Takayoshi Oshima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Takayoshi Oshima has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Akito Kuramata
Tamura Corp, Sayama, Saitama 3501328, Japan
4 shared publicationsKohei Sasaki
Tamura Corp, Sayama, Saitama 3501328, Japan
4 shared publicationsMakoto Kasu
Saga University
3 shared publicationsToshiyuki Oishi
Saga Univ, Dept Elect & Elect Engn, Saga 8408502, Japan
3 shared publicationsYuji Kato
Saga University, Saga, Japan
3 shared publicationsAkihiro Hashiguchi
Saga University
2 shared publications
Latest Publications
- 24 April 2020
- Published by Springer Nature
- p. 703-725
Photodetectors
- 31 May 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (6) , 060910
Characterization of pseudomorphic γ -Ga 2 O 3 and γ -Al 2 O 3 films on MgAl 2 O 4 substrates and the band-alignment at the coherent γ -Ga 2 O 3 /Al 2 O 3 heterojunction interface
We characterized 3.0 nm γ -Ga 2 O 3 , 3.0 nm γ -Al 2 O 3 , and 1.0/3.0 nm γ -Ga 2 O 3 /Al 2 O 3 films grown on (100) MgAl 2 O 4 substrates. X-ray diffraction measurements revealed that γ -Ga 2 O 3 and γ -Al 2 O 3 films were coherent to the substrate with Poisson’s ratios of 0.31 and 0.28. While, X-ray photoelectron spectroscopy found that band gaps of the γ -Ga 2 O 3 and γ -Al 2 O 3 films were 5.6 and 7.4 eV, respectively, and that the γ -Ga 2 O 3 /Al 2 O 3 heterojunction had type-I band alignment with conduction- and valence-band-offsets of 1.6 and 0.2 eV, respectively. These findings regarding the end members of γ -(Al x Ga 1- x ) 2 O 3 will be beneficial for further study on γ -(Al x Ga 1- x ) 2 O 3 -based heterostructures.
- 31 May 2019
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 58 (6) , 060910
Characterization of pseudomorphic γ -Ga 2 O 3 and γ -Al 2 O 3 films on MgAl 2 O 4 substrates and the band-alignment at the coherent γ -Ga 2 O 3 /Al 2 O 3 heterojunction interface
We characterized 3.0 nm γ -Ga 2 O 3 , 3.0 nm γ -Al 2 O 3 , and 1.0/3.0 nm γ -Ga 2 O 3 /Al 2 O 3 films grown on (100) MgAl 2 O 4 substrates. X-ray diffraction measurements revealed that γ -Ga 2 O 3 and γ -Al 2 O 3 films were coherent to the substrate with Poisson’s ratios of 0.31 and 0.28. While, X-ray photoelectron spectroscopy found that band gaps of the γ -Ga 2 O 3 and γ -Al 2 O 3 films were 5.6 and 7.4 eV, respectively, and that the γ -Ga 2 O 3 /Al 2 O 3 heterojunction had type-I band alignment with conduction- and valence-band-offsets of 1.6 and 0.2 eV, respectively. These findings regarding the end members of γ -(Al x Ga 1- x ) 2 O 3 will be beneficial for further study on γ -(Al x Ga 1- x ) 2 O 3 -based heterostructures.
- 23 May 2019
- Published by IOP Publishing in Applied Physics Express
- Vol. 12 (6) , 065503
Fabrication of coherent γ-Al2O3/Ga2O3 superlattices on MgAl2O4 substrates
- 23 May 2019
- Published by IOP Publishing in Applied Physics Express
- Vol. 12 (6) , 065503
Fabrication of coherent γ-Al2O3/Ga2O3 superlattices on MgAl2O4 substrates
- 23 October 2018
- Published by IOP Publishing in Applied Physics Express
- Vol. 11 (11)
β-Ga2O3-based metal–oxide–semiconductor photodiodes with HfO2 as oxide
- 23 October 2018
- Published by IOP Publishing in Applied Physics Express
- Vol. 11 (11)
β-Ga2O3-based metal–oxide–semiconductor photodiodes with HfO2 as oxide
- 30 June 2017
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 56 (8) , 086501
Electrical properties of Schottky barrier diodes fabricated on (001) β-Ga 2 O 3 substrates with crystal defects
The electrical properties of Schottky barrier diodes (SBDs) on a (001) β-Ga 2 O 3 substrate were characterized and correlated with wet etching-revealed crystal defects below the corresponding Schottky contacts. The etching process revealed etched grooves and etched pits, indicating the presence of line-shaped voids and small defects near the surface, respectively. The electrical properties (i.e., leakage currents, ideality factor, and barrier height) exhibited almost no correlation with the density of the line-shaped voids. This very weak correlation was reasonable considering the parallel positional relation between the line-shaped voids extending along the [010] direction and the (001) basal plane in which the voids are rarely exposed on the initial surface in contact with the Schottky metals. The distribution of small defects and SBDs with unusually large leakage currents showed similar patterns on the substrate, suggesting that these defects were responsible for the onset of fatal leak paths. These results will encourage studies on crystal defect management of (001) β-Ga 2 O 3 substrates for the fabrication of devices with enhanced performance using these substrates.
- 30 June 2017
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 56 (8) , 086501
Electrical properties of Schottky barrier diodes fabricated on (001) β-Ga 2 O 3 substrates with crystal defects
The electrical properties of Schottky barrier diodes (SBDs) on a (001) β-Ga 2 O 3 substrate were characterized and correlated with wet etching-revealed crystal defects below the corresponding Schottky contacts. The etching process revealed etched grooves and etched pits, indicating the presence of line-shaped voids and small defects near the surface, respectively. The electrical properties (i.e., leakage currents, ideality factor, and barrier height) exhibited almost no correlation with the density of the line-shaped voids. This very weak correlation was reasonable considering the parallel positional relation between the line-shaped voids extending along the [010] direction and the (001) basal plane in which the voids are rarely exposed on the initial surface in contact with the Schottky metals. The distribution of small defects and SBDs with unusually large leakage currents showed similar patterns on the substrate, suggesting that these defects were responsible for the onset of fatal leak paths. These results will encourage studies on crystal defect management of (001) β-Ga 2 O 3 substrates for the fabrication of devices with enhanced performance using these substrates.
- 27 April 2017
- Published by IOP Publishing in Applied Physics Express
- Vol. 10 (5) , 051104
Epitaxial growth of γ-(AlxGa1−x)O3alloy films for band-gap engineering
- 27 April 2017
- Published by IOP Publishing in Applied Physics Express
- Vol. 10 (5) , 051104
Epitaxial growth of γ-(AlxGa1−x)O3alloy films for band-gap engineering
- 26 October 2016
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 55 (12) , 1202B7
Formation of indium–tin oxide ohmic contacts for β-Ga2O3
Sputter-deposited indium–tin oxide (ITO) electrodes became ohmic contacts for unintentionally doped β-Ga2O3(010) substrates with a carrier concentration of 2 × 1017 cm−3 after rapid thermal annealing in a wide range of annealing temperatures of 900–1150 °C. The formation of an ohmic contact is attributed to interdiffusion between ITO and β-Ga2O3, as evidenced by the results of transmission electron microscopy and energy-dispersive X-ray spectroscopy. The interdiffusion decreases the band gap and increases the donor concentration of β-Ga2O3 at the interface, and forms an intermediate semiconductor layer desirable for carrier transport. The ITO ohmic contact is particularly useful for future β-Ga2O3 devices operated at high temperatures.
- 26 October 2016
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 55 (12) , 1202B7
Formation of indium–tin oxide ohmic contacts for β-Ga2O3
Sputter-deposited indium–tin oxide (ITO) electrodes became ohmic contacts for unintentionally doped β-Ga2O3(010) substrates with a carrier concentration of 2 × 1017 cm−3 after rapid thermal annealing in a wide range of annealing temperatures of 900–1150 °C. The formation of an ohmic contact is attributed to interdiffusion between ITO and β-Ga2O3, as evidenced by the results of transmission electron microscopy and energy-dispersive X-ray spectroscopy. The interdiffusion decreases the band gap and increases the donor concentration of β-Ga2O3 at the interface, and forms an intermediate semiconductor layer desirable for carrier transport. The ITO ohmic contact is particularly useful for future β-Ga2O3 devices operated at high temperatures.
- 21 October 2016
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 55 (12) , 1202B6
Epitaxial growth and electric properties of γ-Al2O3(110) films on β-Ga2O3(010) substrates
Epitaxial growth and electrical properties of γ-Al2O3 films on β-Ga2O3(010) substrates were investigated regarding the prospect of a gate oxide in a β-Ga2O3-based MOSFET. The γ-Al2O3 films grew along the [110] direction and inherited the oxygen sublattice from β-Ga2O3 resulting in the unique in-plane epitaxial relationship of γ-Al2O3 ∥ β-Ga2O3[001]. We found that the γ-Al2O3 layer had a band gap of 7.0 eV and a type-I band alignment with β-Ga2O3 with conduction- and valence-band offsets of 1.9 and 0.5 eV, respectively. A relatively high trap density (≅ 2 × 1012 cm−2 eV−1) was found from the voltage shift of photoassisted capacitance–voltage curves measured for a Au/γ-Al2O3/β-Ga2O3 MOS capacitor. These results indicate good structural and electric properties and some limitations hindering the better understanding of the role of the gate dielectrics (a γ-Al2O3 interface layer naturally crystallized from amorphous Al2O3) in the β-Ga2O3 MOSFET.
- 21 October 2016
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 55 (12) , 1202B6
Epitaxial growth and electric properties of γ-Al2O3(110) films on β-Ga2O3(010) substrates
Epitaxial growth and electrical properties of γ-Al2O3 films on β-Ga2O3(010) substrates were investigated regarding the prospect of a gate oxide in a β-Ga2O3-based MOSFET. The γ-Al2O3 films grew along the [110] direction and inherited the oxygen sublattice from β-Ga2O3 resulting in the unique in-plane epitaxial relationship of γ-Al2O3 ∥ β-Ga2O3[001]. We found that the γ-Al2O3 layer had a band gap of 7.0 eV and a type-I band alignment with β-Ga2O3 with conduction- and valence-band offsets of 1.9 and 0.5 eV, respectively. A relatively high trap density (≅ 2 × 1012 cm−2 eV−1) was found from the voltage shift of photoassisted capacitance–voltage curves measured for a Au/γ-Al2O3/β-Ga2O3 MOS capacitor. These results indicate good structural and electric properties and some limitations hindering the better understanding of the role of the gate dielectrics (a γ-Al2O3 interface layer naturally crystallized from amorphous Al2O3) in the β-Ga2O3 MOSFET.
- 1 November 2012
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 51 (11S) , 11PG11
Epitaxial Structures of Band-Gap-Engineered α-(CrxFe1-x)2O3(0 ≤x≤1) Films Grown onC-Plane Sapphire
- 1 November 2012
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 51 (11S) , 11PG11
Epitaxial Structures of Band-Gap-Engineered α-(CrxFe1-x)2O3(0 ≤x≤1) Films Grown onC-Plane Sapphire
- 18 May 2012
- Published by Springer Nature in MRS Proceedings
- Vol. 1454, 3-13
Spontaneous atomic ordering and magnetism in epitaxially stabilized double-perovskites
- 18 May 2012
- Published by Springer Nature in MRS Proceedings
- Vol. 1454, 3-13
Spontaneous atomic ordering and magnetism in epitaxially stabilized double-perovskites