Andreas Martin Gänzler
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Andreas Martin Gänzler has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Benjamin Mutz
Institute for Chemical Technology and Polymer Chemistry, Karlsruhe Institute of Technology (KIT), D-76131 Karlsruhe, Germany
1 shared publication Christophe Geantet
UMR 5256, Institut de Recherches sur la Catalyse et l'Environnement de LYON, CNRS, Université Claude Bernard Lyon 1, Université de Lyon, cedex, Villeurbanne, France
1 shared publicationFrancisco J. Cadete Santos Aires
UMR 5256, Institut de Recherches sur la Catalyse et l'Environnement de LYON, CNRS, Université Claude Bernard Lyon 1, Université de Lyon, cedex, Villeurbanne, France
1 shared publicationGéraldine Ferre
UMR 5256, Institut de Recherches sur la Catalyse et l'Environnement de LYON, CNRS, Université Claude Bernard Lyon 1, Université de Lyon, cedex, Villeurbanne, France
1 shared publication- Jan-Dierk Grunwaldt
Institute for Chemical Technology and Polymer Chemistry, Karlsruhe Institute of Technology, Engesserstraße 20, 76131 Karlsruhe, Germany
1 shared publication Jan‐Dierk Grunwaldt
Institute for Chemical Technology and Polymer Science (ITCP), Karlsruhe Institute of Technology (KIT), Karlsruhe, Allemagne
1 shared publication
Latest Publications
- Open Access
Surface Oxidation of Supported Ni Particles and Its Impact on the Catalytic Performance during Dynamically Operated Methanation of CO2
The methanation of CO2 within the power-to-gas concept was investigated under fluctuating reaction conditions to gather detailed insight into the structural dynamics of the catalyst. A 10 wt % Ni/Al2O3 catalyst with uniform 3.7 nm metal particles and a dispersion of 21% suitable to investigate structural changes also in a surface-sensitive way was prepared and characterized in detail. Operando quick-scanning X-ray absorption spectroscopy (XAS/QEXAFS) studies were performed to analyze the influence of 30 s and 300 s H2 interruptions during the methanation of CO2 in the presence of O2 impurities (technical CO2). These conditions represent the fluctuating supply of H2 from renewable energies for the decentralized methanation. Short-term H2 interruptions led to oxidation of the most reactive low-coordinated metallic Ni sites, which could not be re-reduced fully during the subsequent methanation cycle and accordingly caused deactivation. Detailed evaluation of the extended X-ray absorption fine structure (EXAFS) spectra showed surface oxidation/reduction processes, whereas the core of the Ni particles remained reduced. The 300-s H2 interruptions resulted in bulk oxidation already after the first cycle and a more pronounced deactivation. These results clearly show the importance and opportunities of investigating the structural dynamics of catalysts to identify their mechanism, especially in power-to-chemicals processes using renewable H2.
Open AccessSurface Oxidation of Supported Ni Particles and Its Impact on the Catalytic Performance during Dynamically Operated Methanation of CO2
The methanation of CO2 within the power-to-gas concept was investigated under fluctuating reaction conditions to gather detailed insight into the structural dynamics of the catalyst. A 10 wt % Ni/Al2O3 catalyst with uniform 3.7 nm metal particles and a dispersion of 21% suitable to investigate structural changes also in a surface-sensitive way was prepared and characterized in detail. Operando quick-scanning X-ray absorption spectroscopy (XAS/QEXAFS) studies were performed to analyze the influence of 30 s and 300 s H2 interruptions during the methanation of CO2 in the presence of O2 impurities (technical CO2). These conditions represent the fluctuating supply of H2 from renewable energies for the decentralized methanation. Short-term H2 interruptions led to oxidation of the most reactive low-coordinated metallic Ni sites, which could not be re-reduced fully during the subsequent methanation cycle and accordingly caused deactivation. Detailed evaluation of the extended X-ray absorption fine structure (EXAFS) spectra showed surface oxidation/reduction processes, whereas the core of the Ni particles remained reduced. The 300-s H2 interruptions resulted in bulk oxidation already after the first cycle and a more pronounced deactivation. These results clearly show the importance and opportunities of investigating the structural dynamics of catalysts to identify their mechanism, especially in power-to-chemicals processes using renewable H2.
- Open Access
- 20 December 2016
- Published by Wiley
- p. 139-140
Using in situ environmental transmission microscopy and operandoX‐ray absorption spectroscopy to investigate ceria based diesel oxidation catalysts
A knowledge‐based design of catalysts requires the determination of so‐called structure‐activity‐relationships. Such correlations between the catalytic activity and its properties on the microscopic and macroscopic scales help to identify new routes for improving state‐of‐the‐art and to develop new generations of catalytic systems. However, in particular at the microscopic level, certain properties of the catalyst, like for example the oxidation state and the morphology of noble metal nanoparticles, can be influenced by the temperature and the atmosphere [1, 2]. As a consequence, it is mandatory to obtain such information under working conditions (“operando”).This accounts in particular for automotive exhaust gas catalysts [3–5]. In the present study, ceria supported catalysts were investigated for application as diesel oxidation catalysts. In contrast to catalysts not supported on ceria, their activity strongly depended on the pre‐conditioning. As previously observed, the activity could be significantly enhanced with respect to low temperature CO and hydrocarbon oxidation, by short reducing pulses (lean/rich‐treatment) at moderate temperatures [6]. Since such treatments could be exploited in a car from the technological point of view it is of high interest to understand the origin and the mechanism of this activation step. Hence, a comprehensive approach was applied appreciating especially the importance of a catalyst characterization in relevant conditions (pressure and temperature). In this regardin situenvironmental transmission electron microscopy (ETEM) was applied together withoperandoquick‐scanning X‐ray absorption spectroscopy (QEXAFS).According to the QEXAFS data obtained on Pt/CeO2/Al2O3the low temperature activity of the catalyst was found to be improved (Figure 1), after the Pt oxidation state got reduced effectively during a lean/rich treatment (Figure 2), e.g. by using CO as reductant. After activation, however, the catalyst got deactivated again during the subsequent light‐off experiment, if treated at too high temperature, accompanied by Pt oxidation. Complementary ETEM studies offered a closer look on the processes on the catalyst surface, e.g. of a reductively treated Pt/CeO2catalyst in an oxidizing atmosphere at elevated temperatures (10 mbar O2, 400 °C). Prominent structural changes were found depending on the reaction atmosphere. Upon treatment similar to those where XAS evidenced deactivation of the catalyst and Pt oxidation, the disappearance of most of the smallest Pt particles was observed (Figure 3) and a lower number of larger particles were found to remain. The disapperance of small Pt particles could represent a possible deactivation pathway due to redispersion of Pt atoms at elevated temperatures. Hence, ETEM experiments confirmed the strong structural dynamics at the microscopic level of the catalyst, which probably represent the origin of the catalysts activation and deactivation and will be further exploited in future.
- 20 December 2016
- Published by Wiley
- p. 139-140
Open AccessUsing in situ environmental transmission microscopy and operandoX‐ray absorption spectroscopy to investigate ceria based diesel oxidation catalysts
A knowledge‐based design of catalysts requires the determination of so‐called structure‐activity‐relationships. Such correlations between the catalytic activity and its properties on the microscopic and macroscopic scales help to identify new routes for improving state‐of‐the‐art and to develop new generations of catalytic systems. However, in particular at the microscopic level, certain properties of the catalyst, like for example the oxidation state and the morphology of noble metal nanoparticles, can be influenced by the temperature and the atmosphere [1, 2]. As a consequence, it is mandatory to obtain such information under working conditions (“operando”).This accounts in particular for automotive exhaust gas catalysts [3–5]. In the present study, ceria supported catalysts were investigated for application as diesel oxidation catalysts. In contrast to catalysts not supported on ceria, their activity strongly depended on the pre‐conditioning. As previously observed, the activity could be significantly enhanced with respect to low temperature CO and hydrocarbon oxidation, by short reducing pulses (lean/rich‐treatment) at moderate temperatures [6]. Since such treatments could be exploited in a car from the technological point of view it is of high interest to understand the origin and the mechanism of this activation step. Hence, a comprehensive approach was applied appreciating especially the importance of a catalyst characterization in relevant conditions (pressure and temperature). In this regardin situenvironmental transmission electron microscopy (ETEM) was applied together withoperandoquick‐scanning X‐ray absorption spectroscopy (QEXAFS).According to the QEXAFS data obtained on Pt/CeO2/Al2O3the low temperature activity of the catalyst was found to be improved (Figure 1), after the Pt oxidation state got reduced effectively during a lean/rich treatment (Figure 2), e.g. by using CO as reductant. After activation, however, the catalyst got deactivated again during the subsequent light‐off experiment, if treated at too high temperature, accompanied by Pt oxidation. Complementary ETEM studies offered a closer look on the processes on the catalyst surface, e.g. of a reductively treated Pt/CeO2catalyst in an oxidizing atmosphere at elevated temperatures (10 mbar O2, 400 °C). Prominent structural changes were found depending on the reaction atmosphere. Upon treatment similar to those where XAS evidenced deactivation of the catalyst and Pt oxidation, the disappearance of most of the smallest Pt particles was observed (Figure 3) and a lower number of larger particles were found to remain. The disapperance of small Pt particles could represent a possible deactivation pathway due to redispersion of Pt atoms at elevated temperatures. Hence, ETEM experiments confirmed the strong structural dynamics at the microscopic level of the catalyst, which probably represent the origin of the catalysts activation and deactivation and will be further exploited in future.