Michael K. Yakes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Michael K. Yakes has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Kenneth J. Schmieder
US Naval Research Laboratory, Washington, DC, USA
2 shared publications - Matthew P. Lumb
George Washington University, Washington, DC, USA
2 shared publications - Stephanie Tomasulo
US Naval Res Lab, Washington, DC 20375 USA
2 shared publications - Eric A. Armour
Veeco Instruments, Somerset, NJ, USA
1 shared publication - James E. Moore
School of Electrical and Computer Engineering, Purdue University, West Lafayette, IN, USA
1 shared publication - Jesse A. Frantz
Naval Research Laboratory, 4555 Overlook Ave SW, Washington, DC 20375, USA
1 shared publication
Latest Publications
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 8 (6) , 1641-1646
Photovoltaics on Transfer Printed III-V Virtual Substrates
We demonstrate a novel concept for III-V engineered substrate cost reduction that does not rely on chemical-mechanical polishing or low-throughput release layer etching. With the potential for significant reduction to III-V substrate cost, the details of this concept are provided, as well as a demonstration of III-V devices grown on a membrane removed from its source substrate and bonded to a non-native target handle. The GaAs solar cell on membrane one-sun and concentration AM1.5 efficiencies register 16.2% and 19.1%, respectively, prior to the application of anti-reflection coating. This is a discrepancy of 2% (one-sun) and 1.2% (concentration) absolute versus a nominally identical control GaAs device, indicating the capability for high performance at reduced cost.
- 1 October 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 8 (6) , 1641-1646
Photovoltaics on Transfer Printed III-V Virtual Substrates
We demonstrate a novel concept for III-V engineered substrate cost reduction that does not rely on chemical-mechanical polishing or low-throughput release layer etching. With the potential for significant reduction to III-V substrate cost, the details of this concept are provided, as well as a demonstration of III-V devices grown on a membrane removed from its source substrate and bonded to a non-native target handle. The GaAs solar cell on membrane one-sun and concentration AM1.5 efficiencies register 16.2% and 19.1%, respectively, prior to the application of anti-reflection coating. This is a discrepancy of 2% (one-sun) and 1.2% (concentration) absolute versus a nominally identical control GaAs device, indicating the capability for high performance at reduced cost.
- 1 August 2018
- Published by Cambridge University Press (CUP) in Microscopy and Microanalysis
- Vol. 24 (S1) , 398-399
Evaluating Compositional Variation in InGaAs Random Alloys Using Atom Probe Tomography
- 1 August 2018
- Published by Cambridge University Press (CUP) in Microscopy and Microanalysis
- Vol. 24 (S1) , 398-399
Evaluating Compositional Variation in InGaAs Random Alloys Using Atom Probe Tomography
- 16 May 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 121 (19)
Surface diffusion measurements of In on InGaAs enabled by droplet epitaxy
Surface diffusion is a critical parameter for non-equilibrium growth techniques such as molecular beam epitaxy. However, very little is known about diffusion rates of individual cations in a mixed cation material. Using droplet epitaxy as the growth technique, we isolate the diffusivity prefactor (D0) and activation energy (EA) of indium on the surface of In0.53Ga0.47As/InP(100). We report two regimes of indium diffusivity under As2-rich conditions: above and below the droplet deposition temperature of 300 °C, corresponding to a change in surface reconstruction. We also discuss methods of extracting the indium diffusion parameters on metal-rich surfaces using droplet epitaxy and nucleation theory. The obtained diffusion parameters are compared to previous work in the literature and could be employed to optimize growth conditions for non-equilibrium crystal growth.
- 16 May 2017
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 121 (19)
Surface diffusion measurements of In on InGaAs enabled by droplet epitaxy
Surface diffusion is a critical parameter for non-equilibrium growth techniques such as molecular beam epitaxy. However, very little is known about diffusion rates of individual cations in a mixed cation material. Using droplet epitaxy as the growth technique, we isolate the diffusivity prefactor (D0) and activation energy (EA) of indium on the surface of In0.53Ga0.47As/InP(100). We report two regimes of indium diffusivity under As2-rich conditions: above and below the droplet deposition temperature of 300 °C, corresponding to a change in surface reconstruction. We also discuss methods of extracting the indium diffusion parameters on metal-rich surfaces using droplet epitaxy and nucleation theory. The obtained diffusion parameters are compared to previous work in the literature and could be employed to optimize growth conditions for non-equilibrium crystal growth.
- 27 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 7 (1) , 340-346
Effect of Growth Temperature on GaAs Solar Cells at High MOCVD Growth Rates
Increasing epitaxial growth rate is an important path toward III-V solar cell cost reductions; however, photovoltaic device performance has been shown to degrade with increasing growth rate. In this study, gallium arsenide (GaAs) material has been deposited via metal-organic chemical vapor deposition (MOCVD) at growth rates varying between 14 and 60 μm/h. Deep-level transient spectroscopy is utilized to elucidate an exponential rise in EL2 trap density as a function of growth rate when all other growth conditions are held constant. Evidence is provided that this EL2 defect is responsible for limiting the Shockley-Read-Hall (SRH) lifetime of very high growth rate solar cells. The effect of growth temperature on devices at high growth rate is subsequently investigated as a strategy to reduce trap density and improve solar cell performance. From this investigation, EL2 trap density is suppressed, and single-junction on-substrate GaAs solar cells grown at 60 μm/h are reported with 1.01 V 1-sun open-circuit voltage and 23.8% AM1.5G efficiency.
- 27 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 7 (1) , 340-346
Effect of Growth Temperature on GaAs Solar Cells at High MOCVD Growth Rates
Increasing epitaxial growth rate is an important path toward III-V solar cell cost reductions; however, photovoltaic device performance has been shown to degrade with increasing growth rate. In this study, gallium arsenide (GaAs) material has been deposited via metal-organic chemical vapor deposition (MOCVD) at growth rates varying between 14 and 60 μm/h. Deep-level transient spectroscopy is utilized to elucidate an exponential rise in EL2 trap density as a function of growth rate when all other growth conditions are held constant. Evidence is provided that this EL2 defect is responsible for limiting the Shockley-Read-Hall (SRH) lifetime of very high growth rate solar cells. The effect of growth temperature on devices at high growth rate is subsequently investigated as a strategy to reduce trap density and improve solar cell performance. From this investigation, EL2 trap density is suppressed, and single-junction on-substrate GaAs solar cells grown at 60 μm/h are reported with 1.01 V 1-sun open-circuit voltage and 23.8% AM1.5G efficiency.