Xavier Frédéric Le Goff
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Interests
Xavier Frédéric Le Goff has a total of 273 co-authors. Here are the top co-authors by number of shared publications:
Pascal Le Floch
Laboratoire de Hétéroéléments et Coordination, Ecole polytechnique, UMR7653 CNRS, 91128 Palaiseau Cedex, France
18 shared publicationsLouis Ricard
LCM, CNRS, Ecole polytechnique, Université Paris-Saclay, 91128 Palaiseau, France
14 shared publicationsAudrey Auffrant
Laboratoire Hétéroéléments et Coordination, Ecole Polytechnique, CNRS, 9118 Palaiseau, France
9 shared publications- Antoine Buchard
Green Chemistry Centre of Excellence, Department of Chemistry, University of York, YO10 5DD York, UK
8 shared publications Nicolas Mézailles
Laboratoire Hétéroéléments et Coordination, Ecole Polytechnique, CNRS, Route de Saclay, 91120 Palaiseau, France
8 shared publications- Nicolas Mézailles
Laboratoire Hétéroéléments et Coordination, Ecole Polytechnique, CNRS, 91128 Palaiseau cedex, France
8 shared publications
Latest Publications
- 1 January 2027
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 34 (1)
A custom-designed heated sample holder for in situ synchrotron small-angle X-ray scattering of radioactive solutions
A dedicated heated sample holder has been developed for the temperature-dependent characterization of radioactive solutions using small-angle X-ray scattering (SAXS). The sample holder features dual containment and was designed to meet radiological safety requirements, as well as the technical and analytical specifications of the MARS beamline at Synchrotron SOLEIL. The development of the sample holder and the selection of its components involved detailed heat-transfer simulations to assess its thermal stability, temperature homogeneity, and operational safety below 100°C. Preliminary characterization and functional tests of the heating module demonstrated the robustness and reliability of the device over the targeted temperature range. The system was subsequently validated under operational conditions at the MARS beamline by studying the forced hydrolysis of a Ce(IV) aqueous solution as a non-radioactive plutonium surrogate. The SAXS data acquired during the experiment were of high quality and consistent with reference data from the literature, thereby demonstrating the suitability of the sample holder for in situ temperature-controlled SAXS measurements of radioactive liquid systems. Beyond this validation, the device provides a platform for future investigations involving actinide systems requiring stringent radiological protection constraints at synchrotron facilities.
- 1 January 2027
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 34 (1)
A custom-designed heated sample holder for in situ synchrotron small-angle X-ray scattering of radioactive solutions
A dedicated heated sample holder has been developed for the temperature-dependent characterization of radioactive solutions using small-angle X-ray scattering (SAXS). The sample holder features dual containment and was designed to meet radiological safety requirements, as well as the technical and analytical specifications of the MARS beamline at Synchrotron SOLEIL. The development of the sample holder and the selection of its components involved detailed heat-transfer simulations to assess its thermal stability, temperature homogeneity, and operational safety below 100°C. Preliminary characterization and functional tests of the heating module demonstrated the robustness and reliability of the device over the targeted temperature range. The system was subsequently validated under operational conditions at the MARS beamline by studying the forced hydrolysis of a Ce(IV) aqueous solution as a non-radioactive plutonium surrogate. The SAXS data acquired during the experiment were of high quality and consistent with reference data from the literature, thereby demonstrating the suitability of the sample holder for in situ temperature-controlled SAXS measurements of radioactive liquid systems. Beyond this validation, the device provides a platform for future investigations involving actinide systems requiring stringent radiological protection constraints at synchrotron facilities.
- Open Access
- 22 June 2026
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 55 (26) , 9889-9908
Revisiting synthesis of pure chernobylite solid solutions for thermal stability investigations
A multiparametric study was developed to optimize the hydrothermal synthesis of chernobylite solid solutions (Zr1-xUxSiO4), a technogenic mineral first discovered in the melted core of the Chernobyl nuclear power plant following the 1986 nuclear accident. The goal was to obtain phase-pure samples for thermodynamic investigation. Optimal synthesis conditions were determined starting from uranium(IV) and zirconium(IV) chloride precursors, using a hydrothermal treatment for seven days at 250°C with a reaction medium maintained within a pH range of 1.4 to 1.8, which minimized the formation of secondary phases Under these conditions, solid solutions of chernobylite were synthesized up to x = 0.60. However, the systematic presence of residual oxide phases in the samples required the development of a purification process involving alternating leaching steps in basic and nitric media. This process removed amorphous silica and selectively dissolved residual oxide phases, respectively. This protocol yielded purified Zr1-xUxSiO4 samples over a wide range of compositions (x ≤ 0.6). The resulting powders consisted of spherical agglomerates of approximately 300 µm in diameter, with specific surface areas ranging from 19 to 22 m2.g-1. Finally, the thermal stability of the chernobylite solid solutions was evaluated using heat treatments between 1000°C and 1300°C. All samples, except for those most enriched in uranium, proved to be thermally stable even at the highest temperatures.
- 22 June 2026
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 55 (26) , 9889-9908
Open AccessRevisiting synthesis of pure chernobylite solid solutions for thermal stability investigations
A multiparametric study was developed to optimize the hydrothermal synthesis of chernobylite solid solutions (Zr1-xUxSiO4), a technogenic mineral first discovered in the melted core of the Chernobyl nuclear power plant following the 1986 nuclear accident. The goal was to obtain phase-pure samples for thermodynamic investigation. Optimal synthesis conditions were determined starting from uranium(IV) and zirconium(IV) chloride precursors, using a hydrothermal treatment for seven days at 250°C with a reaction medium maintained within a pH range of 1.4 to 1.8, which minimized the formation of secondary phases Under these conditions, solid solutions of chernobylite were synthesized up to x = 0.60. However, the systematic presence of residual oxide phases in the samples required the development of a purification process involving alternating leaching steps in basic and nitric media. This process removed amorphous silica and selectively dissolved residual oxide phases, respectively. This protocol yielded purified Zr1-xUxSiO4 samples over a wide range of compositions (x ≤ 0.6). The resulting powders consisted of spherical agglomerates of approximately 300 µm in diameter, with specific surface areas ranging from 19 to 22 m2.g-1. Finally, the thermal stability of the chernobylite solid solutions was evaluated using heat treatments between 1000°C and 1300°C. All samples, except for those most enriched in uranium, proved to be thermally stable even at the highest temperatures.
- Open Access
- 9 March 2026
- Published by Elsevier in Computational Materials Science
- Vol. 268
A deep-learning approach to grain boundary detection in backscattered electron images
- 9 March 2026
- Published by Elsevier in Computational Materials Science
- Vol. 268
Open AccessA deep-learning approach to grain boundary detection in backscattered electron images
- Open Access
- 25 July 2024
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 53 (33) , 13782-13794
Hydrothermal synthesis of (Zr,U)SiO4: an efficient pathway to incorporate uranium into zircon
For the first time, conditions allowing the formation of (Zr,U)SiO4 solid solution with uranium content up to 60 mol% have been determined through the hydrothermal synthesis pathway.
- 25 July 2024
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 53 (33) , 13782-13794
Open AccessHydrothermal synthesis of (Zr,U)SiO4: an efficient pathway to incorporate uranium into zircon
For the first time, conditions allowing the formation of (Zr,U)SiO4 solid solution with uranium content up to 60 mol% have been determined through the hydrothermal synthesis pathway.
- 13 July 2023
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 52 (31) , 10951-10968
Hydrothermal conversion of mixed uranium( iv )–cerium( iii ) oxalates into U 1− x Ce x O 2+ δ · n H 2 O solid solutions
Hydrothermal conversion of U( iv )–Ce( iii ) oxalates allows the quantitative synthesis of morphology-tunable solid solutions of (U,Ce)O 2± δ . Such a process appears to be a credible alternative route for the synthesis of MOx nuclear fuel.
- 13 July 2023
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 52 (31) , 10951-10968
Hydrothermal conversion of mixed uranium( iv )–cerium( iii ) oxalates into U 1− x Ce x O 2+ δ · n H 2 O solid solutions
Hydrothermal conversion of U( iv )–Ce( iii ) oxalates allows the quantitative synthesis of morphology-tunable solid solutions of (U,Ce)O 2± δ . Such a process appears to be a credible alternative route for the synthesis of MOx nuclear fuel.
- 12 January 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (12) , 4016-4021
Tuning the Regioselective Functionalization of Trifluoromethylated Dienes via Lanthanum‐Mediated Single C−F Bond Activation
The development of new fluorine‐containing building blocks and their efficient synthetic access is currently a challenging research field. Herein, the highly regio‐ and stereoselective addition of a large range of aldehydes onto trifluoromethylated benzofulvenes was achieved using a simple La/I2/DIBAL‐Cl system via a selective C−F bond activation process. This versatile methodology provided homodienyl alcohols bearing a terminal CF2‐alkene with potential further applications, as shown by the dehydration to the first benzofulvenes carrying a difluorovinyl group. In addition, for certain electron‐poor aldehydes, unprecedented ipso substitution of the CF3 group in a diene was observed, which, according to DFT studies, is related to the presence of the large, Lewis‐acidic lanthanum metal.
- 12 January 2021
- Published by Wiley in Chemistry – A European Journal
- Vol. 27 (12) , 4016-4021
Tuning the Regioselective Functionalization of Trifluoromethylated Dienes via Lanthanum‐Mediated Single C−F Bond Activation
The development of new fluorine‐containing building blocks and their efficient synthetic access is currently a challenging research field. Herein, the highly regio‐ and stereoselective addition of a large range of aldehydes onto trifluoromethylated benzofulvenes was achieved using a simple La/I2/DIBAL‐Cl system via a selective C−F bond activation process. This versatile methodology provided homodienyl alcohols bearing a terminal CF2‐alkene with potential further applications, as shown by the dehydration to the first benzofulvenes carrying a difluorovinyl group. In addition, for certain electron‐poor aldehydes, unprecedented ipso substitution of the CF3 group in a diene was observed, which, according to DFT studies, is related to the presence of the large, Lewis‐acidic lanthanum metal.
- Open Access
- 27 November 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale Advances
- Vol. 2 (1) , 214-224
Probing the local structure of nanoscale actinide oxides: a comparison between PuO 2 and ThO 2 nanoparticles rules out PuO 2+x hypothesis
XRD, EXAFS and HR-TEM study reveals a strong correlation between AnO 2 (An = Th and Pu) nanoparticle size and An( iv ) local structure.
- 27 November 2019
- Published by Royal Society of Chemistry (RSC) in Nanoscale Advances
- Vol. 2 (1) , 214-224
Open AccessProbing the local structure of nanoscale actinide oxides: a comparison between PuO 2 and ThO 2 nanoparticles rules out PuO 2+x hypothesis
XRD, EXAFS and HR-TEM study reveals a strong correlation between AnO 2 (An = Th and Pu) nanoparticle size and An( iv ) local structure.
- 1 June 2017
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 154, 279-286
Micellization in vegetable oils: A structural characterisation
- 1 June 2017
- Published by Elsevier in Colloids and Surfaces B: Biointerfaces
- Vol. 154, 279-286
Micellization in vegetable oils: A structural characterisation