I. Bencheikh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
I. Bencheikh has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
- Mohammed Nouari
Laboratoire d’Energétique et de Mécanique Théorique et Appliquée, Ecole des Mines de Nancy, Université de Lorraine, F-88100 Saint Dié Des Vosges, France
2 shared publications F. Bilteryst
LARIOPAC: Laboratoire commun de recherche public-PME, LEMTA, CNRS-UMR 7563, Lorraine University, LabCom – Vague 2 – 2013, GIP-InSIC, Saint-Dié-des Vosges, France
1 shared publication- F. Bilteryst
Lorraine Univ, LEMTA, CNRS UMR 7563,GIP InSIC, LARIOPAC Lab Commun Rech Publ PME,LabCom, Vague 2,2013,27 Rue Hellieule, F-88100 St Die, France
1 shared publication
Latest Publications
- 7 November 2016
- Published by Taylor & Francis in Advances in Materials and Processing Technologies
- Vol. 3 (1) , 1-11
Development of a hybrid modeling for the analysis of the coating influence on machining process
The wear resistance of cutting tools has been often enhanced using single or multilayered coatings on their surface. During machining processes, the extreme thermomechanical loading which generated at the tool–chip interface greatly affects the cutting tool zone. The study of the coating behaviour leads to a better understanding of its impact on the overall structure. For this purpose, the MAX-FEM model has been extended in order to describe the behaviour of such structures, ensuring accurate results without special mesh refinement. The ability of the proposed numerical scheme is demonstrated by solving a 2D heat conduction problem. The effectiveness of the model has been tested in terms of convergence and computational time, and systematically compared to a classical finite elements solution. A discussion about the model limitations was also made.
- 7 November 2016
- Published by Taylor & Francis in Advances in Materials and Processing Technologies
- Vol. 3 (1) , 1-11
Development of a hybrid modeling for the analysis of the coating influence on machining process
The wear resistance of cutting tools has been often enhanced using single or multilayered coatings on their surface. During machining processes, the extreme thermomechanical loading which generated at the tool–chip interface greatly affects the cutting tool zone. The study of the coating behaviour leads to a better understanding of its impact on the overall structure. For this purpose, the MAX-FEM model has been extended in order to describe the behaviour of such structures, ensuring accurate results without special mesh refinement. The ability of the proposed numerical scheme is demonstrated by solving a 2D heat conduction problem. The effectiveness of the model has been tested in terms of convergence and computational time, and systematically compared to a classical finite elements solution. A discussion about the model limitations was also made.