Che Wan Zanariah Che Wan Ngah
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Che Wan Zanariah Che Wan Ngah has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
Mohd Adib Yahya
3 shared publications- Zakaria Al-Qodah
Department of Chemical Engineering, Faculty of Engineering Technology, Al-Balqa Applied University, Amman 11134, Jordan
2 shared publications Bambang Kuswandi
Chemo and Biosensors Group, Faculty of Pharmacy, University of Jember, Jl. Kalimantan 37 Jember, East Java, 68121, Indonesia
1 shared publication- Ellisah Hamdan1 shared publication
Kal-Kausar Mohd Amin
1 shared publicationM. A. Hashim
Universiti Sains Islam Malaysia
1 shared publication
Latest Publications
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1972 (1) , 020001
Hybrid solid polymer electrolyte from diapers as separator for electrochemical double layer capacitor (EDLC)
EDLC was fabricated using hybrid solid polymer electrolyte from PVA-diapers and an activated carbon powder as electrode by using solution casting method. For comparison, four types of EDLC cells were constructed and tested. It was found that an EDLC with a PVA-diapers (60:40) polymer electrolyte exhibited much higher capacitance and longer cycle-life. The electrocapacitive properties of the supercapacitor (P50HD50, P60HD40, P70HD30 and P80HD20) were done using electrochemical impedance spectroscopy (EIS), cyclic voltammetry (CV), and galvanostatic charge discharge (GCD). Results from these analysis showed that P60HD40 cell had recorded excellent rate capability and highest Csp value of 179 F g−1 (EIS), 50 F g−1 (CV), 328 F g−1 (GCD) respectively. Futher, results from ESR (GCD) analysis showed that P60HD40 composition of PVA/H3PO4 liquid electroyte gave a lower value of 88.05 Ω in the supercapacitor cell compared with another cells.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1972 (1) , 020001
Hybrid solid polymer electrolyte from diapers as separator for electrochemical double layer capacitor (EDLC)
EDLC was fabricated using hybrid solid polymer electrolyte from PVA-diapers and an activated carbon powder as electrode by using solution casting method. For comparison, four types of EDLC cells were constructed and tested. It was found that an EDLC with a PVA-diapers (60:40) polymer electrolyte exhibited much higher capacitance and longer cycle-life. The electrocapacitive properties of the supercapacitor (P50HD50, P60HD40, P70HD30 and P80HD20) were done using electrochemical impedance spectroscopy (EIS), cyclic voltammetry (CV), and galvanostatic charge discharge (GCD). Results from these analysis showed that P60HD40 cell had recorded excellent rate capability and highest Csp value of 179 F g−1 (EIS), 50 F g−1 (CV), 328 F g−1 (GCD) respectively. Futher, results from ESR (GCD) analysis showed that P60HD40 composition of PVA/H3PO4 liquid electroyte gave a lower value of 88.05 Ω in the supercapacitor cell compared with another cells.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1972 (1) , 030012
Colorimetric determination of Al(III) based on the aggregation of gold nanoparticles functionalized with novel 4-benzoyl pyrazolone derivative
A sensitive and selective colorimetric method has been developed for detection of Al3+ ion using 4-benzoyl pyrazolone-functionalized gold nanoparticles (BMPBP-AuNPs) as novel colorimetric probes. The BMPBP-AuNPs were characterized by UV-visible spectrometry and transmission electron microscopy (TEM). It was found that the addition of the Al3+ ions led to a rapid aggregation of the BMPBP-AuNPs, which changed the color of the mixture from red to blue. Furthermore, there was a shift in the characteristic surface plasmon resonance (SPR) peak from 524 to 650 nm of BMPBP-AuNPs, which confirmed that a good linear relation (R2 = 0.9935) was present between the absorption ratio of 524 and 650 nm. Also, the assay detected the Al3+ ion concentrations in the linear range 0-12 ppm with the detection limit is 0.05 ppm. Finally, the synthesized BMPBP-AuNPs were successfully used as a colorimetric sensor for the selective and sensitive detection of the Al3+ ions in water samples.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1972 (1) , 030012
Colorimetric determination of Al(III) based on the aggregation of gold nanoparticles functionalized with novel 4-benzoyl pyrazolone derivative
A sensitive and selective colorimetric method has been developed for detection of Al3+ ion using 4-benzoyl pyrazolone-functionalized gold nanoparticles (BMPBP-AuNPs) as novel colorimetric probes. The BMPBP-AuNPs were characterized by UV-visible spectrometry and transmission electron microscopy (TEM). It was found that the addition of the Al3+ ions led to a rapid aggregation of the BMPBP-AuNPs, which changed the color of the mixture from red to blue. Furthermore, there was a shift in the characteristic surface plasmon resonance (SPR) peak from 524 to 650 nm of BMPBP-AuNPs, which confirmed that a good linear relation (R2 = 0.9935) was present between the absorption ratio of 524 and 650 nm. Also, the assay detected the Al3+ ion concentrations in the linear range 0-12 ppm with the detection limit is 0.05 ppm. Finally, the synthesized BMPBP-AuNPs were successfully used as a colorimetric sensor for the selective and sensitive detection of the Al3+ ions in water samples.
- Open Access
- 1 January 2016
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 28 (5) , 1164-1168
Optimization of Digestion Method for Determination of Copper in Shrimp Paste Sample Using Flame Atomic Absorption Spectrometry
- 1 January 2016
- Published by Asian Publication Corporation in Asian Journal of Chemistry
- Vol. 28 (5) , 1164-1168
Open AccessOptimization of Digestion Method for Determination of Copper in Shrimp Paste Sample Using Flame Atomic Absorption Spectrometry
- Open Access
- 25 September 2015
- Published by Canadian Center of Science and Education in Journal of Materials Science Research
- Vol. 5 (1) , p24
Preparation of Activated Carbon from Desiccated Coconut Residue by Chemical Activation with NaOH
This study investigates the effect of temperature and impregnation ratio on the physicochemical properties of activated carbon prepared from agricultural waste; desiccated coconut residue (DCR) by chemical activation using sodium hydroxide (NaOH). DCR sample was first carbonized at three different temperatures for 1 hour at 400°C, 500°C, and 600°C respectively. The resulting chars were impregnated with NaOH at three different impregnation ratio; 1:1, 1:2, and 1:3 respectively and activated under nitrogen atmosphere for 1 hour at three different temperatures based on its carbonization temperature. The specific surface area was strongly affected by impregnation ratio in which increased with impregnation ratio. The specific surface area also increased with temperature but then decreased at highest desired temperature.
- 25 September 2015
- Published by Canadian Center of Science and Education in Journal of Materials Science Research
- Vol. 5 (1) , p24
Open AccessPreparation of Activated Carbon from Desiccated Coconut Residue by Chemical Activation with NaOH
This study investigates the effect of temperature and impregnation ratio on the physicochemical properties of activated carbon prepared from agricultural waste; desiccated coconut residue (DCR) by chemical activation using sodium hydroxide (NaOH). DCR sample was first carbonized at three different temperatures for 1 hour at 400°C, 500°C, and 600°C respectively. The resulting chars were impregnated with NaOH at three different impregnation ratio; 1:1, 1:2, and 1:3 respectively and activated under nitrogen atmosphere for 1 hour at three different temperatures based on its carbonization temperature. The specific surface area was strongly affected by impregnation ratio in which increased with impregnation ratio. The specific surface area also increased with temperature but then decreased at highest desired temperature.
- 1 October 2012
- Published by Elsevier in Food Chemistry
- Vol. 134 (4) , 2406-2410
Optimisation of digestion method for determination of arsenic in shrimp paste sample using atomic absorption spectrometry
- 1 October 2012
- Published by Elsevier in Food Chemistry
- Vol. 134 (4) , 2406-2410
Optimisation of digestion method for determination of arsenic in shrimp paste sample using atomic absorption spectrometry