Javaid Akhtar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Javaid Akhtar has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Naseer Sheikh
Centre for Coal Technology, University of the Punjab, Lahore Pakistan
4 shared publications- Khurram Shahzad
Centre for Coal Technology, University of the Punjab, Lahore 54000, Pakistan
2 shared publications Shahid Munir
Centre for Coal Technology, University of the Punjab, Pakistan, Lahore
2 shared publications- Abrar Inayat
Biomass and Bioenergy Research Group, Center for Sustainable Energy and Power Systems Research, Research Institute of Sciences and Engineering, University of Sharjah, Sharjah 27272, United Arab Emirates
1 shared publication - Arshid Mahmood Ali
Department of Chemical & Materials Engineering, Faculty of Engineering, King Abdulaziz University, Jeddah, Saudi Arabia
1 shared publication Asif Khan
Centre for Coal Technology, University of the Punjab, Pakistan, Lahore
1 shared publication
Latest Publications
- Open Access
Torrefaction and Thermochemical Properties of Agriculture Residues
In this study, the densification of three agriculture waste biomasses (corn cobs, cotton stalks, and sunflower) is investigated using the torrefaction technique. The samples were pyrolyzed under mild temperature conditions (200–320 °C) and at different residence times (10 min–60 min). The thermal properties of the obtained bio-char samples were analyzed via thermo-gravimetric analysis (TGA). Compositional analysis of the torrefied samples was also carried out to determine the presence of hemicellulose, cellulose, and lignin contents. According to the results of this study, optimum temperature conditions were found to be 260 °C–300 °C along with a residence time of 20 min–30 min. Based on the composition analysis, it was found that biochar contains more lignin and celluloses and lower hemicellulose contents than do the original samples. The removal of volatile hemicelluloses broke the interlocking of biomass building blocks, rendering biochar brittle, grindable, and less reactive. The results of this study would be helpful in bettering our understanding of the conversion of agricultural waste residues into valuable, solid biofuels for use in energy recovery schemes. The optimum temperature condition, residence time, and GCV for torrefied corn cobs were found to be 290 °C, 20 min, and 5444 kcal/kg, respectively. The optimum temperature condition, residence time, and GCV for torrefied cotton balls were found to be 270 °C, 30 min, and 4481 Kcal/kg, respectively. In the case of sunflower samples, the mass yield of the torrefied sample decreased from 85% to 71% by increasing the residence time from 10 min to 60 min, respectively.
Open AccessTorrefaction and Thermochemical Properties of Agriculture Residues
In this study, the densification of three agriculture waste biomasses (corn cobs, cotton stalks, and sunflower) is investigated using the torrefaction technique. The samples were pyrolyzed under mild temperature conditions (200–320 °C) and at different residence times (10 min–60 min). The thermal properties of the obtained bio-char samples were analyzed via thermo-gravimetric analysis (TGA). Compositional analysis of the torrefied samples was also carried out to determine the presence of hemicellulose, cellulose, and lignin contents. According to the results of this study, optimum temperature conditions were found to be 260 °C–300 °C along with a residence time of 20 min–30 min. Based on the composition analysis, it was found that biochar contains more lignin and celluloses and lower hemicellulose contents than do the original samples. The removal of volatile hemicelluloses broke the interlocking of biomass building blocks, rendering biochar brittle, grindable, and less reactive. The results of this study would be helpful in bettering our understanding of the conversion of agricultural waste residues into valuable, solid biofuels for use in energy recovery schemes. The optimum temperature condition, residence time, and GCV for torrefied corn cobs were found to be 290 °C, 20 min, and 5444 kcal/kg, respectively. The optimum temperature condition, residence time, and GCV for torrefied cotton balls were found to be 270 °C, 30 min, and 4481 Kcal/kg, respectively. In the case of sunflower samples, the mass yield of the torrefied sample decreased from 85% to 71% by increasing the residence time from 10 min to 60 min, respectively.
- 18 October 2017
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 39 (20) , 1999-2005
Reverse flotation of cut-of-grade of Lakhra coal
The selective mining activities have generated a huge quantity of poor grade coal that is rich in mineral matter and sulfur content and has piled up in whole mining site at Lakhra. This highly oxidized and mineral matter rich coal has been upgraded by reverse floatation. Three process parameters such as pH (7, 8, 9, 10, 11), particle mesh size (60, 100, 150, 200), and % solids (10, 15, 20, 25, 30) in flotation pulp have been investigated with respect to their effect on sulfur and ash reduction. According to results of this study, parameters such as particle size of 100 mesh (150 µm), pH 9 and 20% solids were found to be optimum removing 63.7% of ash and 72.9% of sulfur from coal and coal recovery of 61.3%. Moreover, the heating value of coal also improved from 3924 kcal/kg to 5500 kcal/kg ~ 40.16% enhancement. The recovery of combustibles and gangue at optimum conditions was found to be 60.31% and 39.1% respectively. The clean coal thus obtained containing 12.7% ash, 1.5% sulfur, and 5500 kcal/kg heating value can be used as an energy source for cement manufacturing, in utility boilers, and production of smokeless briquettes for domestic and industrial use.
- 18 October 2017
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 39 (20) , 1999-2005
Reverse flotation of cut-of-grade of Lakhra coal
The selective mining activities have generated a huge quantity of poor grade coal that is rich in mineral matter and sulfur content and has piled up in whole mining site at Lakhra. This highly oxidized and mineral matter rich coal has been upgraded by reverse floatation. Three process parameters such as pH (7, 8, 9, 10, 11), particle mesh size (60, 100, 150, 200), and % solids (10, 15, 20, 25, 30) in flotation pulp have been investigated with respect to their effect on sulfur and ash reduction. According to results of this study, parameters such as particle size of 100 mesh (150 µm), pH 9 and 20% solids were found to be optimum removing 63.7% of ash and 72.9% of sulfur from coal and coal recovery of 61.3%. Moreover, the heating value of coal also improved from 3924 kcal/kg to 5500 kcal/kg ~ 40.16% enhancement. The recovery of combustibles and gangue at optimum conditions was found to be 60.31% and 39.1% respectively. The clean coal thus obtained containing 12.7% ash, 1.5% sulfur, and 5500 kcal/kg heating value can be used as an energy source for cement manufacturing, in utility boilers, and production of smokeless briquettes for domestic and industrial use.
- 13 September 2017
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- p. 1-7
Co-pyrolysis and hyrdogenation of waste tires and thar coal blends
- 13 September 2017
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- p. 1-7
Co-pyrolysis and hyrdogenation of waste tires and thar coal blends
- 7 July 2017
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 39 (8) , 904-908
Way forward in meeting energy challenges in Pakistan
In this review the energy potential of Pakistan from hydro, coal, wind, solar and nuclear sources has been discussed. The new projects that are being commissioned on coal, wind, solar, hydel and nuclear-based technologies have also been mentioned. The review has also explored the future prospects of the country’s energy requirements. Pakistan has potential to produce 100,000 MW of electricity from Thar coal for 20 years, 56,000 MW of hydroelectricity, 150,000 MW of wind energy and ∼50,000 MW from solar sources. The coal-fired power generation is expected to 11,500 MW in period 2017–2019. The country is moving in the right direction to cater its energy needs. However, there is a need to find local and foreign investment in the country to meet high energy demands in the country in future.
- 7 July 2017
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 39 (8) , 904-908
Way forward in meeting energy challenges in Pakistan
In this review the energy potential of Pakistan from hydro, coal, wind, solar and nuclear sources has been discussed. The new projects that are being commissioned on coal, wind, solar, hydel and nuclear-based technologies have also been mentioned. The review has also explored the future prospects of the country’s energy requirements. Pakistan has potential to produce 100,000 MW of electricity from Thar coal for 20 years, 56,000 MW of hydroelectricity, 150,000 MW of wind energy and ∼50,000 MW from solar sources. The coal-fired power generation is expected to 11,500 MW in period 2017–2019. The country is moving in the right direction to cater its energy needs. However, there is a need to find local and foreign investment in the country to meet high energy demands in the country in future.
- 5 April 2017
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 39 (10) , 1063-1070
Linear regression-based correlations for estimation of high heating values of Pakistani lignite coals
- 5 April 2017
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 39 (10) , 1063-1070
Linear regression-based correlations for estimation of high heating values of Pakistani lignite coals
- Open Access
High Pressure Oxydesulphurisation of Coal—Effect of Oxidizing Agent, Solvent, Shear and Agitator Configuration
The ambient temperature high pressure oxydesulphurisation technique was investigated to reduce the sulphur content. Prince of Wales coal was chosen for this study. The focus of the study was to investigate the reduction of both pyritic and organic sulphur while changing the KMnO4/Coal ratio, agitation speed, agitator configuration, and shear. The effect of different concentrations of acetone as a solvent and effect of particle size on the sulphur removal was also studied by a series of experimental runs at ambient temperature. Heating value recovery was found to be increased with the decreased KMnO4/Coal ratio and with decreased acetone concentration. It was found that sulphur removal was enhanced with the increase in shear using a turbine impeller. The effect of particle size was more significant on the pyritic sulphur removal as compared to the organic sulphur removal while heating value recovery was found to increase with decreased desulphurization tome for both, under atmospheric and high pressure.
Open AccessHigh Pressure Oxydesulphurisation of Coal—Effect of Oxidizing Agent, Solvent, Shear and Agitator Configuration
The ambient temperature high pressure oxydesulphurisation technique was investigated to reduce the sulphur content. Prince of Wales coal was chosen for this study. The focus of the study was to investigate the reduction of both pyritic and organic sulphur while changing the KMnO4/Coal ratio, agitation speed, agitator configuration, and shear. The effect of different concentrations of acetone as a solvent and effect of particle size on the sulphur removal was also studied by a series of experimental runs at ambient temperature. Heating value recovery was found to be increased with the decreased KMnO4/Coal ratio and with decreased acetone concentration. It was found that sulphur removal was enhanced with the increase in shear using a turbine impeller. The effect of particle size was more significant on the pyritic sulphur removal as compared to the organic sulphur removal while heating value recovery was found to increase with decreased desulphurization tome for both, under atmospheric and high pressure.