Hideaki Taira
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hideaki Taira has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
Hiroyuki K. M. Tanaka
2 shared publications- Daigo Shoji
Univ Tokyo, Earthquake Res Inst, Bunkyo Ku, Tokyo, Japan
1 shared publication Hiroshi Tsuiji
1 shared publication- Hiroyuki K. M. Tanaka
The University of Tokyo
1 shared publication - Masanobu Tanaka
Institute of Particle and Nuclear Studies KEK Tsukuba Japan
1 shared publication - Minoru Takeo
The University of Tokyo
1 shared publication
Latest Publications
- 22 February 2010
- Published by Springer Nature in Earth, Planets and Space
- Vol. 62 (2) , 173-177
Development of a cost-effective plastic scintillator for cosmic-ray muon radiography of a volcano
Muon radiography has recently made it possible to perform imaging of the internal structure of a volcano. Muon-detecting experiments were carried out at Asama and Usu volcanoes using a newly developed scintillator. The goal was to build a large detector that would improve the quality of the data collected by the muon radiography experimental set-up that is currently being used to study volcanic activities. To this end, a costeffective plastic scintillator was developed by a simple “heating-melting method”. The detector consists of planes of scintillator strips and is currently in the prototyping phase. Using a cosmic-ray muon source, we found that the signal from our scintillator was consistent with the zenith-angle dependence of the cosmic-ray muon spectrum with no significant attenuation effects in the scintillator. We confirmed that our scintillators can be incorporated into a portable assembly-type cosmic-ray muon telescope system.
- 22 February 2010
- Published by Springer Nature in Earth, Planets and Space
- Vol. 62 (2) , 173-177
Development of a cost-effective plastic scintillator for cosmic-ray muon radiography of a volcano
Muon radiography has recently made it possible to perform imaging of the internal structure of a volcano. Muon-detecting experiments were carried out at Asama and Usu volcanoes using a newly developed scintillator. The goal was to build a large detector that would improve the quality of the data collected by the muon radiography experimental set-up that is currently being used to study volcanic activities. To this end, a costeffective plastic scintillator was developed by a simple “heating-melting method”. The detector consists of planes of scintillator strips and is currently in the prototyping phase. Using a cosmic-ray muon source, we found that the signal from our scintillator was consistent with the zenith-angle dependence of the cosmic-ray muon spectrum with no significant attenuation effects in the scintillator. We confirmed that our scintillators can be incorporated into a portable assembly-type cosmic-ray muon telescope system.
- 22 February 2010
- Published by Springer Nature in Earth, Planets and Space
- Vol. 62 (2) , 179-186
A potential space- and power-effective muon sensor module for imaging a volcano
The application of muon radiography will be greatly enhanced by the use of two muon sensor modules that save electric power consumption and are easily transportable. Muon sensor modules used for a volcano observation must have a low electric power consumption requirement and be both waterproof and portable. In this article, we discuss two candidate sensor modules: (1) a portable muon sensor module with wavelength-shifting (WLS) fibers and a multi-anode photomultiplier tube (MAPMT), and (2) a regular scintillator telescope with PMT complemented by a low-power Cockcroft-Walton circuit (CWPMT). A realistic telescope system consisting of a muon sensor module with MAPMT has been tested and found to consume 76 W, most of which (72 W) is used by the redundant electronic circuit required for pulse shaping; this could be modified to drastically improve the power consumption. In comparison, a muon telescope system with a CWPMT was found to consume 7.57 W. We also calculated the muon stopping length in SiO2 by means of a Monte-Carlo simulation. This calculation provided the average density structure along the muon path in rock, where the muon path length was shorter than 1.5 km, with an accuracy of about 5% during a 90-day measurement period by assuming a 1-m2 muon detector with an angular resolution of 25 mrad.
- 22 February 2010
- Published by Springer Nature in Earth, Planets and Space
- Vol. 62 (2) , 179-186
A potential space- and power-effective muon sensor module for imaging a volcano
The application of muon radiography will be greatly enhanced by the use of two muon sensor modules that save electric power consumption and are easily transportable. Muon sensor modules used for a volcano observation must have a low electric power consumption requirement and be both waterproof and portable. In this article, we discuss two candidate sensor modules: (1) a portable muon sensor module with wavelength-shifting (WLS) fibers and a multi-anode photomultiplier tube (MAPMT), and (2) a regular scintillator telescope with PMT complemented by a low-power Cockcroft-Walton circuit (CWPMT). A realistic telescope system consisting of a muon sensor module with MAPMT has been tested and found to consume 76 W, most of which (72 W) is used by the redundant electronic circuit required for pulse shaping; this could be modified to drastically improve the power consumption. In comparison, a muon telescope system with a CWPMT was found to consume 7.57 W. We also calculated the muon stopping length in SiO2 by means of a Monte-Carlo simulation. This calculation provided the average density structure along the muon path in rock, where the muon path length was shorter than 1.5 km, with an accuracy of about 5% during a 90-day measurement period by assuming a 1-m2 muon detector with an angular resolution of 25 mrad.