MBM. Bäckström

M. Bäckström

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


M. Bäckström has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Seasonal variations in road runoff quality in Luleå, Sweden

    by C. Westerlund, M. Viklander, M. Bäckström

    In regions with cold climate the urban drainage and highway runoff processes become much more complex, compared to temperate regions. Therefore, climatic conditions should be taken into account in planning and design of BMPs and snow handling strategies. In order to increase the knowledge of road runoff quality during melt and rain periods, respectively, measurements were carried out at a field site during a two-month period. The field site was situated at Södra Hamnleden, a road with 7,400 vehicles/day, in the central part of Luleå. Runoff samples were analysed for suspended solids and heavy metals (Pb, Cu, Cd, Ni and Zn). The results showed that the concentrations of suspended solids, lead, copper and cadmium were higher for the melt period, compared to rain generated runoff on the catchment without snow, and the highest concentrations were found during the rain-on-snow events. The results indicate a flow dependent increase in the concentration of suspended solids during the melt period. A comparison of the total mass of suspended solids over a one-month period showed that the melt period produced about 3 times more suspended solids. Metal elements during melt period were more particulate bound as compared to the rain period characterised by a higher percentage of the dissolved fraction.


  • Grassed swales for stormwater pollution control during rain and snowmelt

    by M. Bäckström

    The retention of suspended solids, particles and heavy metals in different grassed swales during rain events and snowmelt is discussed. The experimental results derived from investigations performed in existing grassed swales in the Luleå region, Northern Sweden. During high pollutant loading rates, grassed swales retain significant amounts of pollutants, mainly due to sedimentation of particulate matter. Low to moderate removal efficiencies could be expected for heavy metals, especially metals in solution (i.e. the dissolved phase). When grassed swales receive urban runoff with low pollutant concentrations, they may release rather than retain pollutants. Swales are important snow deposit areas in the city and particle bound pollutants do to a large extent remain in the swale after snowmelt. However, dissolved pollutants (i.e. dissolved heavy metals) are likely to escape the swale with the melt water. Grassed swales may be regarded as facilities that even out the peaks in pollutant loads without being capable of producing consistent high removal rates. This suggests that swales should be considered as primary treatment devices. Possible design parameters for grassed swales are mean hydraulic detention time, surface loading rate or specific swale area.