SKSotirios G. Kokosis

Sotirios G. Kokosis

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Sotirios G. Kokosis has a total of 7 co-authors. Here are the top co-authors by number of shared publications:

  • Eleni Gati

    School of Electrical and Computer Engineers, National Technical University of Athens, 9, Iroon Polytechniou St, 15780 Zografou, Greece

    1 shared publication
  • Georgios E. Kampitsis

    Power Electronics Laboratory, National Technical University of Athens, Zografou, Greece

    1 shared publication
  • Ioannis E. Andreadis

    Power Electronics Laboratory, National Technical University of Athens, Zografou, Greece

    1 shared publication
  • Nikolaos Patsourakis

    School of Electrical and Computer Engineers, National Technical University of Athens, 9, Iroon Polytechniou St, 15780 Zografou, Greece

    1 shared publication
  • Pavlos Pachos

    Power Electronics Laboratory, National Technical University of Athens, Zografou, Greece

    1 shared publication
  • Stefanos Manias

    Power Electronics Laboratory, National Technical University of Athens, Zografou, Greece

    1 shared publication

Latest Publications

  • Open Access

    Comparison of Series Compensation Topologies for Inductive Chargers of Biomedical Implantable Devices

    by Eleni Gati, Sotirios Kokosis, Nikolaos Patsourakis, Stefanos Manias

    Modern biomedical implantable devices provide an increasingly popular solution for health monitoring and medical issues. Their level of development in the coming years will depend on their reliability and endurance. Their powering and recharging capabilities are key factors for their dominance. In this work, series compensation topologies for use in inductive chargers of biomedical implantable devices are investigated with regard to their performance. The goal is to assess the possibility of reducing the component count of the implantable device and thus, increase its reliability and patient safety. Comparison is performed between the commonly used series-series compensation topology with a topology which incorporates no capacitors in the secondary side but only series compensation in the primary. Extensive investigation of the operation of the two topologies is made through mathematical analysis, simulations, and experimental evaluation, for the most popular schemes of operation, with regard to frequency selection. A prototype inductive charger, including a custom-made inductive link, was designed and built for the experimental evaluation of the system. Insights on the operation of both topologies are provided and the results show that primary-side series compensation can be a strong alternative to series-series compensation, in biomedical applications.


  • Forced Current Balancing of Parallel-Connected SiC JFETs During Forward and Reverse Conduction Mode

    by Sotirios G. Kokosis, Ioannis E. Andreadis, Georgios E. Kampitsis, Pavlos Pachos, Stefanos Manias

    In this paper, a thorough investigation on the parallel connection of the latest generation vertical trench silicon carbide (SiC) junction field-effect transistors (JFETs) during forward and reverse conduction is performed. Both enhancement and depletion mode SiC JFETs are examined, regarding their static and dynamic characteristics. A parametric analysis on the current sharing, reliability, and effectiveness of the parallel connection is carried out. Current asymmetry over the different JFETs is monitored via series-connected current transformers. A forced current balancing technique during forward conduction mode is achieved by controlling the time delay of the gate signal through a low-cost digital signal controller. The drain current mismatch during reverse conduction is also studied and addressed by applying similar techniques as in the forward conduction, or by adding an antiparallel power diode. The performance of paralleled JFETs is validated through simulation and experimental results at room temperature and 150 °C.