Masami Tsubota
Masami Tsubota has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Jiro Kitagawa
Department of Electrical Engineering Faculty of Engineering Fukuoka Institute of Technology 3-30-1 Wajiro-higashi, Higashi-ku 811-0295 Fukuoka Japan
5 shared publications - Hideyuki Sato
Laboratory of Biopharmacy, School of Pharmaceutical Sciences, University of Shizuoka, 52-1 Yada, Suruga-ku, Shizuoka 422-8526, Japan
2 shared publications - Hitoshi Sugawara
Division of General Medicine, Department of Comprehensive Medicine 1 Jichi Medical University, Saitama Medical Center Saitama Japan
2 shared publications - Naoki Shirakawa
Flexible Electronics Research Center, National Institute of Advanced Industrial Science and Technology, Tsukuba, Ibaraki 305-8565, Japan
2 shared publications - Satoshi Tsutsui
Japan Synchrotron Radiation Research Institute (JASRI)
2 shared publications - Youichi Murakami
Condensed Matter Research Center (CMRC) and Photon Factory, Institute of Materials Structure Science, High Energy Accelerator Research Organization (KEK), Tsukuba, Ibaraki 305-0801, Japan
2 shared publications
Latest Publications
- Open Access
Interstitial Atom Engineering in Magnetic Materials
Interstitial light elements play an important role in magnetic materials by improving the magnetic properties through changes of the unit cell volume or through orbital hybridization between the magnetic and interstitial atoms. In this review focusing on the effects of interstitial atoms in Mn-based compounds, which are not well researched, the studies of interstitial atoms in three kinds of magnetic materials (rare-earth Fe-, Mn-, and rare-earth-based compounds) are surveyed. The prominent features of Mn-based compounds are interstitial-atom-induced changes or additional formation of magnetism—either a change from antiferromagnetism (paramagnetism) to ferromagnetism or an additional formation of ferromagnetism. It is noted that in some cases, ferromagnetic coupling can be abruptly caused by a small number of interstitial atoms, which has been overlooked in previous research on rare-earth Fe-based compounds. We also present candidates of Mn compounds, which enable changes of the magnetic state. The Mn-based compounds are particularly important for the easy fabrication of highly functional magnetic devices, as they allow on-demand control of magnetism without causing a large lattice mismatch, among other advantages.
Open AccessInterstitial Atom Engineering in Magnetic Materials
Interstitial light elements play an important role in magnetic materials by improving the magnetic properties through changes of the unit cell volume or through orbital hybridization between the magnetic and interstitial atoms. In this review focusing on the effects of interstitial atoms in Mn-based compounds, which are not well researched, the studies of interstitial atoms in three kinds of magnetic materials (rare-earth Fe-, Mn-, and rare-earth-based compounds) are surveyed. The prominent features of Mn-based compounds are interstitial-atom-induced changes or additional formation of magnetism—either a change from antiferromagnetism (paramagnetism) to ferromagnetism or an additional formation of ferromagnetism. It is noted that in some cases, ferromagnetic coupling can be abruptly caused by a small number of interstitial atoms, which has been overlooked in previous research on rare-earth Fe-based compounds. We also present candidates of Mn compounds, which enable changes of the magnetic state. The Mn-based compounds are particularly important for the easy fabrication of highly functional magnetic devices, as they allow on-demand control of magnetism without causing a large lattice mismatch, among other advantages.
- Open Access
- 1 December 2019
- Published by Elsevier in Results in Physics
- Vol. 15, 102640
Inter-comparison of lattice parameters and evaluation of peak-shift obtained by Rietveld refinements
- 1 December 2019
- Published by Elsevier in Results in Physics
- Vol. 15, 102640
Open AccessInter-comparison of lattice parameters and evaluation of peak-shift obtained by Rietveld refinements
- Open Access
The Impact of the Composition Effect on Ferromagnetic Properties of Tb2Co2Ga
The ferromagnetic properties of Tb2Co2Ga, crystallizing into an orthorhombic W2CoB2-type structure, were investigated by preparing 11 polycrystalline samples with different starting atomic compositions. We found that Tb2Co2Ga possesses a homogeneity range in the ternary phase diagram. The Curie temperature TC is sensitive to the atomic composition and ranges rather widely, i.e., from 75 to 145 K. For the samples with a TC above 90 K, the nearest Tb–Tb and the Tb–Co distances would be important factors deciding TC, considering the RKKY interaction through the hybridization between Tb and Co atoms. An anisotropic change of two kinds of Co–Tb–Co angles in the octahedron formed by two Tb and four Co atoms occurs in the samples with a TC lower than 90 K. Such a change of octahedral parameters seems to be related to a difference of shapes in the ac magnetization anomaly at TC between the samples in the lowest TC (~ 75 K) group and those in the other groups.
Open AccessThe Impact of the Composition Effect on Ferromagnetic Properties of Tb2Co2Ga
The ferromagnetic properties of Tb2Co2Ga, crystallizing into an orthorhombic W2CoB2-type structure, were investigated by preparing 11 polycrystalline samples with different starting atomic compositions. We found that Tb2Co2Ga possesses a homogeneity range in the ternary phase diagram. The Curie temperature TC is sensitive to the atomic composition and ranges rather widely, i.e., from 75 to 145 K. For the samples with a TC above 90 K, the nearest Tb–Tb and the Tb–Co distances would be important factors deciding TC, considering the RKKY interaction through the hybridization between Tb and Co atoms. An anisotropic change of two kinds of Co–Tb–Co angles in the octahedron formed by two Tb and four Co atoms occurs in the samples with a TC lower than 90 K. Such a change of octahedral parameters seems to be related to a difference of shapes in the ac magnetization anomaly at TC between the samples in the lowest TC (~ 75 K) group and those in the other groups.
- Open Access
- 4 July 2018
- Published by IntechOpen
Rare Earth Extraction from NdFeB Magnets
There is a considerable interest in the extraction of rare earths (RE) from NdFeB magnets in order to recycle rare earth elements. Although the wet process using acid is in practical use in the in-plant recycle of sludge, higher selectivity between rare earths and Fe at room temperature is desired. We have recently proposed a pretreatment of corrosion before the hydrochloric acid (HCl) leaching and the oxalic acid precipitation. Almost full recovery of rare earths can be achieved even at room temperature process. In practical extraction methods, employing wet processes, the discharge of waste acid solution is a problem that needs to be solved to reduce the environmental impact. We further present an encouraging demonstration of rare earth extraction from NdFeB magnet using a closed-loop HCl-based process. Triple extraction has been conducted, and the recovery ratio of rare earths is approximately 50% in each extraction, which is reduced from almost 100% recovery in a one-shot extraction. Despite the reduced extraction efficiency, our method with a rather small number of procedures at almost room temperature is still highly advantageous in terms of cost and environmental friendliness. This study represents the initial step toward the realization of a closed-loop acid process in the recycling of rare earth elements.
- 4 July 2018
- Published by IntechOpen
Open AccessRare Earth Extraction from NdFeB Magnets
There is a considerable interest in the extraction of rare earths (RE) from NdFeB magnets in order to recycle rare earth elements. Although the wet process using acid is in practical use in the in-plant recycle of sludge, higher selectivity between rare earths and Fe at room temperature is desired. We have recently proposed a pretreatment of corrosion before the hydrochloric acid (HCl) leaching and the oxalic acid precipitation. Almost full recovery of rare earths can be achieved even at room temperature process. In practical extraction methods, employing wet processes, the discharge of waste acid solution is a problem that needs to be solved to reduce the environmental impact. We further present an encouraging demonstration of rare earth extraction from NdFeB magnet using a closed-loop HCl-based process. Triple extraction has been conducted, and the recovery ratio of rare earths is approximately 50% in each extraction, which is reduced from almost 100% recovery in a one-shot extraction. Despite the reduced extraction efficiency, our method with a rather small number of procedures at almost room temperature is still highly advantageous in terms of cost and environmental friendliness. This study represents the initial step toward the realization of a closed-loop acid process in the recycling of rare earth elements.
- Open Access
- 13 November 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 1-7
A necessary criterion for obtaining accurate lattice parameters by Rietveld method
To obtain the lattice parameters accurately by the Rietveld method, the relationship between the lattice parameters and the peak-shift, which is the deviation in diffraction angle from the theoretical Bragg position, was studied. We show that the fitting accuracy of lattice parameters is related directly to the well reproducibility of the peak-shift. This study unveils that the peak-shift consists of the experimental and the analytical ones. The analytical peak-shift erroneously lowers a reliability factorRwp, which has, so far, been the conventional criterion of fit. The conventional Rietveld method obtains a unit-cell which is a homothetic (proportional) unit-cell of the true one. We propose an additional criterion based on the peak-shift to obtain the true lattice parameters accurately. Our criterion can achieve reproducibility reasonably well for the experimental peak-shift, leading to highly improved accuracy of the lattice parameters.
- 13 November 2017
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 1-7
Open AccessA necessary criterion for obtaining accurate lattice parameters by Rietveld method
To obtain the lattice parameters accurately by the Rietveld method, the relationship between the lattice parameters and the peak-shift, which is the deviation in diffraction angle from the theoretical Bragg position, was studied. We show that the fitting accuracy of lattice parameters is related directly to the well reproducibility of the peak-shift. This study unveils that the peak-shift consists of the experimental and the analytical ones. The analytical peak-shift erroneously lowers a reliability factorRwp, which has, so far, been the conventional criterion of fit. The conventional Rietveld method obtains a unit-cell which is a homothetic (proportional) unit-cell of the true one. We propose an additional criterion based on the peak-shift to obtain the true lattice parameters accurately. Our criterion can achieve reproducibility reasonably well for the experimental peak-shift, leading to highly improved accuracy of the lattice parameters.
- 15 July 2008
- Published by Physical Society of Japan in Journal of the Physical Society of Japan
- Vol. 77 (7) , 073601
Sm–Sb Bond Length in Mixed-Valence System of SmOs4Sb12
- 15 July 2008
- Published by Physical Society of Japan in Journal of the Physical Society of Japan
- Vol. 77 (7) , 073601
Sm–Sb Bond Length in Mixed-Valence System of SmOs4Sb12
- 1 May 2007
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 156-158, 365-368
Ti 2p soft X-ray emission spectroscopy of Ti2O3
- 1 May 2007
- Published by Elsevier in Journal of Electron Spectroscopy and Related Phenomena
- Vol. 156-158, 365-368
Ti 2p soft X-ray emission spectroscopy of Ti2O3
- 1 March 2007
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 310 (2) , e178-e180
Resonant X-ray scattering of- 1 March 2007
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 310 (2) , e178-e180
Resonant X-ray scattering of