SNShinsuke Nakayama

Shinsuke Nakayama

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shinsuke Nakayama has a total of 11 co-authors. Here are the top co-authors by number of shared publications:

  • Osamu Iwamoto

    Japan Atomic Energy Agency, 2-4 Shirakata, Tokai, Ibaraki, Japan

    11 shared publications
  • Yukinobu Watanabe

    Department of Advanced Energy Engineering Science, Kyushu University, Fukuoka, Japan

    9 shared publications
  • Kazuyuki Ogata

    Research Center for Nuclear Physics (RCNP), Osaka University, Osaka, Japan

    5 shared publications
  • Hiroshi Kouno

    Department of Advanced Energy Engineering Science, Kyushu University, Fukuoka 816-8580, Japan

    3 shared publications
  • Naoya Furutachi

    Nuclear Data Center, Japan Atomic Energy Agency, Ibaraki 319-1195, Japan

    2 shared publications
  • Tao Ye

    Department of Advanced Energy Engineering Science, Kyushu University, Fukuoka 816-8580, Japan

    2 shared publications

Latest Publications

  • Open Access

    Evaluation of thermal neutron scattering law of nuclear-grade isotropic graphite

    by Shinsuke Nakayama, Osamu Iwamoto, Atsushi Kimura

    Graphite is a candidate of moderator in innovative nuclear reactors such as high-temperature gas-cooled reactors and molten salt reactors. Scattering of thermal neutrons by a moderator material has a significant impact on the reactor core design. To contribute to the development of the innovative nuclear reactors, thermal neutron scattering law data for nuclear-grade graphite were evaluated. Inelastic scattering component due to lattice vibration was evaluated based on phonon density of states computed with first-principles lattice dynamics simulations. The simulations were performed for ideal crystalline graphite. The evaluated inelastic scattering component well reproduced the experimental double-differential cross sections of scattered neutrons from nuclear-grade isotropic graphite measured at Materials and Life science experimental Facility (MLF) of J-PARC. Coherent elastic scattering component due to crystal structure was evaluated based on the neutron scattering and transmission experiments performed at MLF of J-PARC. Regarding comparison with the neutron transmission experiment, it was found that the quantification of small-angle neutron scattering due to structures larger than crystal, such as pores in graphite, is important.


  • Comparison of Ichimura-Austern-Vincent and Glauber models for the deuteron-induced inclusive breakup reaction in light and medium-mass nuclei

    by Hao Liu, Shinsuke Nakayama, Jin Lei, Zhongzhou Ren

    This study focuses on the deuteron-induced inclusive breakup reaction and investigates the (d,pX) and (d,nX) channels for light and medium mass nuclei. To study the double differential cross section of nonelastic breakup, we employed the models of Ichimura, Austern, and Vincent (IAV) [ Phys. Rev. C 32, 431 (1985)] and the Glauber model with the quantum S matrix [ Phys. Rev. C 80, 014604 (2009)], and compared the results for various reaction systems. Our analysis indicates that the Glauber model combined with the quantum S matrix yields good agreement with the IAV model in predicting the spectra of the deuteron-induced inclusive breakup cross section. Moreover, both models accurately predict the experimental data of light and medium mass targets.

  • Open Access

    Deuteron and alpha sub-libraries of JENDL-5

    by Shinsuke Nakayama, Osamu Iwamoto, Jean-Christophe Sublet

    JENDL-5, the latest version of the Japanese evaluated nuclear data library, includes several sub-libraries to contribute to various applications. In this paper, we outline the evaluation and validation of the deuteron reaction sub-library developed mainly for the design of accelerator-based neutron sources and the alpha-particle reaction sub-library developed mainly for use in the back-end field. As for the deuteron sub-library, the data for 6,7Li, 9Be, and 12,13C from JENDL/DEU-2020 were partially modified and adopted. The data up to 200 MeV for 27Al, 63,65Cu, and 93Nb, which are important as accelerator structural materials, were newly evaluated based on the calculations with the DEURACS code. As for the alpha-particle sub-library, the data up to 15 MeV for 18 light nuclides from Li to Si isotopes were evaluated based on the calculations with the CCONE code, and then only the neutron production cross sections were replaced with the data of JENDL/AN-2005. Validation on neutron yield by Monte Carlo transport simulations was performed for both sub-libraries. As a result, it was confirmed that the simulations based on the sub-libraries showed good agreement with experimental data.

  • Theoretical Study of Deuteron-Induced Reactions in the Nuclear Data Field

    by Shinsuke Nakayama, Osamu Iwamoto, Yukinobu Watanabe, Kazuyuki Ogata


  • Open Access

    JENDL/DEU-2020: deuteron nuclear data library for design studies of accelerator-based neutron sources

    by Shinsuke Nakayama, Osamu Iwamoto, Yukinobu Watanabe, Kazuyuki Ogata

    Intensive fast neutron sources using deuteron accelerators have been proposed for various applications. To contribute to the design study of such neutron sources, a deuteron nuclear data library for 6,7Li, 9Be, and 12,13C up to 200 MeV, JENDL/DEU-2020 is developed. Evaluation of JENDL/DEU-2020 is performed by employing the code system DEURACS with particular attention to neutron production data. Toward the evaluation of JENDL/DEU-2020, some modifications are made to DEURACS. Validation of the library is performed through simulation with the Monte Carlo transport calculation codes. From the simulation, it is shown that calculation results based on JENDL/DEU-2020 reproduce measured neutron production data well in incident energies up to 200 MeV. The new library is expected to make a large contribution to diverse design studies of deuteron accelerator neutron sources.


  • Open Access

    Recent progress of a code system DEURACS toward deuteron nuclear data evaluation

    by Shinsuke Nakayama, Osamu Iwamoto, Yukinobu Watanabe

    Toward deuteron nuclear data evaluation, we have been developing a code system dedicated for deuteron-induced reactions, called DEURACS. In this paper, we review the recent progress in the development of DEURACS. To meet increasing and diversifying demands for deuteron nuclear data, DEURACS has been developed aiming at accurate and comprehensive prediction of deuteron-induced reactions. We present the results of some comparisons between the DEURACS calculations and experimental data for a variety of deuteron-induced reactions at incident energies up to 200 MeV. Double-differential cross sections for emission of neutrons or light ions up to A = 4 and cross sections for production of residual nuclei are analyzed. Neutron yields from deuteron bombardment on thick targets are also analyzed by the Monte Carlo transport simulation based on the deuteron nuclear data provided with DEURACS. Through comparison with experimental and other calculated data, validation of the present modeling in DEURACS is discussed.


  • Consistent description of light composite particle emission in deuteron-induced reactions

    by Shinsuke Nakayama, Osamu Iwamoto, Yukinobu Watanabe

    The weakly bound nature of the deuteron brings the complexity of deuteron-induced reactions compared to nucleon-induced ones and is expected to affect various physical quantities observed in deuteron-induced reactions. Aiming to deep understanding and accurate prediction for the emission of light composite particle (LCP) in deuteron-induced reactions, we revise the computational system dedicated to deuteron-induced reactions, called DEURACS. The model by Iwamoto and Harada describing pre-equilibrium cluster emission which was successfully applied to LCP emission in nucleon-induced reactions is integrated into the framework of DEURACS, in which the breakup processes of incident deuteron are explicitly taken into account. The phenomenological model by Kalbach is also adopted to estimate the contribution from the direct pickup process. Using the revised DEURACS, we analyze the $(d,xt), (d,x^{3}\mathrm{He})$, and $(d,x\ensuremath{\alpha})$ reactions in the target mass range $27\ensuremath{\le}A\ensuremath{\le}90$. Regardless of the targets, the calculation results successfully reproduced the experimental data for each reaction, simultaneously. These results demonstrate that the LCP emission from the pre-equilibrium and compound nucleus processes in deuteron-induced reactions, which occupies a large part of the total LCP emission, can be described by the same theoretical models as used in nucleon-induced reactions when the breakup processes of incident deuteron are properly considered.


  • Role of breakup processes in deuteron-induced spallation reactions at 100–200 MeV/nucleon

    by Shinsuke Nakayama, Naoya Furutachi, Osamu Iwamoto, Yukinobu Watanabe

    Background: Use of deuteron-induced spallation reactions at intermediate energies was recently proposed for transmutation of several long-lived fission products (LLFPs). In the design study of a transmutation system using a deuteron primary beam, accurate cross section data of deuteron-induced reactions on the LLFPs are indispensable. Reliable model predictions play an important role in completing the necessary cross section data since currently available experimental data are very limited. Under the circumstances, we have been developing a code system dedicated for deuteron-induced reactions, which is called DEURACS.


  • Open Access

    Role of breakup processes in deuteron-induced spallation reactions at 100-200 MeV/nucleon

    by Shinsuke Nakayama, Naoya Furutachi, Osamu Iwamoto, Yukinobu Watanabe

    Use of deuteron-induced spallation reactions at intermediate energies has recently been proposed for transmutation of several long-lived fission products (LLFPs). In the design study of a transmutation system using a deuteron primary beam, accurate cross section data of deuteron-induced reactions on the LLFPs are indispensable. Reliable model predictions play an important role in completing the necessary cross section data since currently available experimental data are very limited. Under the circumstances, we have been developing a code system dedicated for deuteron-induced reactions, which is called DEURACS. Aiming to predict the production cross sections of residual nuclei, the purpose of the present work is to clarify a role of deuteron breakup processes in deuteron-induced spallation reactions at intermediate energies. Isotopic production cross sections of residual nuclei in the deuteron-induced reactions on 93Zr and 107Pd at 100-200 MeV/nucleon are analyzed using DEURACS, in which the breakup processes are explicitly taken into account. The calculated cross sections are decomposed into individual components corresponding to the absorption of either neutron or proton in the incident deuteron, or the deuteron itself. The calculated cross sections reproduced the experimental data well over a wide mass number range of residual nuclei. From a component-by-component analysis, it was found that the components of nucleon absorption have the significant contributions to the production of residual nuclei. Consideration of the breakup processes is essential to predict the production cross sections of residual nuclei in deuteron-induced reactions. The framework of DEURACS is applicable to deuteron-induced spallation reactions at intermediate energies.

  • Calculation of neutron cross-sections on copper-63 and -65

    by Shinsuke Nakayama

    Toward the development of the next version of Japanese Evaluated Nuclear Data Library (JENDL) general-purpose file, we calculate neutron cross-sections on 63, 65Cu from 50 keV to 20 MeV, which is the incident energy range above the resolved resonance region in JENDL-4.0. A dispersive optical model potential is adopted with a coupled-channel method for interaction between neutron and 63, 65Cu. Direct, pre-equilibrium, and compound processes are taken into account in the calculation. All cross-sections, differential and double-differential cross-sections are consistently calculated with a single set of model parameters. The calculation results reproduce the measured data very well. In addition, disagreement between the calculated and experimental values seen in an integral test for the 63Cu(n, α)60Co reaction is improved by using the cross-section data obtained from the present work.