Ana Rosa Lazo-Fraga
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ana Rosa Lazo-Fraga has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Alicia Marcelina Díaz García
Laboratorio de Bioinorgánica, Departamento de Química General e Inorgánica, Facultad de Química, Universidad de La Habana, La Habana, C.P. 10400, Cuba
3 shared publications - Marcia Viltres-Portales
GTS Research Group, Department of Chemistry, Faculty of Science
2 shared publications - Margarita Edelia Villanueva Tagle
Univ Havana, Fac Chem, Zapata & G Vedado Plaza, Havana 10400, Cuba
2 shared publications - Osvaldo Estévez-Hernández
Instituto de Ciencia y Tecnologia de Materiales (IMRE), Universidad de la Habana
2 shared publications - Xiang-Yang Lou
Shenzhen Institute of Information Technology
2 shared publications A. M. Díaz-García
Facultad de Química, Universidad de La Habana, La Habana, Cuba
1 shared publication
Latest Publications
- Open Access
- 28 July 2026
- Published by Wiley in ChemistrySelect
- Vol. 11 (29) , e73930
Nonenzymatic Electrochemical Detection of Hydrogen Peroxide at Zinc Oxide Nanoparticle‐Modified Screen‐Printed Electrodes
Hydrogen peroxide (H 2 O 2 ) levels have raised concerns about environmental pollution. However, reliable and low‐cost strategies for monitoring H 2 O 2 levels remain limited. Herein, zinc oxide nanoparticles (ZnONPs) were synthesized via a simple, low‐cost precipitation route followed by controlled calcination, producing a wurtzite hexagonal phase with nanorod morphology. ZnONPs were characterized by infrared spectroscopy, x‐ray diffraction, atomic force, scanning and transmission electron microscopy, and electrochemical techniques. Screen‐printed carbon electrodes (SPEs) were modified by drop‐casting ZnONPs and coating the surface with a thin NAFION layer. Optimizing ZnONPs mass loading showed 37.5 µg cm −2 gave the best electron‐transfer behavior, confirmed by cyclic voltammetry. The SPE/ZnONPs/NAFION electrode displayed a rapid and well‐defined anodic response toward H 2 O 2 oxidation, with a linear concentration range of 20–95 µM ( R 2 = 0.992), a sensitivity of 2.1 µA µM −1 cm −2 , and a low detection limit (LOD = 2.4 µM). When tested in seawater, the sensor maintained a linear response (10–70 µM, R 2 = 0.997) despite signal attenuation from matrix effects, demonstrating adequate robustness (sensitivity of 0.37 µA µM −1 cm −2 , LOD = 7.9 µM) in complex aqueous media. These findings highlight the potential of ZnONPs as effective electrocatalytic modifiers for low‐cost, disposable, and enzyme‐free H 2 O 2 sensing platforms.
- 28 July 2026
- Published by Wiley in ChemistrySelect
- Vol. 11 (29) , e73930
Open AccessNonenzymatic Electrochemical Detection of Hydrogen Peroxide at Zinc Oxide Nanoparticle‐Modified Screen‐Printed Electrodes
Hydrogen peroxide (H 2 O 2 ) levels have raised concerns about environmental pollution. However, reliable and low‐cost strategies for monitoring H 2 O 2 levels remain limited. Herein, zinc oxide nanoparticles (ZnONPs) were synthesized via a simple, low‐cost precipitation route followed by controlled calcination, producing a wurtzite hexagonal phase with nanorod morphology. ZnONPs were characterized by infrared spectroscopy, x‐ray diffraction, atomic force, scanning and transmission electron microscopy, and electrochemical techniques. Screen‐printed carbon electrodes (SPEs) were modified by drop‐casting ZnONPs and coating the surface with a thin NAFION layer. Optimizing ZnONPs mass loading showed 37.5 µg cm −2 gave the best electron‐transfer behavior, confirmed by cyclic voltammetry. The SPE/ZnONPs/NAFION electrode displayed a rapid and well‐defined anodic response toward H 2 O 2 oxidation, with a linear concentration range of 20–95 µM ( R 2 = 0.992), a sensitivity of 2.1 µA µM −1 cm −2 , and a low detection limit (LOD = 2.4 µM). When tested in seawater, the sensor maintained a linear response (10–70 µM, R 2 = 0.997) despite signal attenuation from matrix effects, demonstrating adequate robustness (sensitivity of 0.37 µA µM −1 cm −2 , LOD = 7.9 µM) in complex aqueous media. These findings highlight the potential of ZnONPs as effective electrocatalytic modifiers for low‐cost, disposable, and enzyme‐free H 2 O 2 sensing platforms.
- Open Access
- 16 June 2025
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 15 (4) , 2751
Development of graphite-epoxy screen-printed electrodes selective to nitrate ions
High concentrations of nitrate ions in water can cause eutrophication, while ingestion of these ions can cause methemoglobin and various cancers. Therefore, there is a need for sensitive, selective and inexpensive analytical tools, as an alternative to expensive conventional techniques, to monitor and evaluate the concentration of these ions. The aim of the present investigation is to develop printed graphite-epoxy electrodes modified with PVC membranes for the potentiometric determination of nitrate ions. The electrodes were manually printed in the laboratory with inks prepared from epoxy resin and graphite at different percentages and particle sizes. The printed electrodes were characterized by cyclic voltammetry, electrochemical impedance spectroscopy and scanning electron microscopy, prior to their modification with PVC membrane. The chrono-potentiometric response of the electrodes was evaluated with NO3- ion solutions. The best printing and electrochemical behavior of electrodes was obtained with inks containing 76 % of modified conductive phase-modified graphite nanoparticles. The developed ion-selective electrodes showed response to nitrate ions with a super-Nernstian slope, detection limits in the order of 10 mmol L-1, response times of 10 to 12 seconds and selectivity in the presence of NO2-, SO42-, Cl-, Br-, I- and CrO42- ions. The developed electrodes were used for the indirect determination of chloride ions in water samples by potentiometric titration.
- 16 June 2025
- Published by International Association of Physical Chemists (IAPC) in Journal of Electrochemical Science and Engineering
- Vol. 15 (4) , 2751
Open AccessDevelopment of graphite-epoxy screen-printed electrodes selective to nitrate ions
High concentrations of nitrate ions in water can cause eutrophication, while ingestion of these ions can cause methemoglobin and various cancers. Therefore, there is a need for sensitive, selective and inexpensive analytical tools, as an alternative to expensive conventional techniques, to monitor and evaluate the concentration of these ions. The aim of the present investigation is to develop printed graphite-epoxy electrodes modified with PVC membranes for the potentiometric determination of nitrate ions. The electrodes were manually printed in the laboratory with inks prepared from epoxy resin and graphite at different percentages and particle sizes. The printed electrodes were characterized by cyclic voltammetry, electrochemical impedance spectroscopy and scanning electron microscopy, prior to their modification with PVC membrane. The chrono-potentiometric response of the electrodes was evaluated with NO3- ion solutions. The best printing and electrochemical behavior of electrodes was obtained with inks containing 76 % of modified conductive phase-modified graphite nanoparticles. The developed ion-selective electrodes showed response to nitrate ions with a super-Nernstian slope, detection limits in the order of 10 mmol L-1, response times of 10 to 12 seconds and selectivity in the presence of NO2-, SO42-, Cl-, Br-, I- and CrO42- ions. The developed electrodes were used for the indirect determination of chloride ions in water samples by potentiometric titration.
- 23 August 2024
- Published by Elsevier in Materials Today Communications
- Vol. 40
Sponge-loaded spion for adsorption of trans-[CuCl2(NH3)2] in wastewater remediation
- 23 August 2024
- Published by Elsevier in Materials Today Communications
- Vol. 40
Sponge-loaded spion for adsorption of trans-[CuCl2(NH3)2] in wastewater remediation
- 26 September 2023
- Published by Springer Nature in Chemical Papers
- Vol. 78 (1) , 165-172
Vancomycin selective electrode based on molecularly imprinted polymer
- 26 September 2023
- Published by Springer Nature in Chemical Papers
- Vol. 78 (1) , 165-172
Vancomycin selective electrode based on molecularly imprinted polymer
- 15 May 2023
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 305
Sorption study of [Cu(Cl)(NH)] by Cu(II) in sponge Metalzorb for wastewater remediation
- 15 May 2023
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 305
Sorption study of [Cu(Cl)(NH)] by Cu(II) in sponge Metalzorb for wastewater remediation
- 12 December 2022
- Published by Taylor & Francis in Phosphorus, Sulfur, and Silicon and the Related Elements
- Vol. 198 (5) , 403-416
3,3-Disubstituted 1-acylthioureas as ionophores for Pb(II)-ion selective electrodes: physical and chemical characterization of the sensing membranes
- 12 December 2022
- Published by Taylor & Francis in Phosphorus, Sulfur, and Silicon and the Related Elements
- Vol. 198 (5) , 403-416
3,3-Disubstituted 1-acylthioureas as ionophores for Pb(II)-ion selective electrodes: physical and chemical characterization of the sensing membranes
- 13 June 2022
- Published by Taylor & Francis in Phosphorus, Sulfur, and Silicon and the Related Elements
- Vol. 197 (12) , 1213-1225
On the analytical response of lead(II) selective electrodes using 1-aroyl-3,3-dimethylthioureas as ionophores: membrane analysis and quantum chemical calculations
Solid-state Pb2+-ion selective electrodes (Pb2+-ISEs) based on liquid membranes using three 1-aroyl-3,3-dimethylthioureas as ionophores were developed. The receptors differ structurally in the aromatic ring of the 1-aroyl group and have been labeled as FDM, BDM, and TDM. The analytical performance of the constructed electrodes was studied by determining the calibration parameters. The electrodes showed Nernstian behavior with average sensitivities of 30.1, 31.5 and 26.6 mV/dec, as well as average lifetimes of 100, 60 and 7 days, respectively. Cd2+ and Cu2+ cations were interfering toward Pb2+ ions detection. The sensing membranes were studied by SEM-EDS and the results have suggested the formation of aggregates through time related to complex species Pb2+-aroylthioureas. Additionally, quantum chemical calculations were carried out at the B3LYP/6-311G(d,p) level of theory to compute the geometry, frontier molecular orbital energies and global reactivity parameters of the aroylthioureas in tributyl phosphate (TBP) as solvent mediator. Correlation studies between the receptor’s quantum chemical parameters and the experimental analytical response of the Pb2+-ISEs were addressed in order to clarify the differences observed in the analytical response of the constructed electrodes. The results support the chemical model of interaction between thioureas and Pb2+ ions through orbital control involving vacant d-orbitals of the metal ion and electrons from the HOMO of the organic molecule. Graphical Abstract
- 13 June 2022
- Published by Taylor & Francis in Phosphorus, Sulfur, and Silicon and the Related Elements
- Vol. 197 (12) , 1213-1225
On the analytical response of lead(II) selective electrodes using 1-aroyl-3,3-dimethylthioureas as ionophores: membrane analysis and quantum chemical calculations
Solid-state Pb2+-ion selective electrodes (Pb2+-ISEs) based on liquid membranes using three 1-aroyl-3,3-dimethylthioureas as ionophores were developed. The receptors differ structurally in the aromatic ring of the 1-aroyl group and have been labeled as FDM, BDM, and TDM. The analytical performance of the constructed electrodes was studied by determining the calibration parameters. The electrodes showed Nernstian behavior with average sensitivities of 30.1, 31.5 and 26.6 mV/dec, as well as average lifetimes of 100, 60 and 7 days, respectively. Cd2+ and Cu2+ cations were interfering toward Pb2+ ions detection. The sensing membranes were studied by SEM-EDS and the results have suggested the formation of aggregates through time related to complex species Pb2+-aroylthioureas. Additionally, quantum chemical calculations were carried out at the B3LYP/6-311G(d,p) level of theory to compute the geometry, frontier molecular orbital energies and global reactivity parameters of the aroylthioureas in tributyl phosphate (TBP) as solvent mediator. Correlation studies between the receptor’s quantum chemical parameters and the experimental analytical response of the Pb2+-ISEs were addressed in order to clarify the differences observed in the analytical response of the constructed electrodes. The results support the chemical model of interaction between thioureas and Pb2+ ions through orbital control involving vacant d-orbitals of the metal ion and electrons from the HOMO of the organic molecule. Graphical Abstract
- 26 September 2017
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 22 (2) , 471-478
Cyclic voltammetry and impedance spectroscopy analysis for graphene-modified solid-state electrode transducers
- 26 September 2017
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 22 (2) , 471-478
Cyclic voltammetry and impedance spectroscopy analysis for graphene-modified solid-state electrode transducers