Takayoshi Mori
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Takayoshi Mori has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Masaki Wada
Access Network Service Systems Laboratories, Tsukuba, Japan
6 shared publications - Taiji Sakamoto
NTT Access Network Service Systems Laboratories, NTT Corporation, Tsukuba, Japan
6 shared publications Takashi Yamamoto
5 shared publicationsFumihiko Yamamoto
NTT Access Network Service Systems Laboratories, Tsukuba, Japan
3 shared publicationsKazuhide Nakajima
3 shared publications- Kazuhide Nakajima
Access Network Service Systems Laboratories, NTT Corporation, Tsukuba, Japan
3 shared publications
Latest Publications
- 12 December 2018
- Published by Elsevier in Optical Fiber Technology
- Vol. 47, 158-163
MDL reduction effect of S-bend induced modal coupling in five-mode ring core fiber
- 12 December 2018
- Published by Elsevier in Optical Fiber Technology
- Vol. 47, 158-163
MDL reduction effect of S-bend induced modal coupling in five-mode ring core fiber
- 30 January 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (5) , 1233-1238
Gain-Clamped 4-LP-Mode Erbium-Doped Fiber Amplifier With Low Temporal Gain Variation
We demonstrate a ring resonator based gain-clamped 4-LP-mode erbium-doped fiber amplifier (EDFA). In this study, we show that a gain-clamped EDFA can reduce temporal modal gain variation simultaneously in all modes. We experimentally evaluate the transient response of a 4-LP-mode EDFA and succeed in reducing the modal gain variation for all modes at 1530 and 1550 nm from 4.0 to 1.1 dB and from 2.8 to 0.7 dB, respectively, by using a gain-clamping technique.
- 30 January 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (5) , 1233-1238
Gain-Clamped 4-LP-Mode Erbium-Doped Fiber Amplifier With Low Temporal Gain Variation
We demonstrate a ring resonator based gain-clamped 4-LP-mode erbium-doped fiber amplifier (EDFA). In this study, we show that a gain-clamped EDFA can reduce temporal modal gain variation simultaneously in all modes. We experimentally evaluate the transient response of a 4-LP-mode EDFA and succeed in reducing the modal gain variation for all modes at 1530 and 1550 nm from 4.0 to 1.1 dB and from 2.8 to 0.7 dB, respectively, by using a gain-clamping technique.
- 29 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (2) , 331-335
Two-LP-Mode Six-Core Cladding Pumped EDFA With High Pump Power Density
We report the design, fabrication and evaluation of a cladding pumped 2-LP mode 6-core moderately coupled amplifier. In this study, we show that moderately coupled multi-core erbium doped fiber (EDF) can realize a high pump power density in a cladding by allowing core-to-core power coupling. We also experimentally evaluate the amplification characteristics and confirm an average mode-core gain of 18 dB, a differential mode-core gain of 4 dB, and an average noise figure of 7 dB in the C-band. Moreover, we confirm an average mode-core gain of 15 dB, a differential mode-core gain of 5 dB, and an average noise figure of 7.5 dB in the L-band.
- 29 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 36 (2) , 331-335
Two-LP-Mode Six-Core Cladding Pumped EDFA With High Pump Power Density
We report the design, fabrication and evaluation of a cladding pumped 2-LP mode 6-core moderately coupled amplifier. In this study, we show that moderately coupled multi-core erbium doped fiber (EDF) can realize a high pump power density in a cladding by allowing core-to-core power coupling. We also experimentally evaluate the amplification characteristics and confirm an average mode-core gain of 18 dB, a differential mode-core gain of 4 dB, and an average noise figure of 7 dB in the C-band. Moreover, we confirm an average mode-core gain of 15 dB, a differential mode-core gain of 5 dB, and an average noise figure of 7.5 dB in the L-band.
- 1 February 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 35 (10) , 1936-1944
Strongly Coupled Two-LP Mode Ring Core Fiber With Low Effective Index Difference
We propose a strongly coupled ring core fiber for mode-division multiplexed (MDM) transmission with multiple-input multiple-output (MIMO) digital signal processing (DSP) supporting two linearly polarized (LP) modes over the C-band. We show numerically that the mode coupling efficiency of ring-core fiber can be increased by optimizing the structural parameters of the fiber based on an S-bend model. Accordingly, the coupling coefficient is successfully controlled using ring-core fiber fabricated with an effective index difference between the modesneff of 0.3 × 10-3 and an effective area Aeff of 290 m2 for the LP01 and LP11 modes. Finally, we experimentally demonstrate the applicability of our fiber to MDM transmission with MIMO DSP and successfully reduce the signal quality difference by employing mode coupling in a fabricated 15.4 km fiber.
- 1 February 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 35 (10) , 1936-1944
Strongly Coupled Two-LP Mode Ring Core Fiber With Low Effective Index Difference
We propose a strongly coupled ring core fiber for mode-division multiplexed (MDM) transmission with multiple-input multiple-output (MIMO) digital signal processing (DSP) supporting two linearly polarized (LP) modes over the C-band. We show numerically that the mode coupling efficiency of ring-core fiber can be increased by optimizing the structural parameters of the fiber based on an S-bend model. Accordingly, the coupling coefficient is successfully controlled using ring-core fiber fabricated with an effective index difference between the modesneff of 0.3 × 10-3 and an effective area Aeff of 290 m2 for the LP01 and LP11 modes. Finally, we experimentally demonstrate the applicability of our fiber to MDM transmission with MIMO DSP and successfully reduce the signal quality difference by employing mode coupling in a fabricated 15.4 km fiber.
- 12 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 35 (6) , 1222-1227
Coupled Few-Mode Multicore Fiber With Low Differential Mode Delay Characteristics
We investigate a coupled few-mode multi-core fiber (FM-MCF) design to realize an ultra-high spatial density space division multiplexing (SDM) transmission line with low differential mode delay (DMD) characteristics. We describe a super-mode-based FM-MCF design that takes account of the DMD between modes in the inter-LP mode group (e.g. between LP01- and LP11-like super-modes). We also show a randomly coupled FM-MCF design based on fiber bending and twisting to reduce the DMD between modes in the intra-LP mode group. We fabricated coupled 3-mode 7-core fiber and realized a low DMD value of less than 0.2 ns/km for all modes where the inter-core non-uniformity induced DMD was successfully suppressed owing to distributed random mode coupling. The fabricated fiber has 21 spatial modes within a 125 mm cladding, and a relative core density of 21, which is the highest of any reported 125 mm cladding SDM fiber.
- 12 December 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 35 (6) , 1222-1227
Coupled Few-Mode Multicore Fiber With Low Differential Mode Delay Characteristics
We investigate a coupled few-mode multi-core fiber (FM-MCF) design to realize an ultra-high spatial density space division multiplexing (SDM) transmission line with low differential mode delay (DMD) characteristics. We describe a super-mode-based FM-MCF design that takes account of the DMD between modes in the inter-LP mode group (e.g. between LP01- and LP11-like super-modes). We also show a randomly coupled FM-MCF design based on fiber bending and twisting to reduce the DMD between modes in the intra-LP mode group. We fabricated coupled 3-mode 7-core fiber and realized a low DMD value of less than 0.2 ns/km for all modes where the inter-core non-uniformity induced DMD was successfully suppressed owing to distributed random mode coupling. The fabricated fiber has 21 spatial modes within a 125 mm cladding, and a relative core density of 21, which is the highest of any reported 125 mm cladding SDM fiber.
- 20 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 35 (4) , 762-767
Differential Modal Gain Reduction of L-band 5-Mode EDFA Using EDF With Center Depressed Core Index
We report a 5-mode erbium doped fiber amplifier (EDFA) operating in the L-band (1570-1605 nm) designed to extend the bandwidth of mode division multiplexed transmission. We design an EDF with a center depressed core index and a ring doped erbium concentration profile to obtain a low differential modal gain (DMG) and a low splice loss with a graded-index fiber as a transmission line. Then we fabricate a center depressed core EDF and realize a gain of 20 dB for all modes and a low DMG with a deviation of less than 3 dB in the 1570 – 1605 nm range with a 48-m-long erbium doped fiber when the pump mode is the LP01 mode.
- 20 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 35 (4) , 762-767
Differential Modal Gain Reduction of L-band 5-Mode EDFA Using EDF With Center Depressed Core Index
We report a 5-mode erbium doped fiber amplifier (EDFA) operating in the L-band (1570-1605 nm) designed to extend the bandwidth of mode division multiplexed transmission. We design an EDF with a center depressed core index and a ring doped erbium concentration profile to obtain a low differential modal gain (DMG) and a low splice loss with a graded-index fiber as a transmission line. Then we fabricate a center depressed core EDF and realize a gain of 20 dB for all modes and a low DMG with a deviation of less than 3 dB in the 1570 – 1605 nm range with a 48-m-long erbium doped fiber when the pump mode is the LP01 mode.
- Open Access
- 7 November 2013
- Published by Elsevier in Optical Fiber Technology
- Vol. 19 (6) , 658-664
Wideband WDM coherent optical MIMO transmission over 50 μm-core GI-MMF using selective mode excitation technique
- 7 November 2013
- Published by Elsevier in Optical Fiber Technology
- Vol. 19 (6) , 658-664
Open AccessWideband WDM coherent optical MIMO transmission over 50 μm-core GI-MMF using selective mode excitation technique
- 1 January 2013
- Published by Optica Publishing Group
- p. AW3C.1
Few-mode fiber for mode-division-multiplexed transmission with MIMO DSP
We review recent work on few-mode fibers for mode-division-multiplexed transmission with MIMO DSP and introduce our demonstrations of a low DMD 4 LP mode fiber and DMD compensation transmission line.
- 1 January 2013
- Published by Optica Publishing Group
- p. AW3C.1
Few-mode fiber for mode-division-multiplexed transmission with MIMO DSP
We review recent work on few-mode fibers for mode-division-multiplexed transmission with MIMO DSP and introduce our demonstrations of a low DMD 4 LP mode fiber and DMD compensation transmission line.