Gabriel M. Rebeiz
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Gabriel M. Rebeiz has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Andrew R. Brown
Radiation Laboratory, Department of Electrical Engineering, University of Michigan, Ann Arbor, Michigan 48109
1 shared publication Chen-Yu Chi
Hewlett Packard Co., 1400 Fountaingrove Pkwy., Santa Rosa, California 95403
1 shared publicationLinda Katehi
1 shared publication- Linda P. B. Katehi
Radiation Laboratory, EECS Department, The University of Michigan, Ann Arbor, Michigan 48109‐2122
1 shared publication - Pierre Blondy
IRCOM, University of Limoges, Limoges, France
1 shared publication Stephen V. Robertson
Radiation Laboratory, EECS Department, The University of Michigan, Ann Arbor, Michigan 48109‐2122
1 shared publication
Latest Publications
- 28 May 1999
- Published by Hindawi Limited in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 9 (4) , 326-337
Microwave and millimeter‐wave high‐Q micromachined resonators
Alternative techniques for integrating high-quality factor resonators using micromachining techniques have been investigated. Two methods are presented which include suspending microstrip lines on thin dielectric membranes, resulting in an effective dielectric constant of near unity, and integrating three-dimensional micromachined waveguide cavity resonators with planar feedlines. These resonators show large improvements in quality factor over conventional techniques, and more importantly, allow for planar integration in complex systems. Resonators were fabricated in suspended microstrip at 29, 37, and 62 GHz with quality factors of over 450 with very close agreement between simulated and measured results. An integrated micromachined cavity resonator was also fabricated with a TE011 resonance quality factor of 1117 at 24 GHz and a TE021 resonance quality factor of 1163 at 38 GHz. To the authors' knowledge, these are the highest quality factor planar resonators without the use of superconductive materials, and can be used in microwave and millimeter-wave low-loss filters and low-phase-noise oscillators. ©1999 John Wiley & Sons, Inc. Int J RF and Microwave CAE 9: 326–337, 1999.
- 28 May 1999
- Published by Hindawi Limited in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 9 (4) , 326-337
Microwave and millimeter‐wave high‐Q micromachined resonators
Alternative techniques for integrating high-quality factor resonators using micromachining techniques have been investigated. Two methods are presented which include suspending microstrip lines on thin dielectric membranes, resulting in an effective dielectric constant of near unity, and integrating three-dimensional micromachined waveguide cavity resonators with planar feedlines. These resonators show large improvements in quality factor over conventional techniques, and more importantly, allow for planar integration in complex systems. Resonators were fabricated in suspended microstrip at 29, 37, and 62 GHz with quality factors of over 450 with very close agreement between simulated and measured results. An integrated micromachined cavity resonator was also fabricated with a TE011 resonance quality factor of 1117 at 24 GHz and a TE021 resonance quality factor of 1163 at 38 GHz. To the authors' knowledge, these are the highest quality factor planar resonators without the use of superconductive materials, and can be used in microwave and millimeter-wave low-loss filters and low-phase-noise oscillators. ©1999 John Wiley & Sons, Inc. Int J RF and Microwave CAE 9: 326–337, 1999.
- 1 March 1997
- Published by Wiley in International Journal of Microwave and Millimeter-Wave Computer-Aided Engineering
- Vol. 7 (2) , 149-166
Micromachined membrane filters for microwave and millimeter-wave applications (invited article)
- 1 March 1997
- Published by Wiley in International Journal of Microwave and Millimeter-Wave Computer-Aided Engineering
- Vol. 7 (2) , 149-166
Micromachined membrane filters for microwave and millimeter-wave applications (invited article)
- 1 February 1995
- Published by Defense Technical Information Center (DTIC)
Theoretical and Experimental Study of Low-Loss, High- Efficiency Monolithic Antenna Structures at 94 GHz.
Work was studied on power combining applications using coplanar waveguide (cpw)-fed slot antenna oscillators. In this work, a large amount of oscillators are combined together to result in a high power source. The problems encountered with such systems is the non-linear interaction in the coupled-oscillators. As a single oscillator, we use a slot-antenna with a single microwave transistor designed to oscillate at 20 0Hz. We have successfully combined a 2x2 array of these slot-antenna oscillators at 20 GHz to generate a total radiated power of 70 mW with a dc-RF efficiency of 15%. The power combining efficiency was 100%. Since the antennas are placed on a dielectric lens and therefore result in a high-gain pattern, the effective radiated power is around 4.5w. This configuration does not suffer from substrate mode problems and therefore can be easily extended to 94 GHz power combining systems. (MM)
- 1 February 1995
- Published by Defense Technical Information Center (DTIC)
Theoretical and Experimental Study of Low-Loss, High- Efficiency Monolithic Antenna Structures at 94 GHz.
Work was studied on power combining applications using coplanar waveguide (cpw)-fed slot antenna oscillators. In this work, a large amount of oscillators are combined together to result in a high power source. The problems encountered with such systems is the non-linear interaction in the coupled-oscillators. As a single oscillator, we use a slot-antenna with a single microwave transistor designed to oscillate at 20 0Hz. We have successfully combined a 2x2 array of these slot-antenna oscillators at 20 GHz to generate a total radiated power of 70 mW with a dc-RF efficiency of 15%. The power combining efficiency was 100%. Since the antennas are placed on a dielectric lens and therefore result in a high-gain pattern, the effective radiated power is around 4.5w. This configuration does not suffer from substrate mode problems and therefore can be easily extended to 94 GHz power combining systems. (MM)