Guangwei Wang
Guangwei Wang has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Hongzhen Chen
State Key Lab of Silicon Materials, Zhejiang University, Zhejiang, People’s Republic of China
4 shared publicationsSuresh Mulmi
2 shared publications- Venkataraman Thangadurai
EaStCHEM, School of Chemistry, University of St Andrews, North Haugh, St Andrews, KY16 9ST, UK
2 shared publications Zhong Chen
Environmentally-Benign Chemical Process Research Center, Chongqing Institute of Green and Intelligent Technology (CIGIT), Chinese Academy of Sciences, Chongqing, P. R. China
2 shared publications- Fengjun Yin
Chongqing Institute of Green and Intelligent Technology, Chinese Academy of Sciences, Chongqing 400714, China
1 shared publication - HaiFeng Su
Chongqing Institute of Green and Intelligent Technology, Chinese Academy of Sciences, Chongqing, China
1 shared publication
Latest Publications
- 1 November 2021
- Published by Elsevier in Ceramics International
- Vol. 47 (21) , 30483-30503
Synthesis and characterization of calcium double perovskites for the potential application of semiconducting CO2 sensors
- 1 November 2021
- Published by Elsevier in Ceramics International
- Vol. 47 (21) , 30483-30503
Synthesis and characterization of calcium double perovskites for the potential application of semiconducting CO2 sensors
- 23 October 2021
- Published by Springer Nature in Ionics
- Vol. 28 (1) , 463-476
Perovskite-type semiconductors for detecting ppm level of carbon dioxide
- 23 October 2021
- Published by Springer Nature in Ionics
- Vol. 28 (1) , 463-476
Perovskite-type semiconductors for detecting ppm level of carbon dioxide
- 18 August 2020
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 102 (18) , 6329-6338
Oxygen consumption for the combustion of sewage sludge: a potential environmental parameter determined by an electrochemical YSZ oxygen sensor
Oxygen consumption (OC) for the combustion of dried sewage sludge was determined by an equipped YSZ oxygen sensor. Probably due to the good combustion of the sludge, it was not affected by the temperature and oxygen concentration. However, it increased directly proportional to the rise of sludge amount. The mole ratio of OC/TOC agreed well with each entry and almost equalled 1, which indicated the feasibility of directly using OC to assess the organic burden in the wastes. As a result, OC in this study can be potentially applied to replace the chemical oxygen demand (COD) for the evaluation of samples involving solid-containing wastes (e.g., sewage sludge). Additionally, the easy determination of OC also promotes its advantage over COD because of the unavoidable drawbacks for the conventional COD determination.
- 18 August 2020
- Published by Taylor & Francis in International Journal of Environmental Analytical Chemistry
- Vol. 102 (18) , 6329-6338
Oxygen consumption for the combustion of sewage sludge: a potential environmental parameter determined by an electrochemical YSZ oxygen sensor
Oxygen consumption (OC) for the combustion of dried sewage sludge was determined by an equipped YSZ oxygen sensor. Probably due to the good combustion of the sludge, it was not affected by the temperature and oxygen concentration. However, it increased directly proportional to the rise of sludge amount. The mole ratio of OC/TOC agreed well with each entry and almost equalled 1, which indicated the feasibility of directly using OC to assess the organic burden in the wastes. As a result, OC in this study can be potentially applied to replace the chemical oxygen demand (COD) for the evaluation of samples involving solid-containing wastes (e.g., sewage sludge). Additionally, the easy determination of OC also promotes its advantage over COD because of the unavoidable drawbacks for the conventional COD determination.
- Open Access
- 19 December 2016
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 39543
Metabolic engineering of Corynebacterium crenatium for enhancing production of higher alcohols
Biosynthesis approaches for the production of higher alcohols as a source of alternative fossil fuels have garnered increasing interest recently. However, there is little information available in the literature about using undirected whole-cell mutagenesis (UWCM) in vivo to improve higher alcohols production. In this study, for the first time, we approached this question from two aspects: first preferentially improving the capacity of expression host, and subsequently optimizing metabolic pathways using multiple genetic mutations to shift metabolic flux toward the biosynthetic pathway of target products to convert intermediate 2-keto acid compounds into diversified C4~C5 higher alcohols using UWCM in vivo, with the aim of improving the production. The results demonstrated the production of higher alcohols including isobutanol, 2-methyl-1-butanol, 3-methyl-1-butanol from glucose and duckweed under simultaneous saccharification and fermentation (SSF) scheme were higher based on the two aspects compared with only the use of wild-type stain as expression host. These findings showed that the improvement via UWCM in vivo in the two aspects for expression host and metabolic flux can facilitate the increase of higher alcohols production before using gene editing technology. Our work demonstrates that a multi-faceted approach for the engineering of novel synthetic pathways in microorganisms for improving biofuel production is feasible.
- 19 December 2016
- Published by Springer Nature in Scientific Reports
- Vol. 6 (1) , 39543
Open AccessMetabolic engineering of Corynebacterium crenatium for enhancing production of higher alcohols
Biosynthesis approaches for the production of higher alcohols as a source of alternative fossil fuels have garnered increasing interest recently. However, there is little information available in the literature about using undirected whole-cell mutagenesis (UWCM) in vivo to improve higher alcohols production. In this study, for the first time, we approached this question from two aspects: first preferentially improving the capacity of expression host, and subsequently optimizing metabolic pathways using multiple genetic mutations to shift metabolic flux toward the biosynthetic pathway of target products to convert intermediate 2-keto acid compounds into diversified C4~C5 higher alcohols using UWCM in vivo, with the aim of improving the production. The results demonstrated the production of higher alcohols including isobutanol, 2-methyl-1-butanol, 3-methyl-1-butanol from glucose and duckweed under simultaneous saccharification and fermentation (SSF) scheme were higher based on the two aspects compared with only the use of wild-type stain as expression host. These findings showed that the improvement via UWCM in vivo in the two aspects for expression host and metabolic flux can facilitate the increase of higher alcohols production before using gene editing technology. Our work demonstrates that a multi-faceted approach for the engineering of novel synthetic pathways in microorganisms for improving biofuel production is feasible.
- 31 May 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (59) , 54202-54214
Application of red mud as both neutralizer and catalyst in supercritical water oxidation (SCWO) disposal of sewage sludge
Red mud was used in the supercritical water oxidation (SCWO) disposal of sewage sludge, not only as a neutralizer for acidic substances produced in situ, but also as a catalyst for decomposition of pollutants. With initial amounts of 2, 4, 6, and 8% of red mud, the total carbon (TC) value of the solid residue increased from 9.16 mg g−1 to 14.88, 17.91, 20.11, and 26.14 mg g−1, respectively. This resulted from the net increase in the inorganic carbon after capturing and absorption of CO2 produced in situ. The pH of the drained water was correspondingly increased from 5.16 to the range 7.67–7.82. This was mainly determined by the balance in the system of soluble inorganic salts (SIS)–remaining organic substances (RS)–CO2–H2O under certain conditions. However, the pH controlling system switched to SIS–CO2–H2O and RS–CO2–H2O as the operating temperature increased and the residence time increased, respectively. An increase in the TOC removal rate was observed by increasing the amount of red mud, and an outcome in excess of 99.3% could be achieved, although at a relatively low temperature of 400 °C by an initial concentration of 8% red mud. Combined with the rise of TOC removal rate after 2% red mud addition confirmed in the experiments with different operating temperatures and that with different residence time, the catalytic effect of red mud was strongly evidenced. It was probably attributable to the active components in red mud at the primary period, and to the fine-grained calcite that formed in situ, along with tricalcium aluminate, perovskite, hematite, and other inorganic salts at the subsequent period.
- 31 May 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (59) , 54202-54214
Application of red mud as both neutralizer and catalyst in supercritical water oxidation (SCWO) disposal of sewage sludge
Red mud was used in the supercritical water oxidation (SCWO) disposal of sewage sludge, not only as a neutralizer for acidic substances produced in situ, but also as a catalyst for decomposition of pollutants. With initial amounts of 2, 4, 6, and 8% of red mud, the total carbon (TC) value of the solid residue increased from 9.16 mg g−1 to 14.88, 17.91, 20.11, and 26.14 mg g−1, respectively. This resulted from the net increase in the inorganic carbon after capturing and absorption of CO2 produced in situ. The pH of the drained water was correspondingly increased from 5.16 to the range 7.67–7.82. This was mainly determined by the balance in the system of soluble inorganic salts (SIS)–remaining organic substances (RS)–CO2–H2O under certain conditions. However, the pH controlling system switched to SIS–CO2–H2O and RS–CO2–H2O as the operating temperature increased and the residence time increased, respectively. An increase in the TOC removal rate was observed by increasing the amount of red mud, and an outcome in excess of 99.3% could be achieved, although at a relatively low temperature of 400 °C by an initial concentration of 8% red mud. Combined with the rise of TOC removal rate after 2% red mud addition confirmed in the experiments with different operating temperatures and that with different residence time, the catalytic effect of red mud was strongly evidenced. It was probably attributable to the active components in red mud at the primary period, and to the fine-grained calcite that formed in situ, along with tricalcium aluminate, perovskite, hematite, and other inorganic salts at the subsequent period.
- 1 April 2014
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 88, 117-125
Study of transpiring fluid dynamics in supercritical water oxidation using a transparent reactor
- 1 April 2014
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 88, 117-125
Study of transpiring fluid dynamics in supercritical water oxidation using a transparent reactor