Mukesh Jangir
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mukesh Jangir has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Suryakanta Dalai
Jubilant Biosys Ltd
3 shared publicationsDeepak Kumar
Department of Applied Sciences, Chemistry, NIMS University
2 shared publications- Indra Prabha Jain
Centre for Non-Conventional Energy Resources, University of Rajasthan, Jaipur, India
2 shared publications - Ankur Jain
Centre for Renewable Energy & Storage Suresh Gyan Vihar University Jaipur India
1 shared publication - Daniele Mirabile Gattia
Department of Sustainability, Circularity, and Climate Change Adaptation of Production and Territorial Systems (SSPT), Research Centre of Casaccia, Italian National Agency for New Technologies, Energy and Sustainable Economic Development (ENEA), Via Anguillarese 301, 00123 Rome, Italy
1 shared publication - Daniele Mirabile Gattia
Casaccia Res Ctr, ENEA, Via Anguillarese 301, I-00123 Rome, Italy
1 shared publication
Latest Publications
- Open Access
- 3 May 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (18) , 19033-19044
Synthesis of a Novel 1,3,4-Oxadiazole Derivative with Piperazine and Phenoxypropanol Functionalities
- 3 May 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (18) , 19033-19044
Open AccessSynthesis of a Novel 1,3,4-Oxadiazole Derivative with Piperazine and Phenoxypropanol Functionalities
- 1 April 2025
- Published by Georg Thieme Verlag KG in Synthesis
- Vol. 57 (09) , 1640-1650
Design and Synthesis of a Novel 1,2,4-Oxadiazole Derivative: 3-(3-(5-((4-Phenylpiperazin-1-yl)methyl)-1,2,4-oxadiazol-3-yl) phenoxy)propan-2-olamines
The synthesis of novel heterocyclic 3-(3-(5-((4-phenylpiperazin-1-yl)methyl)-1,2,4-oxadiazol-3-yl)phenoxy)propan-2-olamine derivatives, in particular piperazine and piperidine derivatives of 1,2,4-oxadiazole, is reported. These compounds are a distinguished motif for biological studies. An effective piperazine and piperidine derivative methodology on 1,2,4-oxadiazole substrates has been developed. This pathway, along with good yields and clean reactions, has a broad substrate scope and provides new biologically useful moieties that can be further investigated for their applicability.
- 1 April 2025
- Published by Georg Thieme Verlag KG in Synthesis
- Vol. 57 (09) , 1640-1650
Design and Synthesis of a Novel 1,2,4-Oxadiazole Derivative: 3-(3-(5-((4-Phenylpiperazin-1-yl)methyl)-1,2,4-oxadiazol-3-yl) phenoxy)propan-2-olamines
The synthesis of novel heterocyclic 3-(3-(5-((4-phenylpiperazin-1-yl)methyl)-1,2,4-oxadiazol-3-yl)phenoxy)propan-2-olamine derivatives, in particular piperazine and piperidine derivatives of 1,2,4-oxadiazole, is reported. These compounds are a distinguished motif for biological studies. An effective piperazine and piperidine derivative methodology on 1,2,4-oxadiazole substrates has been developed. This pathway, along with good yields and clean reactions, has a broad substrate scope and provides new biologically useful moieties that can be further investigated for their applicability.
- 1 March 2025
- Published by Springer Nature in Catalysis Letters
- Vol. 155 (4) , 1-10
Synthesis of 1,2,4-Oxadiazole Derivatives via XPhos Pd G3 Catalyzed Buchwald Coupling
- 1 March 2025
- Published by Springer Nature in Catalysis Letters
- Vol. 155 (4) , 1-10
Synthesis of 1,2,4-Oxadiazole Derivatives via XPhos Pd G3 Catalyzed Buchwald Coupling
- Open Access
- 27 September 2020
- Published by MDPI AG in Inorganics
- Vol. 8 (10) , 54
Behavior of Compacted Magnesium-Based Powders for Energy-Storage Applications
Energy storage is one of the main challenges to address in the near future—in particular due to the intermittent energy produced by extensive renewable energy production plants. The use of hydrides for this type of energy storage has many positive aspects. Hydride-based systems consist of absorption and desorption reactions that are strongly exothermic and endothermic, respectively. Heat management in the design of hydrogen storage tanks is an important issue, in order to ensure high-level performance in terms of the kinetics for hydrogen release/uptake and reasonable storage capacity. When loose powder is used, material in the form of pellets should be considered in order to avoid detrimental effects including decreased cycling performance. Moreover, sustainable materials in large-scale hydrogen reactors could be recovered and reused to improve any life cycle analysis of such systems. For these reasons, magnesium hydride was used in this study, as it is particularly suitable for hydrogen storage due to its high H2 storage capacity, reversibility and the low costs. Magnesium hydride was ball-milled in presence of 5 wt % Fe as a catalyst, then compacted with an uniaxial press after the addition of expanded natural graphite (ENG). The materials underwent 45 cycles in a Sievert’s type apparatus at 310 °C and eight bar, in order to study the kinetics and cycling stability. Scanning electron microscopy was used to investigate microstructural properties and failure phenomena. Together with Rietveld analysis, X-ray diffraction was performed for phase identification and structural information. The pellets demonstrated suitable cycling stability in terms of total hydrogen storage capacity and kinetics.
- 27 September 2020
- Published by MDPI AG in Inorganics
- Vol. 8 (10) , 54
Open AccessBehavior of Compacted Magnesium-Based Powders for Energy-Storage Applications
Energy storage is one of the main challenges to address in the near future—in particular due to the intermittent energy produced by extensive renewable energy production plants. The use of hydrides for this type of energy storage has many positive aspects. Hydride-based systems consist of absorption and desorption reactions that are strongly exothermic and endothermic, respectively. Heat management in the design of hydrogen storage tanks is an important issue, in order to ensure high-level performance in terms of the kinetics for hydrogen release/uptake and reasonable storage capacity. When loose powder is used, material in the form of pellets should be considered in order to avoid detrimental effects including decreased cycling performance. Moreover, sustainable materials in large-scale hydrogen reactors could be recovered and reused to improve any life cycle analysis of such systems. For these reasons, magnesium hydride was used in this study, as it is particularly suitable for hydrogen storage due to its high H2 storage capacity, reversibility and the low costs. Magnesium hydride was ball-milled in presence of 5 wt % Fe as a catalyst, then compacted with an uniaxial press after the addition of expanded natural graphite (ENG). The materials underwent 45 cycles in a Sievert’s type apparatus at 310 °C and eight bar, in order to study the kinetics and cycling stability. Scanning electron microscopy was used to investigate microstructural properties and failure phenomena. Together with Rietveld analysis, X-ray diffraction was performed for phase identification and structural information. The pellets demonstrated suitable cycling stability in terms of total hydrogen storage capacity and kinetics.
- 1 September 2019
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 801, 188-191
Study on nanostructured MgH2 with Fe and its oxides for hydrogen storage applications
- 1 September 2019
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 801, 188-191
Study on nanostructured MgH2 with Fe and its oxides for hydrogen storage applications
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 030059
Improved hydrogen storage properties of MgH2 catalyzed with TiO2
In order to improve the hydrogenation properties of the MgH2, various concentration of rutile Titanium Oxide (TiO2) (X wt%= 5, 10, 15 wt %) is added to MgH2 by ball milling and the catalytic effect of TiO2 on hydriding/dehydriding properties of MgH2 has been investigated. Result shows that the TiO2 significantly reduced onset temperature of desorption. Onset temperature as low as 190 °C were observed for the MgH2−15 wt% TiO2 sample which is 60 °C and 160 °C lower than the as-milled and as-received MgH2. Fromm the Kissinger plot the activation energy of 15 wt% TiO2 added sample is calculated to be -75.48 KJ/mol. These results indicate that the hydrogenation properties of MgH2–TiO2 have been improved compared to the as-milled and as-received MgH2. Furthermore, XRD and XPS were performed to characterize the structural evolution upon milling and dehydrogenation.
- 1 January 2018
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1953 (1) , 030059
Improved hydrogen storage properties of MgH2 catalyzed with TiO2
In order to improve the hydrogenation properties of the MgH2, various concentration of rutile Titanium Oxide (TiO2) (X wt%= 5, 10, 15 wt %) is added to MgH2 by ball milling and the catalytic effect of TiO2 on hydriding/dehydriding properties of MgH2 has been investigated. Result shows that the TiO2 significantly reduced onset temperature of desorption. Onset temperature as low as 190 °C were observed for the MgH2−15 wt% TiO2 sample which is 60 °C and 160 °C lower than the as-milled and as-received MgH2. Fromm the Kissinger plot the activation energy of 15 wt% TiO2 added sample is calculated to be -75.48 KJ/mol. These results indicate that the hydrogenation properties of MgH2–TiO2 have been improved compared to the as-milled and as-received MgH2. Furthermore, XRD and XPS were performed to characterize the structural evolution upon milling and dehydrogenation.
- 5 October 2017
- Published by Wiley in International Journal of Energy Research
- Vol. 42 (3) , 1139-1147
The enhanced de/re-hydrogenation performance of MgH2 with TiH2 additive
- 5 October 2017
- Published by Wiley in International Journal of Energy Research
- Vol. 42 (3) , 1139-1147
The enhanced de/re-hydrogenation performance of MgH2 with TiH2 additive