Wayne L. Neu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Wayne L. Neu has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Daniel J. Stilwell
Virginia Tech
2 shared publications Clinton D. Jones
Department of Aerospace and Ocean Engineering, Virginia Tech, Blacksburg, VA 24061 USA
1 shared publication- Haider N. Arafat
Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061; Cessna Aircraft Company, Wichita, KS 67277
1 shared publication - Jan Petrich
The Bradley Department of Electrical and Computer Engineering, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061
1 shared publication Jessica A. Jacobson
Department of Aerospace and Ocean Engineering, Virginia Tech, Blacksburg, VA 24061 USA
1 shared publicationJohn B. Hennage
Department of Aerospace and Ocean Engineering, Virginia Tech, Blacksburg, VA 24061 USA
1 shared publication
Latest Publications
- 1 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01977385,p. 1-7
Identification of a simplified AUV pitch axis model for control design: Theory and experiments
This paper presents an system identification algorithm for the longitudinal motion of a streamlined, tail-controlled, miniature autonomous underwater vehicle (AUV). The motion of a rigid body in six degrees of freedom is restricted to the dive plane to derive a fourth order dynamic pitch axis model. Based on the mechanical design of the vehicle, we impose symmetry and buoyancy assumptions that allow further model truncation. Basic dependencies between inherent stability of these truncated models and system parameters such as hydrodynamic coefficients are addressed. For the goal to rapidly design an AUV attitude control system, we experimentally show that it is sufficient to consider a second order dynamic model. We identify model parameters by matching the input and output behavior via least squares. Data collected during field trials validates both the system identification and the utility of a second order model for control design.
- 1 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01977385,p. 1-7
Identification of a simplified AUV pitch axis model for control design: Theory and experiments
This paper presents an system identification algorithm for the longitudinal motion of a streamlined, tail-controlled, miniature autonomous underwater vehicle (AUV). The motion of a rigid body in six degrees of freedom is restricted to the dive plane to derive a fourth order dynamic pitch axis model. Based on the mechanical design of the vehicle, we impose symmetry and buoyancy assumptions that allow further model truncation. Basic dependencies between inherent stability of these truncated models and system parameters such as hydrodynamic coefficients are addressed. For the goal to rapidly design an AUV attitude control system, we experimentally show that it is sufficient to consider a second order dynamic model. We identify model parameters by matching the input and output behavior via least squares. Data collected during field trials validates both the system identification and the utility of a second order model for control design.
- 1 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01977385,p. 1-6
Using Single Propeller Performance Data to Predict the Performance of a Counterrotating Pair
The question of using off-the-shelf model boat propellers in a counterrotating-pair configuration was addressed. A number of candidate propellers were performance tested in a water tunnel. Both open-water single-propeller tests and counterrotating-pair tests were performed. A model based on momentum theory was devised to predict the performance of the counterrotating pair from the individual single-propeller performance curves. Unknown coefficients in the model were determined by minimizing the deviation of the model from the counterrotating performance data. Excellent agreement between the model and the data was found over the entire range of the counterrotating pairs tested. The model can now be used to predict the thrust, net torque and efficiency of two off-the-shelf model boat propellers operating as a counterrotating pair.
- 1 September 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01977385,p. 1-6
Using Single Propeller Performance Data to Predict the Performance of a Counterrotating Pair
The question of using off-the-shelf model boat propellers in a counterrotating-pair configuration was addressed. A number of candidate propellers were performance tested in a water tunnel. Both open-water single-propeller tests and counterrotating-pair tests were performed. A model based on momentum theory was devised to predict the performance of the counterrotating pair from the individual single-propeller performance curves. Unknown coefficients in the model were determined by minimizing the deviation of the model from the counterrotating performance data. Excellent agreement between the model and the data was found over the entire range of the counterrotating pairs tested. The model can now be used to predict the thrust, net torque and efficiency of two off-the-shelf model boat propellers operating as a counterrotating pair.
- 1 September 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01977385,p. 1-6
Development of a Dynamic Model of a Small High-Speed Autonomous Underwater Vehicle
A dynamic model is developed for a small, highspeed autonomous underwater vehicle. The vehicle has the unusual property of weighing up to 50 percent more than its displacement, and we seek to characterize requirements for steady-state flight imposed by the vehicles's weight. The process of deriving a dynamic model, which is presented in a tutorial manner, highlights problems that arise when the dynamics of a submersible are expressed in terms of linear and angular momenta and combined with experimentally derived hydrodynamic coefficients
- 1 September 2006
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01977385,p. 1-6
Development of a Dynamic Model of a Small High-Speed Autonomous Underwater Vehicle
A dynamic model is developed for a small, highspeed autonomous underwater vehicle. The vehicle has the unusual property of weighing up to 50 percent more than its displacement, and we seek to characterize requirements for steady-state flight imposed by the vehicles's weight. The process of deriving a dynamic model, which is presented in a tutorial manner, highlights problems that arise when the dynamics of a submersible are expressed in terms of linear and angular momenta and combined with experimentally derived hydrodynamic coefficients