Xiao Xiao Cai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Xiao Xiao Cai has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
- Simon P. Platt
University of Central Lancashire
5 shared publications - Esben Bryndt Klinkby
DTU Nutech, Technical University of Denmark, DTU Risø Campus, Frederiksborgvej 399, DK-4000, Roskilde, Denmark
4 shared publications - Thomas Kittelmann
European Spallation Source ERIC, Lund, Sweden
4 shared publications Kalliopi Kanaki
European Spallation Source ESS ERIC, SE-221 00 Lund, P.O Box 176, Sweden
3 shared publicationsRichard Hall-Wilton
European Spallation Source ERIC, 22-100, Lund, Sweden
3 shared publicationsThomas Kittelmann
European Spallation Source ERIC, 22-100, Lund, Sweden
3 shared publications
Latest Publications
- 20 October 2020
- Published by SAGE Publications in Journal of Neutron Research
- Vol. 22 (2-3) , 183-189
Simulating neutron transport in long beamlines at a spallation neutron source using Geant4
The transport of neutrons in long beamlines at spallation neutron sources presents a unique challenge for Monte-Carlo transport calculations. This is due to the need to accurately model the deep-penetration of high-energy neutrons through meters of thick dense shields close to the source and at the same time to model the transport of low- energy neutrons across distances up to around 150 m in length. Typically, such types of calculations may be carried out with MCNP-based codes or alternatively PHITS. However, in recent years there has been an increased interest in the suitability of Geant4 for such types of calculations. Therefore, we have implemented supermirror physics, a neutron chopper module and the duct-source variance reduction technique for low- energy neutron transport from the PHITS Monte-Carlo code into Geant4. In the current work, we present a series of benchmarks of these extensions with the PHITS software, which demonstrates the suitability of Geant4 for simulating long neutron beamlines at a spallation neutron source, such as the European Spallation Source, currently under construction in Lund, Sweden.
- 20 October 2020
- Published by SAGE Publications in Journal of Neutron Research
- Vol. 22 (2-3) , 183-189
Simulating neutron transport in long beamlines at a spallation neutron source using Geant4
The transport of neutrons in long beamlines at spallation neutron sources presents a unique challenge for Monte-Carlo transport calculations. This is due to the need to accurately model the deep-penetration of high-energy neutrons through meters of thick dense shields close to the source and at the same time to model the transport of low- energy neutrons across distances up to around 150 m in length. Typically, such types of calculations may be carried out with MCNP-based codes or alternatively PHITS. However, in recent years there has been an increased interest in the suitability of Geant4 for such types of calculations. Therefore, we have implemented supermirror physics, a neutron chopper module and the duct-source variance reduction technique for low- energy neutron transport from the PHITS Monte-Carlo code into Geant4. In the current work, we present a series of benchmarks of these extensions with the PHITS software, which demonstrates the suitability of Geant4 for simulating long neutron beamlines at a spallation neutron source, such as the European Spallation Source, currently under construction in Lund, Sweden.
- Open Access
- 1 January 2020
- Published by Elsevier in Computer Physics Communications
- Vol. 246, 106851
NCrystal: A library for thermal neutron transport
- 1 January 2020
- Published by Elsevier in Computer Physics Communications
- Vol. 246, 106851
Open AccessNCrystal: A library for thermal neutron transport
- Open Access
- 1 September 2019
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 151, 30-38
Background reduction at DTU Nutech surface gamma laboratory
- 1 September 2019
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 151, 30-38
Open AccessBackground reduction at DTU Nutech surface gamma laboratory
- 1 March 2019
- Published by Elsevier in Journal of Computational Physics
- Vol. 380, 400-407
Rejection-based sampling of inelastic neutron scattering
- 1 March 2019
- Published by Elsevier in Journal of Computational Physics
- Vol. 380, 400-407
Rejection-based sampling of inelastic neutron scattering
- Open Access
- 15 December 2018
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 551, 386-389
Simulation tools for detector and instrument design
- 15 December 2018
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 551, 386-389
Open AccessSimulation tools for detector and instrument design
- Open Access
Rejection-based sampling of inelastic neutron scattering
Distributions of inelastically scattered neutrons can be quantum dynamically described by a scattering kernel. We present an accurate and computationally efficient rejection method for sampling a given scattering kernel of any isotropic material. The proposed method produces continuous neutron energy and angular distributions, typically using just a single interpolation per sampling. We benchmark the results of this method against those from accurate analytical models and one of the major neutron transport codes. We also show the results of applying this method to the conventional discrete double differential cross sections.
Open AccessRejection-based sampling of inelastic neutron scattering
Distributions of inelastically scattered neutrons can be quantum dynamically described by a scattering kernel. We present an accurate and computationally efficient rejection method for sampling a given scattering kernel of any isotropic material. The proposed method produces continuous neutron energy and angular distributions, typically using just a single interpolation per sampling. We benchmark the results of this method against those from accurate analytical models and one of the major neutron transport codes. We also show the results of applying this method to the conventional discrete double differential cross sections.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Validation of Detailed Geant4 Model for Thermal Neutron Scattering using the Results of Multi-Grid Detector Prototype Test at CNCS at SNS
The European Spallation Source (ESS) aspires to be the worlds leading neutron source of the upcoming decades, and sets the scope on replacing 3 He tube detectors where it is reasonably achievable. The Multi-Grid detector, an Ar/CO 2 -filled proportional chamber based on solid 10 B 4 C converter, is the most potent replacement technology for chopper spectroscopy. This study reproduces in a detailed Geant4 geometry of a neutron scattering instrument the data from the Multi-Grid demonstrator detector, that has been tested for a 1 year period, installed side-by-side to the 3 He tubes at the CNCS instrument at SNS. For the further understanding of the background of the detector, Monte-Carlo simulations were performed, with the ESS Coding Framework, using a Geant4 version extended with NXSG4 and NCrystal. A detailed and realistic model of the prototype was built and was validated via comparison against measured data. With this model, different sources of neutron scattering were determined and studied separately, providing a better understanding of the scattered neutron background. Due to these capabilities the model will be used in the further optimization of the detector, especially for the background reduction via shielding, which will lead to instruments with better signal-to-background ratio by design.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Validation of Detailed Geant4 Model for Thermal Neutron Scattering using the Results of Multi-Grid Detector Prototype Test at CNCS at SNS
The European Spallation Source (ESS) aspires to be the worlds leading neutron source of the upcoming decades, and sets the scope on replacing 3 He tube detectors where it is reasonably achievable. The Multi-Grid detector, an Ar/CO 2 -filled proportional chamber based on solid 10 B 4 C converter, is the most potent replacement technology for chopper spectroscopy. This study reproduces in a detailed Geant4 geometry of a neutron scattering instrument the data from the Multi-Grid demonstrator detector, that has been tested for a 1 year period, installed side-by-side to the 3 He tubes at the CNCS instrument at SNS. For the further understanding of the background of the detector, Monte-Carlo simulations were performed, with the ESS Coding Framework, using a Geant4 version extended with NXSG4 and NCrystal. A detailed and realistic model of the prototype was built and was validated via comparison against measured data. With this model, different sources of neutron scattering were determined and studied separately, providing a better understanding of the scattered neutron background. Due to these capabilities the model will be used in the further optimization of the detector, especially for the background reduction via shielding, which will lead to instruments with better signal-to-background ratio by design.
- Open Access
- 25 September 2017
- Published by IOP Publishing in New Journal of Physics
- Vol. 19 (10) , 103027
Neutron total cross section calculation within the framework of quasi-harmonic approximation
The accuracy of neutron scattering cross sections is the gauge for the realistic outcome of a neutron transport simulation. To improve the traditional harmonic physics model used in such simulations, we revisit the slow neutron transport theory in crystalline materials and aim to develop a unified model that has good performance for neutron transport problems in crystals in a wide range of temperatures and pressures. The quasi-harmonic approximation correlates phonon evolution explicitly with unit cell volume. Therefore it is capable of evaluating a variety of material properties at finite temperatures. In this work, we show numerically that it is a very effective tool for our application as well. Within the framework of quasi-harmonic approximation, we calculate the temperature dependent characteristics of phonons in three elemental crystals, namely Be, Mg and Al. Based on the obtained results, our calculated neutron total cross sections agree closely with experimental transmission cross sections in a large temperature range below the melting point. We show that as the harmonic cross section model ignores the effects of phonon softening in these crystals, it underestimates the total inelastic cross sections at high temperatures. In the case of Al, we observe that such underestimation is up to 7% at room temperature. In addition, we study the phonon-phonon scatterings in Al. We observe that the cross section is insensitive to the finite phonon lifetimes even at 800K.
- 25 September 2017
- Published by IOP Publishing in New Journal of Physics
- Vol. 19 (10) , 103027
Open AccessNeutron total cross section calculation within the framework of quasi-harmonic approximation
The accuracy of neutron scattering cross sections is the gauge for the realistic outcome of a neutron transport simulation. To improve the traditional harmonic physics model used in such simulations, we revisit the slow neutron transport theory in crystalline materials and aim to develop a unified model that has good performance for neutron transport problems in crystals in a wide range of temperatures and pressures. The quasi-harmonic approximation correlates phonon evolution explicitly with unit cell volume. Therefore it is capable of evaluating a variety of material properties at finite temperatures. In this work, we show numerically that it is a very effective tool for our application as well. Within the framework of quasi-harmonic approximation, we calculate the temperature dependent characteristics of phonons in three elemental crystals, namely Be, Mg and Al. Based on the obtained results, our calculated neutron total cross sections agree closely with experimental transmission cross sections in a large temperature range below the melting point. We show that as the harmonic cross section model ignores the effects of phonon softening in these crystals, it underestimates the total inelastic cross sections at high temperatures. In the case of Al, we observe that such underestimation is up to 7% at room temperature. In addition, we study the phonon-phonon scatterings in Al. We observe that the cross section is insensitive to the finite phonon lifetimes even at 800K.
- Open Access
- 1 September 2017
- Published by Elsevier in Computer Physics Communications
- Vol. 218, 17-42
Monte Carlo Particle Lists: MCPL
- 1 September 2017
- Published by Elsevier in Computer Physics Communications
- Vol. 218, 17-42
Open AccessMonte Carlo Particle Lists: MCPL
- Open Access
- 18 April 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. PP (00189499) , 1
Using Back-Scattering to Enhance Efficiency in Neutron Detectors
The principle of using strongly scattering materials to recover efficiency in detectors for neutron instruments, via back-scattering of unconverted thermal neutrons, is discussed in general. The feasibility of the method is illustrated through Geant4-based simulations involving thermal neutrons impinging on a specific setup with a layer of polyethylene placed behind a single-layered boron-10 thin film gaseous detector. The results show that detection efficiencies can be as much as doubled in the most ideal scenario, but with associated adverse contributions to spatial and timing resolution of respectively centimetres and tens of microseconds. Potential mitigation techniques to contain the impact on resolution are investigated, and are found to alleviate the issues to some degree, at a cost of reduced gain in efficiency.
- 18 April 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. PP (00189499) , 1
Open AccessUsing Back-Scattering to Enhance Efficiency in Neutron Detectors
The principle of using strongly scattering materials to recover efficiency in detectors for neutron instruments, via back-scattering of unconverted thermal neutrons, is discussed in general. The feasibility of the method is illustrated through Geant4-based simulations involving thermal neutrons impinging on a specific setup with a layer of polyethylene placed behind a single-layered boron-10 thin film gaseous detector. The results show that detection efficiencies can be as much as doubled in the most ideal scenario, but with associated adverse contributions to spatial and timing resolution of respectively centimetres and tens of microseconds. Potential mitigation techniques to contain the impact on resolution are investigated, and are found to alleviate the issues to some degree, at a cost of reduced gain in efficiency.