STShuo Tang

Shuo Tang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shuo Tang has a total of 23 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Damped Iterative Explicit Guidance for Multistage Rockets with Thrust Drop Faults

    by Zongzhan Ma, Chuankui Wang, Zhi Xu, Shuo Tang, Ying Ma

    A damped iterative explicit guidance (DIEG) algorithm is proposed to address the problem of the insufficient convergence of classical explicit guidance methods in the event of thrust drop faults in multistage rockets. Based on the iterative guidance mode (IGM) and powered explicit guidance (PEG), this method is enhanced in three aspects: (1) an accurate transversality condition is derived and applied in the dimension-reduction framework instead of using a simplified assumption; (2) the Gauss–Legendre quadrature formula (GLQF) is adopted to increase the accuracy of the method by addressing the issue of excessive errors in calculating thrust integration using linearization methods based on a small quantity assumption under fault conditions; and (3) a damping factor for solving the time-to-go is introduced to avoid the chattering phenomenon and enhance convergence. A numerical simulation was conducted in single- and multistage mission scenarios by gradually reducing the engine thrust to compare the performance of DIEG and PEG. The results show that DIEG has a much larger convergence range than PEG and has fuel optimality similar to that of the optimization method in most fault scenarios. Finally, the robustness of DIEG under various deviations is verified through Monte Carlo simulation.

  • Two-Layer Formation-Containment Fault-Tolerant Control of Fixed-Wing UAV Swarm for Dynamic Target Tracking

    by Boyu Qin, Dong Zhang, Shuo Tang, Yang Xu

    This paper tackles the formation-containment control problem of fixed-wing unmanned aerial vehicle (UAV) swarm with model uncertainties for dynamic target tracking in three-dimensional space in the faulty case of UAVs' actuator and sensor. The fixed-wing UAV swarm under consideration is organized as a “multi-leader-multi-follower” structure, in which only several leaders can obtain the dynamic target information while others only receive the neighbors' information through the communication network. To simultaneously realize the formation, containment, and dynamic target tracking, a two-layer control framework is adopted to decouple the problem into two subproblems: reference trajectory generation and trajectory tracking. In the upper layer, a distributed finite-time estimator (DFTE) is proposed to generate each UAV's reference trajectory in accordance with the control objective. Subsequently, a distributed composite robust fault-tolerant trajectory tracking controller is developed in the lower layer, where a novel adaptive extended super-twisting (AESTW) algorithm with a finite-time extended state observer (FTESO) is involved in solving the robust trajectory tracking control problem under model uncertainties, actuator, and sensor faults. The proposed controller simultaneously guarantees rapidness and enhances the system's robustness with fewer chattering effects. Finally, corresponding simulations are carried out to demonstrate the effectiveness and competitiveness of the proposed two-layer fault-tolerant cooperative control scheme.


  • Open Access

    Distributed Grouping Cooperative Dynamic Task Assignment Method of UAV Swarm

    by Boyu Qin, Dong Zhang, Shuo Tang, Mengyang Wang

    Aiming at the problem of UAV swarms with distributed subsets performing cooperative reconnaissance-and-attack tasks on multi-targets in complex and uncertain combat scenarios, a distributed grouping cooperative dynamic task assignment method is proposed based on extended contract network protocol. The dynamic task assignment model for the UAV swarm with the topology of distributed subsets is established considering multiple constraints such as task cooperation, performing sequence, dynamic environment, communication topology, payload model, and UAV capability. According to the characteristics of multi-participants and multi-tasks in the process of UAV swarm executing tasks, the determination mechanism on cooperators and the selection mechanism of sequential tasks are proposed, and then the contract network protocol is extended. On the basis of the above, an event-triggered task assignment strategy for dynamic tasks is designed. The simulated results show that the proposed method can achieve the cooperative dynamic assignment of the UAV swarm to perform reconnaissance-and-attack tasks to multi-targets in complex and uncertain combat scenarios, improve the adaptiveness of the swarm under the sudden circumstance, and realize the optimization for task execution efficiency of the UAV swarm.


  • Open Access

    A Modified RANS Model for Drag Prediction of Practical Configuration with Riblets and Experimental Validation

    by Chaoqun Li, Shuo Tang, Yi Li, Zihai Geng

    To reduce the computational cost, the k-ω SST turbulence model with Rotation and Curvature correction (SST-RC) is modified to predict the drag of practical aerodynamic configurations mounted with drag-reducing riblets. In the modified model, wall ω is reconstructed based on the existing experimental results and becomes a function of riblet geometry, angle of attack, position at the surface, and parameters of computational grids. The modified SST-RC model is validated by existing experimental and numerical examinations. Subsequently, a maximum error of 3.00% is achieved. Furthermore, experimental and numerical studies on a wing–body configuration are conducted in this work. The maximum error between the drag-reducing ratios obtained by numerical simulations and those of experiments is 3.21%. Analysis of numerical results demonstrates a maximum of 5.36% decline in skin friction coefficient for the model with riblets; moreover, the distribution of the pressure coefficient is also changed.


  • Quasi-One-Dimensional Modeling and Analysis of RBCC Dual-Mode Scramjet Engine

    by Feng Cheng, Shuo Tang, Dong Zhang, Yi Li

    The quasi-one-dimensional method for the dual-mode scramjet (DMR) of the hypersonic RBCC powered vehicle was simplified in most of open researches. Furthermore, these simplified method can not fully capture the processes of wall heat transfer, changes in the boundary layer and the ratio of specific heat and the transonic flow in the reacting flow. Addressing this problem, we establish the models for processing core flow area, transonic flow and precombustion shock train (PCST) based on the governing equations for quasi-one-dimensional flow and certain assumptions. Thus the quasi-one-dimensional model of dual-mode scramjet engine that incorporates the changes in wall heat transfer and in the ratio of specific heat is built. Then, the reliability and accuracy of the model are assessed qualitatively and quantitatively by experiment and CFD numerical simulation. There is a high agreement between the theoretical calculations and the results of experimental data and CFD numerical simulation. This work expands the application scope and increases the reliability of quasi-one-dimensional model of dual-mode scramjet engine in RBCC engine. The results shed new light on the preliminary performance assessment and engineering application of dual-mode scramjet engine.


  • Development of Multitarget Acquisition, Pointing, and Tracking System for Airborne Laser Communication

    by Qing Li, Lei Liu, Xiaofei Ma, Si-Lu Chen, Hai Yun, Shuo Tang

    Cluster unmanned aerial vehicles (UAVs) are widely demanded. To achieve high rate and large capacity communication with cluster UAVs, one of the key but still challenge task is to perform multi-target acquisition, pointing and tracking (APT) under complex airborne environment. To solve this problem, this paper gives one composite axis APT system for multi-target laser communication with cluster UAVs. The APT system consists of a gimbal mirror and piezoelectric fast steering mirrors (FSMs), which can achieve independent and synchronous control of multiple optical axes. The cascade control scheme is designed for the gimbal mirror and the H-infinite controller is designed for the FSM. To further improve the control accuracy, the hysteresis compensator based on least square support vector machines (LS-SVM) is proposed. The pruning error minimization method of LS-SVM is applied to reduce the computational cost. The simulation studies validate the control performance of the multi-target APT system. Finally, the experimental prototype is developed. The experimental results further validate the effectiveness of the proposed multi-target APT system.


  • Fractional-Order Sliding Mode Control of Air-Breathing Hypersonic Vehicles Based on Linear-Quadratic Regulator

    by Lin Cao, Shuo Tang, Dong Zhang

    A new fractional-order sliding mode control (FOSMC) scheme is investigated for air-breathing hypersonic vehicles (AHVs). The control scheme proposed is designed based on linear-quadratic optimal theory. First, by using the technique of input/output feedback linearization, the longitudinal model of AHVs is linearized to be decoupled tracking-error dynamics. Second, a linear-quadratic regulator (LQR) is designed to ensure that the tracking-error dynamics converge to the equilibrium point as soon as possible. Based on LQR, a novel fractional-order sliding manifold is introduced. Subsequently, the FOSMC is designed to reject system uncertainties and reduce the magnitude of control chattering. Then, Lyapunov stability theory is used to prove the finite-time convergence of the closed-loop system. The simulations indicate that the proposed control scheme shows excellent performance and robustness in the absence of uncertainties. Compared with conventional integer-order sliding mode control (IOSMC), the high-frequency chattering of control input is drastically depressed.


  • Robust Trajectory Tracking Guidance for Low L/D Lunar Return Vehicles Using Command Filtered Backstepping Approach

    by Bo Zhang, Shuo Tang, Binfeng Pan

    A reentry guidance method for low lift-to-drag (L/D) ratio vehicles in a lunar return mission is presented. Different from the reference drag tracking scheme, method in this paper tracks a weighted profile of altitude and downrange using a command filtered backstepping approach. First, the dynamics of the tracking error are established with dispersions and uncertainties explicitly taken into consideration. Then, in accordance with the backstepping technique, the weighted reference profile is tracked with the help of a virtual control signal. Next, by tracking the virtual control signal, a real control input is derived. Dispersions and uncertainties are accurately estimated by a well-designed disturbance observer and compensated for by the estimates. The derivatives of the virtual control needed by the backstepping algorithm are obtained by filtering the virtual control signal with a second-order command filter. Finally, the stability of the whole system is analyzed, and extensive numerical simulations are conducted to demonstrate the effectiveness and robustness of the proposed method.


  • Open Access

    Multi-Step Control of Chaos in the Application of Earth-Moon Orbit Transfer

    by Yue Zheng, Binfeng Pan, Shuo Tang, Yang Wang

    A multi-step control of chaos method is proposed in this paper to reduce the flight time in the chaotic region of Earth-Moon low-energy orbit transfer. According to the motion regularity and the fact that the chaos orbit is highly sensitive to the initial conditions in the circular restricted three-body system, the optimal perturbation of chaos control at each step is calculated by the adaptive particle swarm optimization algorithm, and then the low-energy earth-moon orbit transfer trajectory is obtained. This proposed method can efficiently construct the Earth-Moon low-energy orbit transfer trajectory without the relying on the periodic orbits and the requirement of random search, and the corresponding flight time in chaotic motion can be significantly reduced. Finally, numerical simulations are provided to demonstrate the correctness and efficiency of this proposed method.