Larisa Ruleva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Larisa Ruleva has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
S I Solodovnikov
Ishlinsky Institute for Problems in Mechanics RAS, Vernadsky prospekt 101(1), Moscow, 119526, Russia
10 shared publicationsS T Surzhikov
Ishlinsky Institute for Problems in Mechanics RAS, Vernadsky prospekt 101(1), Moscow, 119526, Russia
7 shared publicationsM A Kotov
Ishlinsky Institute for Problems in Mechanics RAS, Vernadsky prospekt 101(1), Moscow, 119526, Russia
6 shared publicationsS. I. Solodovnikov
Ishlinsky Institute for Problems in Mechanics of the Russian Academyof Sciences, Moscow, Russia
6 shared publications- Mikhail A. Kotov
Ishlinsky Institute for Problems in Mechanics RAS , Moscow
5 shared publications P V Kozlov
Ishlinsky Institute for Problems in Mechanics RAS, Vernadsky prospekt 101(1), Moscow, 119526, Russia
3 shared publications
Latest Publications
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (7) , 139
Experimental Studies of the Glow Discharge on Flat Electrodes in a Flow
The interaction of the glow discharge on a flat plate with air flow in a diaphragmless shock wind tunnel is studied experimentally. As compared to the opposite directional electrodes, longer burning of discharge on the flat plate is revealed. The effect of magnetic induction on plasma luminescence and flow parameters is shown. Video frames of the discharge are given.
- 1 December 2025
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 60 (7) , 139
Experimental Studies of the Glow Discharge on Flat Electrodes in a Flow
The interaction of the glow discharge on a flat plate with air flow in a diaphragmless shock wind tunnel is studied experimentally. As compared to the opposite directional electrodes, longer burning of discharge on the flat plate is revealed. The effect of magnetic induction on plasma luminescence and flow parameters is shown. Video frames of the discharge are given.
- 1 October 2024
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 59 (5) , 1669-1676
Experimental Studies of Gas-Discharge Plasma in Air Flow
This paper presents the combustion modes of gas-discharge plasma and its quasi-stationary state in the aerodynamic unit of a laboratory facility. A research model is shown in the form of a flat channel with electrodes, pressure, and heat flow sensors. The mutual influence of gas-discharge plasma and air flow at a Mach speed of M = 2.9 is investigated. Transformation of the gas-discharge column glow in the flow and shadow patterns of shock-wave structures are recorded on video. We show the influence of the discharge energy deposition on the state of the discharge column glow and on the flow. We demonstrate the existence of a normal glow discharge in the flow, an increase in heating, and a decrease in pressure on the surface of the model.
- 1 October 2024
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 59 (5) , 1669-1676
Experimental Studies of Gas-Discharge Plasma in Air Flow
This paper presents the combustion modes of gas-discharge plasma and its quasi-stationary state in the aerodynamic unit of a laboratory facility. A research model is shown in the form of a flat channel with electrodes, pressure, and heat flow sensors. The mutual influence of gas-discharge plasma and air flow at a Mach speed of M = 2.9 is investigated. Transformation of the gas-discharge column glow in the flow and shadow patterns of shock-wave structures are recorded on video. We show the influence of the discharge energy deposition on the state of the discharge column glow and on the flow. We demonstrate the existence of a normal glow discharge in the flow, an increase in heating, and a decrease in pressure on the surface of the model.
- 1 August 2024
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 59 (4) , 996-1003
Measuring Heat Flux Using Calorimetric Sensors
This article presents the results of the heat flux measurement on a flat channel plate and a cylinder within a gas stream. The developed calorimetric sensors are used simultaneously with the coaxial thermocouple. The resulting measurement of heat flux show that calorimetric sensors can be used in test modes.
- 1 August 2024
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 59 (4) , 996-1003
Measuring Heat Flux Using Calorimetric Sensors
This article presents the results of the heat flux measurement on a flat channel plate and a cylinder within a gas stream. The developed calorimetric sensors are used simultaneously with the coaxial thermocouple. The resulting measurement of heat flux show that calorimetric sensors can be used in test modes.
- 1 December 2023
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 58 (8) , 1577-1583
Experimental Studies of Shock Wave Formation in a Diaphragmless Shock Tube
Shockwave processes in a shock tube equipped with a high-speed low-inertia electromagnetic pneumatic valve are experimentally investigated. Graphs of the pressure sensor signals in the shock tube channel are given. The dependence of the valve opening time on the pressure in the high and low gas density chambers is shown. A physical simulation of the valve operation at the initial moments of its opening with the formation of a shock wave is carried out.
- 1 December 2023
- Published by Pleiades Publishing Ltd in Fluid Dynamics
- Vol. 58 (8) , 1577-1583
Experimental Studies of Shock Wave Formation in a Diaphragmless Shock Tube
Shockwave processes in a shock tube equipped with a high-speed low-inertia electromagnetic pneumatic valve are experimentally investigated. Graphs of the pressure sensor signals in the shock tube channel are given. The dependence of the valve opening time on the pressure in the high and low gas density chambers is shown. A physical simulation of the valve operation at the initial moments of its opening with the formation of a shock wave is carried out.
- Open Access
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2549 (1)
Preparation for test experiments in a hypersonic aerodynamic shock tube
The laboratory installation "Hypersonic Aerodynamic Shock Tube" is preparing for test experiments. The characteristic modes for experimental tests are based on the results of numerical simulation of gas flow parameters in the working and measuring parts in a hypersonic shock wind tunnel are identified. The parameters in the low-pressure channel and at the nozzle inlet are experimentally was investigated. An increase in the pressure in the incident and reflected shock waves at the nozzle inlet was shown with an increase in the pressure in the low-pressure chamber. At the maximum values of the stagnation pressure in the plug at the entrance to the nozzle, the glow of ionized gas was observed. Experimental graphs of the pressure at the nozzle inlet and the ionization signals were presented. The temperature of the region behind the nozzle section and at a distance from it when the aerodynamic unit was evacuated to different vacuum depths is measured. Certified sensors and laboratory-made sensors located on the plate were used. The acceptability of using laboratory calorimetric sensors was shown. Fragments of visualization of shock-wave structures behind the nozzle section were presented.
- 1 January 2023
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2549 (1)
Open AccessPreparation for test experiments in a hypersonic aerodynamic shock tube
The laboratory installation "Hypersonic Aerodynamic Shock Tube" is preparing for test experiments. The characteristic modes for experimental tests are based on the results of numerical simulation of gas flow parameters in the working and measuring parts in a hypersonic shock wind tunnel are identified. The parameters in the low-pressure channel and at the nozzle inlet are experimentally was investigated. An increase in the pressure in the incident and reflected shock waves at the nozzle inlet was shown with an increase in the pressure in the low-pressure chamber. At the maximum values of the stagnation pressure in the plug at the entrance to the nozzle, the glow of ionized gas was observed. Experimental graphs of the pressure at the nozzle inlet and the ionization signals were presented. The temperature of the region behind the nozzle section and at a distance from it when the aerodynamic unit was evacuated to different vacuum depths is measured. Certified sensors and laboratory-made sensors located on the plate were used. The acceptability of using laboratory calorimetric sensors was shown. Fragments of visualization of shock-wave structures behind the nozzle section were presented.
- Open Access
- 14 September 2022
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 362, 01025
Effect of vacuuming on gas-dynamic parameters
The peculiarity of end-to-end temperature registration on models at the beginning of the experiment, then during high-speed pumping of the test unit into a vacuum and when a high-speed flow is applied to the model is experimentally revealed. The dependence of temperature registration on the vacuum depth and the independence of heat flow registration is shown.
- 14 September 2022
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 362, 01025
Open AccessEffect of vacuuming on gas-dynamic parameters
The peculiarity of end-to-end temperature registration on models at the beginning of the experiment, then during high-speed pumping of the test unit into a vacuum and when a high-speed flow is applied to the model is experimentally revealed. The dependence of temperature registration on the vacuum depth and the independence of heat flow registration is shown.
- Open Access
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012015
Normal glow discharge in nitrogen and inert gases between flat electrodes with distance of 10 mm
Experimental study of normal glow discharge in the installation of IPMech RAS is continued. For problem formulation of discharge behavior between “infinite” electrodes investigations were carried out at a distance of 10 mm between flat electrodes with much greater diameter in the pressure range 1÷10 Torr. Dependencies of the characteristic size of the glow region on the discharge current in helium, argon and nitrogen were obtained. Spectral characteristics were constructed. Rotational and vibrational temperatures of the discharge were estimated.
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012015
Open AccessNormal glow discharge in nitrogen and inert gases between flat electrodes with distance of 10 mm
Experimental study of normal glow discharge in the installation of IPMech RAS is continued. For problem formulation of discharge behavior between “infinite” electrodes investigations were carried out at a distance of 10 mm between flat electrodes with much greater diameter in the pressure range 1÷10 Torr. Dependencies of the characteristic size of the glow region on the discharge current in helium, argon and nitrogen were obtained. Spectral characteristics were constructed. Rotational and vibrational temperatures of the discharge were estimated.
- Open Access
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012016
Parameters of the air flow formed by the interchangeable nozzles with the transformed critical part
The results of studies of the nozzle block functioning with interchangeable nozzles at the hypersonic aerodynamic shock tube (HAST) are presented. Air flow parameters from the elongated nozzle and of variety of critical cross-sections of the inlet of the nozzle were calculated. The dependence of the influence of the nozzle critical section size on the uniformity of incoming flow and speed was shown. The calculated pressure values were compared with those measured experimentally at the nozzle exit cut and at different distances from it.
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012016
Open AccessParameters of the air flow formed by the interchangeable nozzles with the transformed critical part
The results of studies of the nozzle block functioning with interchangeable nozzles at the hypersonic aerodynamic shock tube (HAST) are presented. Air flow parameters from the elongated nozzle and of variety of critical cross-sections of the inlet of the nozzle were calculated. The dependence of the influence of the nozzle critical section size on the uniformity of incoming flow and speed was shown. The calculated pressure values were compared with those measured experimentally at the nozzle exit cut and at different distances from it.
- Open Access
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012020
Normal Glow Discharge between Flat Electrodes Arranged in the Same Plane
The new arrangement of the anode and the cathode in one plane was made. This configuration was tested in the experiment series. Current - voltage characteristics and glow discharge visualizations were received. Pressure and electric parameters were determined for next experimental studies of these processes.
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012020
Open AccessNormal Glow Discharge between Flat Electrodes Arranged in the Same Plane
The new arrangement of the anode and the cathode in one plane was made. This configuration was tested in the experiment series. Current - voltage characteristics and glow discharge visualizations were received. Pressure and electric parameters were determined for next experimental studies of these processes.
- Open Access
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012014
Gas dynamic process formation in reflected shock tunnels and its validation purposes by hypersonic aerodynamic shock tube example
The work for ensure the possibility of validation results for numerical simulation of gas-dynamic processes in a wide range with the use of modern techniques and certified measuring instruments are continued at the hypersonic aerodynamic shock tube facility. The method of precise experimental determination of the dynamic pressure at the critical section of the nozzle was tested. The results of calculations of the pressure field behind the section of the regular and elongated nozzles are validated. Measurements of the stagnation pressure before the nozzle were obtained experimentally.
- 1 June 2019
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1250 (1) , 012014
Open AccessGas dynamic process formation in reflected shock tunnels and its validation purposes by hypersonic aerodynamic shock tube example
The work for ensure the possibility of validation results for numerical simulation of gas-dynamic processes in a wide range with the use of modern techniques and certified measuring instruments are continued at the hypersonic aerodynamic shock tube facility. The method of precise experimental determination of the dynamic pressure at the critical section of the nozzle was tested. The results of calculations of the pressure field behind the section of the regular and elongated nozzles are validated. Measurements of the stagnation pressure before the nozzle were obtained experimentally.