M A Daeian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
M A Daeian has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
Ali Moosavi
Sharif University of Technology
1 shared publicationAli Nouri-Borujerdi
Sharif University of Technology
1 shared publicationEhsan Taghvaei
Sharif University of Technology
1 shared publication
Latest Publications
- 9 February 2017
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 50 (10) , 105301
Drag reduction in a channel with microstructure grooves using the lattice Boltzmann method
Using the Shan–Chen lattice Boltzmann multi-phase model, we investigate the effect of adding microstructured grooves to the walls of a 2D parallel-plate channel on the pressure drop in the channel. The effects of the size of the grooves on the pressure drop in the channel were considered. It was observed that the pitch of the grooves has a considerable effect on the pressure drop in the channel, and even for some values of the pitch we observe an increase in the pressure drop. As the pitch decreases, a lower pressure drop is achieved. The results also show that as the ratio of the solid–liquid contact surface to the whole surface is decreased, the pressure drop decreases. It is also observed that the grooves should be deep enough to yield drag reduction, otherwise it would have a negative effect.
- 9 February 2017
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 50 (10) , 105301
Drag reduction in a channel with microstructure grooves using the lattice Boltzmann method
Using the Shan–Chen lattice Boltzmann multi-phase model, we investigate the effect of adding microstructured grooves to the walls of a 2D parallel-plate channel on the pressure drop in the channel. The effects of the size of the grooves on the pressure drop in the channel were considered. It was observed that the pitch of the grooves has a considerable effect on the pressure drop in the channel, and even for some values of the pitch we observe an increase in the pressure drop. As the pitch decreases, a lower pressure drop is achieved. The results also show that as the ratio of the solid–liquid contact surface to the whole surface is decreased, the pressure drop decreases. It is also observed that the grooves should be deep enough to yield drag reduction, otherwise it would have a negative effect.