 702-711
Monitoring of a pilot GFO filter for removal of low-concentration arsenic in water
Many water treatment plants (WTPs) were designed to remove ammonia, iron, and manganese simultaneously using biofilters. In some cases (especially in the Pianura Padana area, in Italy) such plants were designed without a specific treatment stage for arsenic removal because its concentration in the groundwater (i.e. 10 to 20 μg/L) was lower than the previous maximum contaminant level (MCL) of 50 μg-As/L; therefore, specific treatments for arsenic removal must be introduced or upgraded in WTPs. In this work, the results of a 19-month monitoring campaign are reported for a pilot granular ferric oxide (GFO) filter installed in an Italian WTP as a polishing stage. The aim was to investigate the performance of GFO with low arsenic concentrations. The results show that, if the groundwater arsenic concentration is close to the MCL, GFO treatment can be cost effective (approximately 80,000 bed volumes have been treated). It was confirmed that GFO can be effective for the removal of both As(III) and As(V) species.
- 1 December 2016
- Published by IWA Publishing in Water Practice & Technology
- Vol. 11 (4) , 702-711
Monitoring of a pilot GFO filter for removal of low-concentration arsenic in water
Many water treatment plants (WTPs) were designed to remove ammonia, iron, and manganese simultaneously using biofilters. In some cases (especially in the Pianura Padana area, in Italy) such plants were designed without a specific treatment stage for arsenic removal because its concentration in the groundwater (i.e. 10 to 20 μg/L) was lower than the previous maximum contaminant level (MCL) of 50 μg-As/L; therefore, specific treatments for arsenic removal must be introduced or upgraded in WTPs. In this work, the results of a 19-month monitoring campaign are reported for a pilot granular ferric oxide (GFO) filter installed in an Italian WTP as a polishing stage. The aim was to investigate the performance of GFO with low arsenic concentrations. The results show that, if the groundwater arsenic concentration is close to the MCL, GFO treatment can be cost effective (approximately 80,000 bed volumes have been treated). It was confirmed that GFO can be effective for the removal of both As(III) and As(V) species.