Haibiao Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Haibiao Wu has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Xingzhong Cao
Institute of High Energy Physics, Chinese Academy of Sciences, Beijing 100049, P. R. China
4 shared publications Baoyi Wang
3 shared publicationsPeng Zhang
3 shared publications- Te Zhu
Institute of High Energy Physics, Chinese Academy of Sciences, Beijing, China
3 shared publications - Fengjiao Ye
Institute for High Energy Physics, Beijing 100039, China
2 shared publications - Peng Kuang
Institute of High Energy Physics, Chinese Academy of Sciences, Beijing 100049, China
2 shared publications
Latest Publications
- Open Access
- 10 March 2026
- Published by SAGE Publications in Technology in Cancer Research & Treatment
- Vol. 25
Region-specific Multi-Omics Modeling for Predicting Acute Radiation-Induced Proctitis in Cervical Cancer Radiotherapy: A Retrospective Analysis
Introduction: To develop and evaluate a multi-omics machine-learning model that integrates clinical variables, dose-volume histogram (DVH) metrics, radiomics, and dosiomics from both the rectum and rectal wall regions of interest (ROIs) to improve prediction of acute radiation proctitis (ARP) in cervical cancer patients receiving radiotherapy. Methods: In this single-center retrospective cohort, 107 cervical cancer patients were randomly split into a training set (n = 85) and a testing set (n = 22) in an 8:2 ratio. Radiomic were extracted from planning CT, and dosiomic features from 3-D RT-dose distributions, for both rectum and rectal wall ROIs. Features were z-score standardized; redundant features were filtered by Pearson correlation, followed by least absolute shrinkage and selection operator (LASSO) for selection. Support Vector Machine (SVM) and Multilayer Perceptron (MLP) classifiers were trained using stratified five-fold cross-validation within the training set. Model performance was assessed on the held-out test set using receiver operating characteristic (ROC) analysis; clinical utility was evaluated with decision-curve analysis (DCA). The primary endpoint was Common Terminology Criteria for Adverse Events (CTCAE,version 5.0) grade ≥2 ARP. Results: Multi-omics fusion outperformed single-modality models across ROIs and classifiers. The rectal-wall multi-omics SVM achieved the best discrimination with AUC 0.867 (95% Confidence Interval [CI]:0.709-1.000) in the test set; performance for the whole-rectum region of interest (ROI) was lower (AUC 0.714). DVH-only models showed limited discrimination, and no DVH feature was retained after penalized selection in the multi-omics pipeline. DCA demonstrated the greatest net clinical benefit for the rectal-wall multi-omics model across threshold probabilities 0.20–0.50. Conclusion: A rectal-wall, region-specific multi-omics approach integrating clinical, radiomic, and dose-based descriptors improves prediction of radiotherapy-induced ARP compared with single-modality and whole-rectum analyses. These findings highlight the importance of ROI selection and multi-omics integration for precision toxicity assessment and support future external validation and prospective evaluation.
- 10 March 2026
- Published by SAGE Publications in Technology in Cancer Research & Treatment
- Vol. 25
Open AccessRegion-specific Multi-Omics Modeling for Predicting Acute Radiation-Induced Proctitis in Cervical Cancer Radiotherapy: A Retrospective Analysis
Introduction: To develop and evaluate a multi-omics machine-learning model that integrates clinical variables, dose-volume histogram (DVH) metrics, radiomics, and dosiomics from both the rectum and rectal wall regions of interest (ROIs) to improve prediction of acute radiation proctitis (ARP) in cervical cancer patients receiving radiotherapy. Methods: In this single-center retrospective cohort, 107 cervical cancer patients were randomly split into a training set (n = 85) and a testing set (n = 22) in an 8:2 ratio. Radiomic were extracted from planning CT, and dosiomic features from 3-D RT-dose distributions, for both rectum and rectal wall ROIs. Features were z-score standardized; redundant features were filtered by Pearson correlation, followed by least absolute shrinkage and selection operator (LASSO) for selection. Support Vector Machine (SVM) and Multilayer Perceptron (MLP) classifiers were trained using stratified five-fold cross-validation within the training set. Model performance was assessed on the held-out test set using receiver operating characteristic (ROC) analysis; clinical utility was evaluated with decision-curve analysis (DCA). The primary endpoint was Common Terminology Criteria for Adverse Events (CTCAE,version 5.0) grade ≥2 ARP. Results: Multi-omics fusion outperformed single-modality models across ROIs and classifiers. The rectal-wall multi-omics SVM achieved the best discrimination with AUC 0.867 (95% Confidence Interval [CI]:0.709-1.000) in the test set; performance for the whole-rectum region of interest (ROI) was lower (AUC 0.714). DVH-only models showed limited discrimination, and no DVH feature was retained after penalized selection in the multi-omics pipeline. DCA demonstrated the greatest net clinical benefit for the rectal-wall multi-omics model across threshold probabilities 0.20–0.50. Conclusion: A rectal-wall, region-specific multi-omics approach integrating clinical, radiomic, and dose-based descriptors improves prediction of radiotherapy-induced ARP compared with single-modality and whole-rectum analyses. These findings highlight the importance of ROI selection and multi-omics integration for precision toxicity assessment and support future external validation and prospective evaluation.
- Open Access
Effect of Annealing on Vacancy-Type Defects and Heterogeneous Cu Precipitation Behavior in Fe60Cr12Mn8Cu15Mo3V2 Alloy
This study systematically investigates the evolution of vacancy-type defects and heterogeneous Cu nanoprecipitates in an Fe60Cr12Mn8Cu15Mo3V2 (at%) multi-principal element alloy during thermal processing, utilizing Positron annihilation lifetime spectroscopy (PAS), coincidence Doppler broadening (CDB) spectroscopy, and transmission electron microscopy (TEM). The results show that the alloy exhibited a dual-phase coexistence structure of Body-Centered Cubic (BCC) and Face-Centered Cubic (FCC). The CDB results show that the density of heterogeneous Cu precipitates gradually increases with annealing temperature. Compared to the as-cast alloy, the precipitates annealed at 773 K exhibit a significantly reduced size (approximately 33 nm) with higher density. The PAS results demonstrate that gradual migration and aggregation of monovacancies at 573 K form vacancy clusters, while contraction and dissociation of these clusters dominate at 673 K. Within the temperature range of 773–973 K, the dynamic equilibrium between the aggregation and decomposition of vacancy clusters maintains stable annihilation characteristics with minimal lifetime changes.
Open AccessEffect of Annealing on Vacancy-Type Defects and Heterogeneous Cu Precipitation Behavior in Fe60Cr12Mn8Cu15Mo3V2 Alloy
This study systematically investigates the evolution of vacancy-type defects and heterogeneous Cu nanoprecipitates in an Fe60Cr12Mn8Cu15Mo3V2 (at%) multi-principal element alloy during thermal processing, utilizing Positron annihilation lifetime spectroscopy (PAS), coincidence Doppler broadening (CDB) spectroscopy, and transmission electron microscopy (TEM). The results show that the alloy exhibited a dual-phase coexistence structure of Body-Centered Cubic (BCC) and Face-Centered Cubic (FCC). The CDB results show that the density of heterogeneous Cu precipitates gradually increases with annealing temperature. Compared to the as-cast alloy, the precipitates annealed at 773 K exhibit a significantly reduced size (approximately 33 nm) with higher density. The PAS results demonstrate that gradual migration and aggregation of monovacancies at 573 K form vacancy clusters, while contraction and dissociation of these clusters dominate at 673 K. Within the temperature range of 773–973 K, the dynamic equilibrium between the aggregation and decomposition of vacancy clusters maintains stable annihilation characteristics with minimal lifetime changes.
- 3 May 2022
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 566
Thermal evolution of microdefects in He ion irradiated W-Ni-Feheavy alloy
- 3 May 2022
- Published by Elsevier in Journal of Nuclear Materials
- Vol. 566
Thermal evolution of microdefects in He ion irradiated W-Ni-Feheavy alloy
- Open Access
- 5 January 2022
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 54 (6) , 2048-2054
Uncertainty quantification of the power control system of a small PWR with coolant temperature perturbation
- 5 January 2022
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 54 (6) , 2048-2054
Open AccessUncertainty quantification of the power control system of a small PWR with coolant temperature perturbation
- Open Access
Effects of He-D Interaction on Irradiation-Induced Swelling in Fe9Cr Alloys
The atomic-scale defects such as (deuterium, helium)-vacancy clusters in nuclear energy materials are one of the causes for the deterioration of the macroscopic properties of materials. Unfortunately, they cannot be observed by transmission electron microscopy (TEM) before they grow to the nanometer scale. Positron annihilation spectroscopy (PAS) has been proven to be sensitive to open-volume defects, and could characterize the evolution of the size and concentration of the vacancy-like nanoclusters. We have investigated the effects of He-D interaction on the formation of nanoscale cavities in Fe9Cr alloys by PAS and TEM. The results show that small-sized bubbles are formed in the specimen irradiated with 5 × 1016 He+/cm2, and the subsequent implanted D-ions contribute to the growth of these helium bubbles. The most likely reason is that helium bubbles previously formed in the sample captured deuterium injected later, causing bubbles to grow. In the lower dose He-irradiated samples, a large number of small dislocations and vacancies are generated and form helium-vacancy clusters with the helium atoms.
Open AccessEffects of He-D Interaction on Irradiation-Induced Swelling in Fe9Cr Alloys
The atomic-scale defects such as (deuterium, helium)-vacancy clusters in nuclear energy materials are one of the causes for the deterioration of the macroscopic properties of materials. Unfortunately, they cannot be observed by transmission electron microscopy (TEM) before they grow to the nanometer scale. Positron annihilation spectroscopy (PAS) has been proven to be sensitive to open-volume defects, and could characterize the evolution of the size and concentration of the vacancy-like nanoclusters. We have investigated the effects of He-D interaction on the formation of nanoscale cavities in Fe9Cr alloys by PAS and TEM. The results show that small-sized bubbles are formed in the specimen irradiated with 5 × 1016 He+/cm2, and the subsequent implanted D-ions contribute to the growth of these helium bubbles. The most likely reason is that helium bubbles previously formed in the sample captured deuterium injected later, causing bubbles to grow. In the lower dose He-irradiated samples, a large number of small dislocations and vacancies are generated and form helium-vacancy clusters with the helium atoms.
- 1 February 2017
- Published by Wiley in Physica Status Solidi (a)
- Vol. 214 (5)
Formation and recovery of Cu precipitates in Fe–Cu model alloys under varying heat treatment
Fe–Cu systems, model alloys of nuclear reactor pressure vessel (RPV) steels, heat treatments by annealing and quenching, are studied by the positron annihilation technique and high‐resolution SEM. The different effect of annealing and quenching on the formation of Cu precipitates was discussed. The ultrafine Cu precipitates, which are formed in Fe–x wt.% Cu (x = 1.0 and 1.5) alloys after thermal annealing, are observed clearly and no obvious Cu precipitates were found in the quenched alloys. The annealing temperature has an effect on the concentration of Cu precipitates, which leads to a change of the proportion of positron annihilation in the Cu precipitates, and this can be reflected by the change of the W parameters. Positron annihilation Doppler broadening spectroscopy results show that Cu precipitates formed during annealing at 1173 K still exist when the annealing temperature is higher than 1453 K. SEM measurements were used to observe the size and the distribution of Cu precipitates in the samples, after using different annealing temperature.
- 1 February 2017
- Published by Wiley in Physica Status Solidi (a)
- Vol. 214 (5)
Formation and recovery of Cu precipitates in Fe–Cu model alloys under varying heat treatment
Fe–Cu systems, model alloys of nuclear reactor pressure vessel (RPV) steels, heat treatments by annealing and quenching, are studied by the positron annihilation technique and high‐resolution SEM. The different effect of annealing and quenching on the formation of Cu precipitates was discussed. The ultrafine Cu precipitates, which are formed in Fe–x wt.% Cu (x = 1.0 and 1.5) alloys after thermal annealing, are observed clearly and no obvious Cu precipitates were found in the quenched alloys. The annealing temperature has an effect on the concentration of Cu precipitates, which leads to a change of the proportion of positron annihilation in the Cu precipitates, and this can be reflected by the change of the W parameters. Positron annihilation Doppler broadening spectroscopy results show that Cu precipitates formed during annealing at 1173 K still exist when the annealing temperature is higher than 1453 K. SEM measurements were used to observe the size and the distribution of Cu precipitates in the samples, after using different annealing temperature.