Junjian Fu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Junjian Fu has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Ke Liu
School of Materials Science and Engineering, Beijing University of Technology, Beijing 100124, China
2 shared publications - Shubo Li
Faculty of Materials and Manufacturing, Beijing University of Technology, Beijing 100124, China
2 shared publications - Wenbo Du
College of Materials Science and Engineering, Beijing University of Technology, Beijing 100124, China
2 shared publications - Xian Du
Beijing Univ Technol, Coll Mat Sci & Engn, 100 Ping Le Yuan, Beijing 100124, Peoples R China
2 shared publications - Zhaohui Wang
College of Materials Science and Engineering, Beijing University of Technology, Beijing, China
2 shared publications - Adil Mansoor
College of Physics and Optoelectronic Engineering, Shenzhen University, Shenzhen, People’s Republic of China
1 shared publication
Latest Publications
- Open Access
Effect of the Ca2Mg6Zn3 Phase on the Corrosion Behavior of Biodegradable Mg-4.0Zn-0.2Mn-xCa Alloys in Hank’s Solution
The effect of the Ca2Mg6Zn3 phase on the corrosion behavior of biodegradable Mg-4.0Zn-0.2Mn-xCa (ZM-xCa, x = 0.1, 0.3, 0.5 and 1.0 wt.%) alloys in Hank’s solution was investigated with respect to phase spacing, morphology, distribution and volume fraction. With the increase in Ca addition, the volume fraction of the Ca2Mg6Zn3 phase increased from 2.5% to 7.6%, while its spacing declined monotonically from 43 μm to 30 μm. The Volta potentials of secondary phases relative to the Mg matrix were measured by using scanning kelvin probe force microscopy (SKPFM). The results show that the Volta potential of the intragranular spherical Ca2Mg6Zn3 phase (+109 mV) was higher than that of the dendritic Ca2Mg6Zn3 phase (+80 mV). It is suggested that the Ca2Mg6Zn3 acted as a cathode to accelerate the corrosion process due to the micro-galvanic effect. The corrosion preferred to occur around the spherical Ca2Mg6Zn3 phase at the early stage and developed into the intragranular region. The corrosion rate increased slightly with increasing Ca content from 0.1 wt.% to 0.5 wt.% because of the enhanced micro-galvanic corrosion effect. The decrease in the phase spacing and sharp increase in the secondary phase content resulted in a dramatic increase in the corrosion rate of the ZM-1.0Ca alloy.
Open AccessEffect of the Ca2Mg6Zn3 Phase on the Corrosion Behavior of Biodegradable Mg-4.0Zn-0.2Mn-xCa Alloys in Hank’s Solution
The effect of the Ca2Mg6Zn3 phase on the corrosion behavior of biodegradable Mg-4.0Zn-0.2Mn-xCa (ZM-xCa, x = 0.1, 0.3, 0.5 and 1.0 wt.%) alloys in Hank’s solution was investigated with respect to phase spacing, morphology, distribution and volume fraction. With the increase in Ca addition, the volume fraction of the Ca2Mg6Zn3 phase increased from 2.5% to 7.6%, while its spacing declined monotonically from 43 μm to 30 μm. The Volta potentials of secondary phases relative to the Mg matrix were measured by using scanning kelvin probe force microscopy (SKPFM). The results show that the Volta potential of the intragranular spherical Ca2Mg6Zn3 phase (+109 mV) was higher than that of the dendritic Ca2Mg6Zn3 phase (+80 mV). It is suggested that the Ca2Mg6Zn3 acted as a cathode to accelerate the corrosion process due to the micro-galvanic effect. The corrosion preferred to occur around the spherical Ca2Mg6Zn3 phase at the early stage and developed into the intragranular region. The corrosion rate increased slightly with increasing Ca content from 0.1 wt.% to 0.5 wt.% because of the enhanced micro-galvanic corrosion effect. The decrease in the phase spacing and sharp increase in the secondary phase content resulted in a dramatic increase in the corrosion rate of the ZM-1.0Ca alloy.
- Open Access
- 10 March 2017
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 182 (1) , 012053
Microstructure and mechanical properties of the as-cast Mg-Zn-Mn-Ca alloys
- 10 March 2017
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 182 (1) , 012053
Open AccessMicrostructure and mechanical properties of the as-cast Mg-Zn-Mn-Ca alloys