HUHirotaka Ujikawa

Hirotaka Ujikawa

*This is an algorithmically generated author record based on publicly available information.

Hirotaka Ujikawa has a total of 37 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Optical-wireless cooperative control with optical path switching for traffic steering in Open RAN

    by Kenji Miyamoto, Takumi Harada, Hirotaka Ujikawa, Tatsuya Shimada, Tomoaki Yoshida

    We propose an optical-wireless control with optical path switching for traffic steering in an open radio access network (RAN) applying an all-photonic network (APN) offering a user-dedicated optical path. Some of the strict requirements for beyond fifth-generation (5G) and sixth-generation (6G) mobile systems, such as low latency, high reliability, and low power consumption, must be met not only in wireless networks but also across optical and wireless networks in the RAN. We experimentally demonstrate our proposed optical-wireless cooperative control executing optical path switching in coordination with the handover of traffic steering. The results showed that the control loop from collecting and analyzing key performance indicators to controlling the RAN and APN was less than 800 ms, which meets the control loop requirement of less than 1 s defined by the O-RAN Alliance.


  • Proactive congestion control for fast switchover and optical path at mobile midhaul utilizing optimized parallel traffic prediction with multi-thread and multi-processing procedures

    by Yuka Okamoto, Hirotaka Ujikawa, Kenji Miyamoto, Tatsuya Shimada, Tomoaki Yoshida

    According to the 3rd Generation Partnership Project, it is necessary to keep end-to-end latency to less than 5 ms in 5G mobile networks to achieve remote applications that replace on-site work and operations. The challenge here is that the bursty traffic (e.g., video) abruptly changes on a short timescale. Bursty traffic has an instantaneous high bitrate, which can exceed the link rate of the mobile midhaul (MMH) and thereby cause congestion, leading to an increase in latency. We propose a proactive congestion control method that performs parallel prediction of distributed unit (DU) traffic and fast switchover of the central unit (CU) and optical path in the MMH. Since the processing load of traffic analysis increases in accordance with the number of DUs, the CPU used for prediction becomes overloaded when many DUs are aggregated. This leads to concerns that the prediction cannot be completed in advance, that the timing of control is shifted, and that congestion occurs when switching is performed, thereby increasing the latency. The key idea of the proposed method is to optimize the number of CPU cores and threads for parallel prediction of the DU. To evaluate its feasibility and effectiveness, we experimentally optimized the number of CPU cores, thread allocations, and prediction periods and then estimated the maximum number of simultaneous predictions. The experimental results for a simple condition where video traffic and background traffic are mixed show that our prototype controller successfully achieved a latency at the MMH as low as 1 ms with appropriate congestion control. Our findings demonstrate the latency reduction effect of the proposed congestion control method for MMH in an aggregated DU configuration for applications with severe latency requirements such as remote control.

  • Experimental evaluation of an SDN controller for open optical-circuit-switched networks

    by Kazuya Anazawa, Takeru Inoue, Toru Mano, Hiroshi Ou, Hirotaka Ujikawa, Dmitrii Briantcev, Sumaiya Binte Ali, Devika Dass, Hideki Nishizawa, Yoshiaki Sone, et al.

    Open optical networks have been considered to be important for cost-effectively building and operating networks. Recently, optical-circuit-switches (OCSes) have attracted industry and academia because of their cost efficiency and higher capacity than traditional electrical packet switches and reconfigurable optical add-drop multiplexers (ROADMs). Though the open interfaces and control planes for traditional ROADMs and transponders have been defined by several standard-defining organizations, those of OCSes have not. Considering that several OCSes have already been installed in production datacenter networks and several OCS products are on the market, bringing openness and interoperability into OCS-based networks has become important. Motivated by this fact, this paper investigates a software-defined networking controller for open optical-circuit-switched networks. To this end, we identified the use cases of OCSes and derived the controller requirements for supporting them. We then proposed a multi-vendor (MV) OCS controller framework that satisfies the derived requirements; it was designed to quickly and consistently operate fiber paths upon receiving the operation requests. We validated our controller by implementing it and evaluating its performance on actual MV-OCS networks. It satisfied all the requirements, and fiber paths could be configured within 1.0 s by using our controller.


  • User-dedicated optical path switching with optical-wireless cooperative control for low-latency and seamless handover

    by Kenji Miyamoto, Hirotaka Ujikawa, Tatsuya Shimada, Tomoaki Yoshida

    We propose a user-dedicated optical path switching technique for low-latency and seamless handover in the radio access network (RAN) with the all-photonic network (APN). The APN is a network that connects end points directly with optical paths of dedicated wavelengths assigned to each user and provides large-capacity and low-latency connections. As mobile systems beyond 5th generation (5G) and 6th generation (6G) will require extremely low latency, applying the APN to the RAN is promising to achieve this. However, the RAN with the APN has a challenge in optical path switching during the handover procedure of mobile systems because optical switches that compose the APN do not have an Internet protocol (IP) layer function that enables routing control for handover in the conventional router network. Our proposed optical path switching technique to solve this challenge utilizes optical-wireless cooperative control and switches an optical path dedicated to user equipment (UE) executing handover in conjunction with its handover procedure. The key point of the proposed technique is that a next generation node B (gNB) transmits an optimal-timing optical path switching trigger to the optical switch. We experimentally demonstrated the generation of a dedicated optical path for UE in the RAN with the APN as a premise to enable the proposed optical path switching technique. To evaluate the feasibility and effectiveness of the proposed optical path switching technique, we experimentally compared the optical switch and router in terms of latency performance, packet loss, and packet misdirection in the path switching during handover. The results indicated successful optical path switching during handover without packet loss and packet misdirection while reducing the latency per single network equipment by 99%, from 4 µs for the router to 45 ns for the optical switch.


  • Proactive Congestion Control by Fast Optical Switching Within 1-ms Delay at Mobile Backhaul Utilizing Traffic Data Volume

    by Yuka Okamoto, Hirotaka Ujikawa, Kota Asaka, Tatsuya Shimada, Tomoaki Yoshida

    The development and introduction of real-time remote control of robots using mobile NWs is expected. To realize this control, a network configuration in which the User Plane Function (UPF) and Mobile Edge Computing (MEC) are located near the Central Unit (CU) is considered. If traffic exceeds the processing capability of the UPF, there is the concern of congestion. In this paper, we propose and demonstrate a method for obtaining the uplink traffic volume from the CU and predicting the future traffic to switch the optical path and UPF before congestion occurs within the Mobile Backhaul (MBH) delay of 1ms.

  • Flexible Access System Architecture (FASA) to Support Diverse Requirements and Agile Service Creation

    by Jun-Ichi Kani, Manabu Yoshino, Kota Asaka, Hirotaka Ujikawa, Takashi Yamada, Keita Nishimoto, Ken-Ichi Suzuki, Akihiro Otaka

    This paper summarizes our studies on the Flexible Access System Architecture (FASA) which will support a wide range of services and stimulate the creation of new services in the next generation. After reviewing related concepts and technical trends, FASA's concept and use cases are introduced. FASA aims to cover residential, enterprise, and mobile backhaul/fronthaul services. The technical directions associated with implementing FASA and the challenges raised are described. They include hardware design to maximize the use of common hardware, clarification of architectures that suit time-critical applications, and deeper softwarization.


  • Dynamic software updating of OLTs without service interruption

    by Takumi Harada, Hirotaka Ujikawa, Manabu Yoshino, Noriyuki Oota, Ken-Ichi Suzuki, Akihiro Otaka


  • Energy-Efficient Service Multiplexing on Profile-Based TWDM Access Systems

    by Hirotaka Ujikawa, Ken-Ichi Suzuki, Akihiro Otaka, Hiroki Nishiyama, Nei Kato

    Both the variety of communication devices and their options in connecting to the Internet are continuously increasing due to the advances in numerous attractive network applications. These trends make designing the network much more complex. Legacy network design only had to consider pre-defined applications using common end-point devices such as plain old telephone system (POTS). On the other hand, the current and future network, especially in the access part, is expected to be universal so as to cover not only residential users, but also mobile users, and the huge number Internet of Things (IoT) devices for the sake of cost efficiency. The key issue is the difficulty of designing a complex network that is also extremely energy efficient, particularly the future access system. Although many studies have attempted to improve the bandwidth utilization or energy efficiency in multiple-wavelength systems, little is known about how it will be impacted by the divergence among these multiple concrete services. In order to solve this energy issue, we propose a service multiplexing method with a profile-based network architecture where each device declares its traffic profile. Our concept provides the feasible and practical control of complex network. It differs markedly from the methods that control the traffic at the packet or session level as it is easy to apply in actual networks.


  • A novel network design and operation for reducing transmission power in cloud radio access network with power over fiber

    by Yunseong Lee, Katsuya Suto, Hiroki Nishiyama, Nei Kato, Hirotaka Ujikawa, Ken-Ichi Suzuki

    As the number of mobile users and the variety of contents increase, future access networks need to improve their capacity and latency. The concept of Cloud Radio Access Network (C-RAN), which densely deploys a large number of Remote Radio Heads (RRHs), presents a solution to guarantee such communication quality. However, the network still suffers cost issues related to power line supply to a large number of RRHs. Therefore, in this paper, we describe our envisioned C-RAN based on Passive Optical Network (PON) exploiting Power over Fiber (PoF), which is able to provide communication services without external power supply for RRHs. We also describe the conventional network design and operation schemes. Then, power-effective network design and operation approaches to equalize the transmission power of all Optical Line Terminals (OLTs) in the assumed network are presented. Our proposed power-effective network design demonstrates how to deploy the RRHs. Also, based on the proposed design approach, we present a joint control algorithm of the sleep schedule of RRHs and the transmission power of OLTs by considering the distribution of users. Furthermore, the effectiveness of our proposed approach is evaluated through numerical calculation.


  • A MPCP-Based Centralized Rate Control Method for Mobile Stations in FiWi Access Networks

    by Kei Saito, Hiroki Nishiyama, Nei Kato, Hirotaka Ujikawa, Ken-Ichi Suzuki

    Fiber Wireless (FiWi) access networks is widely used to connect users to the core network. The FiWi access networks consist of the edge router, the Passive Optical Networks (PONs), and the wireless networks. In this environment, the edge router, which is the terminal to the core network, can have heavy congestion. To cope with this problem, we propose a Multi Point Control Protocol (MPCP)-based centralized rate control method to centrally control the traffic rate at each Home GateWay (HGW) so as to avoid congestion at the edge router. In the proposed scheme, the transmission delay due to rate control overhead can be mitigated. The performance of the proposed scheme is verified by numerical analysis and computer simulations.