Ke Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ke Yang has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
Bing Li
5 shared publicationsXin Wang
5 shared publicationsXuanxuan Xu
Shaanxi Key Laboratory for Photoelectric Functional Materials and Devices, Xi'an Technological University, Xi'an 710021, China
3 shared publicationsYanhong Li
3 shared publications- Bing Li
School of Materials Science and Chemical Engineering, Xi’an Technological University, Xi’an 710021, China
2 shared publications - Fengying Chen
College of Chemical Engineering and Modern Materials, Shaanxi Key Laboratory of Comprehensive Utilization of Tailings Resources, Shangluo University, Shangluo 726000, China
2 shared publications
Latest Publications
- Open Access
Collaborative Control Strategy of Megawatt-Level Zinc–Iron Flow Battery Energy Storage System Based on Source–Grid–Load–Storage Integration
The zinc–iron redox battery (ZIRB) has become one of the hot technologies of electrochemical energy storage due to its safety, stability and low cost of the electrolyte. In this paper, a collaborative control strategy for an MW-level zinc–iron flow battery energy storage system is studied, and the operation control and management of the MW-level zinc–iron flow battery energy storage system are coordinated and optimized to improve the operation efficiency of the whole system. The model of the megawatt zinc–iron flow battery energy storage system is established in this paper. A ZIRB state of charge (SOC) estimation method based on least squares (LS) and an extended Kalman filter (EKF) is proposed. Experiments under constant-current discharge show that the proposed LS-EKF method can achieve accurate SOC estimation for the tested ZIRB system, with a maximum estimation error of approximately 2.3%. Experiments show that the proposed algorithm has good accuracy, rapidity and robustness at different SOC initial values. According to SOC differences between battery cells, the coordination strategy of each cell is designed to meet the requirements of frequency modulation while taking into account the safety of battery operation. On this basis, the optimization problem is designed and solved with the goal of optimal frequency modulation effect and battery energy loss, and the collaborative control of the MW-level ZIRB energy storage system is realized.
Open AccessCollaborative Control Strategy of Megawatt-Level Zinc–Iron Flow Battery Energy Storage System Based on Source–Grid–Load–Storage Integration
The zinc–iron redox battery (ZIRB) has become one of the hot technologies of electrochemical energy storage due to its safety, stability and low cost of the electrolyte. In this paper, a collaborative control strategy for an MW-level zinc–iron flow battery energy storage system is studied, and the operation control and management of the MW-level zinc–iron flow battery energy storage system are coordinated and optimized to improve the operation efficiency of the whole system. The model of the megawatt zinc–iron flow battery energy storage system is established in this paper. A ZIRB state of charge (SOC) estimation method based on least squares (LS) and an extended Kalman filter (EKF) is proposed. Experiments under constant-current discharge show that the proposed LS-EKF method can achieve accurate SOC estimation for the tested ZIRB system, with a maximum estimation error of approximately 2.3%. Experiments show that the proposed algorithm has good accuracy, rapidity and robustness at different SOC initial values. According to SOC differences between battery cells, the coordination strategy of each cell is designed to meet the requirements of frequency modulation while taking into account the safety of battery operation. On this basis, the optimization problem is designed and solved with the goal of optimal frequency modulation effect and battery energy loss, and the collaborative control of the MW-level ZIRB energy storage system is realized.
- Open Access
- 26 December 2024
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 26 (1) , 91
Correction: Ke et al. A Comprehensive Investigation into the Crystallology, Molecule, and Quantum Chemistry Properties of Two New Hydrous Long-Chain Dibasic Ammonium Salts CnH2n+8N2O6 (n = 35 and 37). Int. J. Mol. Sci. 2023, 24, 5467
The journal’s Editorial Office and Editorial Board are jointly issuing a resolution and removal of the Journal Notice linked to this article
- 26 December 2024
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 26 (1) , 91
Open AccessCorrection: Ke et al. A Comprehensive Investigation into the Crystallology, Molecule, and Quantum Chemistry Properties of Two New Hydrous Long-Chain Dibasic Ammonium Salts CnH2n+8N2O6 (n = 35 and 37). Int. J. Mol. Sci. 2023, 24, 5467
The journal’s Editorial Office and Editorial Board are jointly issuing a resolution and removal of the Journal Notice linked to this article
- 12 June 2024
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 330, 118477
Role of alumina particles in chemical-mechanical synergies in ruthenium polishing
- 12 June 2024
- Published by Elsevier in Journal of Materials Processing Technology
- Vol. 330, 118477
Role of alumina particles in chemical-mechanical synergies in ruthenium polishing
- Open Access
- 13 March 2023
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 24 (6) , 5467
A Comprehensive Investigation into the Crystallology, Molecule, and Quantum Chemistry Properties of Two New Hydrous Long-Chain Dibasic Ammonium Salts CnH2n+8N2O6 (n = 35 and 37)
Through the salification reaction of carboxylation, successful attachment of the long-chain alkanoic acid to the two ends of 1,3-propanediamine was realized, which enabled the doubling of the long-chain alkanoic acid carbon chain. Hydrous 1,3-propanediamine dihexadecanoate (abbreviated as 3C16) and 1,3-propanediamine diheptadecanoate (abbreviated as 3C17) were synthesized afterward, and their crystal structures were characterized by the X-ray single crystal diffraction technique. By analyzing their molecular and crystal structure, their composition, spatial structure, and coordination mode were determined. Two water molecules played important roles in stabilizing the framework of both compounds. Hirshfeld surface analysis revealed the intermolecular interactions between the two molecules. The 3D energy framework map presented the intermolecular interactions more intuitively and digitally, in which dispersion energy plays a dominant role. DFT calculations were performed to analyze the frontier molecular orbitals (HOMO–LUMO). The energy difference between the HOMO–LUMO is 0.2858 eV and 0.2855 eV for 3C16 and 3C17, respectively. DOS diagrams further confirmed the distribution of the frontier molecular orbitals of 3C16 and 3C17. The charge distributions in the compounds were visualized using a molecular electrostatic potential (ESP) surface. ESP maps indicated that the electrophilic sites are localized around the oxygen atom. The crystallographic data and parameters of quantum chemical calculation in this paper will provide data and theoretical support for the development and application of such materials.
- 13 March 2023
- Published by MDPI AG in International Journal of Molecular Sciences
- Vol. 24 (6) , 5467
Open AccessA Comprehensive Investigation into the Crystallology, Molecule, and Quantum Chemistry Properties of Two New Hydrous Long-Chain Dibasic Ammonium Salts CnH2n+8N2O6 (n = 35 and 37)
Through the salification reaction of carboxylation, successful attachment of the long-chain alkanoic acid to the two ends of 1,3-propanediamine was realized, which enabled the doubling of the long-chain alkanoic acid carbon chain. Hydrous 1,3-propanediamine dihexadecanoate (abbreviated as 3C16) and 1,3-propanediamine diheptadecanoate (abbreviated as 3C17) were synthesized afterward, and their crystal structures were characterized by the X-ray single crystal diffraction technique. By analyzing their molecular and crystal structure, their composition, spatial structure, and coordination mode were determined. Two water molecules played important roles in stabilizing the framework of both compounds. Hirshfeld surface analysis revealed the intermolecular interactions between the two molecules. The 3D energy framework map presented the intermolecular interactions more intuitively and digitally, in which dispersion energy plays a dominant role. DFT calculations were performed to analyze the frontier molecular orbitals (HOMO–LUMO). The energy difference between the HOMO–LUMO is 0.2858 eV and 0.2855 eV for 3C16 and 3C17, respectively. DOS diagrams further confirmed the distribution of the frontier molecular orbitals of 3C16 and 3C17. The charge distributions in the compounds were visualized using a molecular electrostatic potential (ESP) surface. ESP maps indicated that the electrophilic sites are localized around the oxygen atom. The crystallographic data and parameters of quantum chemical calculation in this paper will provide data and theoretical support for the development and application of such materials.
- 25 May 2022
- Published by Springer Nature in China Foundry
- Vol. 19 (3) , 275-280
Plasticity improvement of (Cu43Zr48Al9)98Y2 bulk metallic glass composites by dispersed Ta particles
- 25 May 2022
- Published by Springer Nature in China Foundry
- Vol. 19 (3) , 275-280
Plasticity improvement of (Cu43Zr48Al9)98Y2 bulk metallic glass composites by dispersed Ta particles
- 1 November 2021
- Published by Walter de Gruyter GmbH in International Journal of Materials Research
- Vol. 112 (11) , 860-871
Effect of Gd addition on non-isothermal and isothermal crystallisation of Cu–Zr–Al bulk metallic glass
The crystallisation kinetics of (Cu46Zr46Al8)100–xGdx (x = 0, 2 and 4 at.%) bulk metallic glasses in non-isothermal and isothermal conditions were studied by differential scanning calorimetry and X-ray diffraction. X-ray diffraction analysis shows that the crystallisation product Cu10Zr7 changes to Cu10Zr7 and Cu2Gd in the presence of Gd in non-isothermal and isothermal conditions. Crystallisation activation energy was calculated using the Kissinger and Ozawa methods in non-isothermal conditions and using the Arrhenius model in isothermal conditions. The results show that Gd addition triggers an increase in the energy barrier during crystallisation. The Johnson–Mehl–Avrami model was employed to analyse the crystallisation kinetics in the isothermal condition. The Avrami exponent, n, for Cu46Zr46Al8 is more than 2.5, which demonstrates that the crystallisation is mainly governed by diffusion-controlled three-dimensional growth with increasing nucleation rate. Comparably, n for (Cu46Zr46Al8)98Gd2 and (Cu46Zr46Al8)96Gd4 is 1.5 < n < 2.5, which suggests that the crystallisation is mainly determined by diffusion-controlled three-dimensional growth with decreasing nucleation rate.
- 1 November 2021
- Published by Walter de Gruyter GmbH in International Journal of Materials Research
- Vol. 112 (11) , 860-871
Effect of Gd addition on non-isothermal and isothermal crystallisation of Cu–Zr–Al bulk metallic glass
The crystallisation kinetics of (Cu46Zr46Al8)100–xGdx (x = 0, 2 and 4 at.%) bulk metallic glasses in non-isothermal and isothermal conditions were studied by differential scanning calorimetry and X-ray diffraction. X-ray diffraction analysis shows that the crystallisation product Cu10Zr7 changes to Cu10Zr7 and Cu2Gd in the presence of Gd in non-isothermal and isothermal conditions. Crystallisation activation energy was calculated using the Kissinger and Ozawa methods in non-isothermal conditions and using the Arrhenius model in isothermal conditions. The results show that Gd addition triggers an increase in the energy barrier during crystallisation. The Johnson–Mehl–Avrami model was employed to analyse the crystallisation kinetics in the isothermal condition. The Avrami exponent, n, for Cu46Zr46Al8 is more than 2.5, which demonstrates that the crystallisation is mainly governed by diffusion-controlled three-dimensional growth with increasing nucleation rate. Comparably, n for (Cu46Zr46Al8)98Gd2 and (Cu46Zr46Al8)96Gd4 is 1.5 < n < 2.5, which suggests that the crystallisation is mainly determined by diffusion-controlled three-dimensional growth with decreasing nucleation rate.
- 8 July 2021
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 53 (10) , 1143-1153
Crystallization kinetics of Cu–Zr–Al bulk metallic glass with Nd addition
- 8 July 2021
- Published by Wiley in International Journal of Chemical Kinetics
- Vol. 53 (10) , 1143-1153
Crystallization kinetics of Cu–Zr–Al bulk metallic glass with Nd addition
- 1 January 2019
- Published by Elsevier in Journal of Rare Earths
- Vol. 37 (1) , 95-100
Optimisation of superplastic processing parameters for (Cu43Zr48Al9)98Y2 bulk metallic glasses
- 1 January 2019
- Published by Elsevier in Journal of Rare Earths
- Vol. 37 (1) , 95-100
Optimisation of superplastic processing parameters for (Cu43Zr48Al9)98Y2 bulk metallic glasses
- 1 October 2018
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 34 (10) , 1867-1875
Hot deformation behavior of Cu-bearing antibacterial titanium alloy
- 1 October 2018
- Published by Elsevier in Journal of Materials Science & Technology
- Vol. 34 (10) , 1867-1875
Hot deformation behavior of Cu-bearing antibacterial titanium alloy