Lei Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lei Zhang has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Chunxiao Chai
College of Chemistry and Chemical Engineering
2 shared publicationsYanhua Xu
School of Chemistry and Chemical Engineering, Institute of Functional Polymer Composites, Henan University, Kaifeng, 475004, China
2 shared publicationsYufeng Wu
College of Chemistry and Chemical Engineering
2 shared publicationsFan Jiang
College of Chemistry and Chemical Engineering Henan University Kaifeng 475004 China
1 shared publication- Hua Duan
Graduate School, Beijing University of Chinese Medicine, Beijing, China
1 shared publication Ke Zheng
College of Chemistry and Chemical Engineering Henan University Kaifeng 475004 China
1 shared publication
Latest Publications
- 4 December 2020
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 610, 125974
Synthesis and corrosion inhibitory effect of a novel β-amino alcohol compound
- 4 December 2020
- Published by Elsevier in Colloids and Surfaces A: Physicochemical and Engineering Aspects
- Vol. 610, 125974
Synthesis and corrosion inhibitory effect of a novel β-amino alcohol compound
- Open Access
- 11 July 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (44) , 24970-24981
Functional polyaspartic acid derivatives as eco-friendly corrosion inhibitors for mild steel in 0.5 M H2SO4solution
To improve the corrosion inhibition efficiency of eco-friendly polyaspartic acid (PASP) for mild steel in acidic solutions, PASP/N-(3-aminopropyl)imidazole (PD-1) and PASP/N-(3-aminopropyl)-imidazole-co-n-dodecylamine (PD-2) were chemically synthesized by the facile ring-opening reaction of polysuccinimide. Inhibition efficiencies of PD-1 and PD-2 for mild steel in a 0.5 M H2SO4 solution were investigated by electrochemical measurements (electrochemical impedance and polarization) and the weight loss method. In comparison with PASP, PD-1 and PD-2 show improved inhibition efficiencies due to the functional groups. In particular, PD-2 shows superior corrosion inhibition capacity, and the efficiency is up to 94% at a relatively low concentration of 100 mg L−1 at 298 K, as determined by potentiodynamic polarization measurements. Surface analysis of mild steel with PD-2 as an inhibitor clearly indicates that the inhibitor molecules adsorb on the steel surface and efficiently inhibit the corrosion of mild steel. The present work provides very meaningful results in designing and preparing new polymer inhibitors with high inhibition efficiency.
- 11 July 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (44) , 24970-24981
Open AccessFunctional polyaspartic acid derivatives as eco-friendly corrosion inhibitors for mild steel in 0.5 M H2SO4solution
To improve the corrosion inhibition efficiency of eco-friendly polyaspartic acid (PASP) for mild steel in acidic solutions, PASP/N-(3-aminopropyl)imidazole (PD-1) and PASP/N-(3-aminopropyl)-imidazole-co-n-dodecylamine (PD-2) were chemically synthesized by the facile ring-opening reaction of polysuccinimide. Inhibition efficiencies of PD-1 and PD-2 for mild steel in a 0.5 M H2SO4 solution were investigated by electrochemical measurements (electrochemical impedance and polarization) and the weight loss method. In comparison with PASP, PD-1 and PD-2 show improved inhibition efficiencies due to the functional groups. In particular, PD-2 shows superior corrosion inhibition capacity, and the efficiency is up to 94% at a relatively low concentration of 100 mg L−1 at 298 K, as determined by potentiodynamic polarization measurements. Surface analysis of mild steel with PD-2 as an inhibitor clearly indicates that the inhibitor molecules adsorb on the steel surface and efficiently inhibit the corrosion of mild steel. The present work provides very meaningful results in designing and preparing new polymer inhibitors with high inhibition efficiency.
- 2 February 2018
- Published by Wiley in Polymers for Advanced Technologies
- Vol. 29 (5) , 1518-1525
Facile synthesis of oligo(4‐methoxyphenol) in water and evaluation of its efficiency in stabilization of polypropylene
A hindered polyphenol, oligo(4‐methoxyphenol), has been first successfully synthesized via a mild biocatalytic pathway using horseradish peroxidase as catalyst in water without any additive. Then the efficiency of oligo(4‐methoxyphenol) in stabilization of polypropylene (PP) was evaluated in terms of thermal analysis and accelerated aging test. It was observed that the apparent activation energy for thermal decomposition of PP/oligo(4‐methoxyphenol) calculated by Friedman's method is higher than that of virgin PP. Oligo(4‐methoxyphenol)‐stabilized PP maintains its tensile strength even after aging at 120°C for 800 hours. Oxidation induction time and onset oxidation temperature of PP/oligo(4‐methoxyphenol) are higher than both virgin PP and PP/4‐methoxyphenol, as well as PP stabilized with commercially available 6‐di‐tert‐buty‐4‐methylphenol or 1076. These results indicate that oligo(4‐methoxyphenol) can effectively improve the thermo‐oxidative resistance of PP. Noting that oligo(4‐methoxyphenol) is synthesized via enzymatic polymerization in water under mild condition with a facile procedure, oligo(4‐methoxyphenol) is thus proposed as a new efficiency and readily available antioxidant for PP.
- 2 February 2018
- Published by Wiley in Polymers for Advanced Technologies
- Vol. 29 (5) , 1518-1525
Facile synthesis of oligo(4‐methoxyphenol) in water and evaluation of its efficiency in stabilization of polypropylene
A hindered polyphenol, oligo(4‐methoxyphenol), has been first successfully synthesized via a mild biocatalytic pathway using horseradish peroxidase as catalyst in water without any additive. Then the efficiency of oligo(4‐methoxyphenol) in stabilization of polypropylene (PP) was evaluated in terms of thermal analysis and accelerated aging test. It was observed that the apparent activation energy for thermal decomposition of PP/oligo(4‐methoxyphenol) calculated by Friedman's method is higher than that of virgin PP. Oligo(4‐methoxyphenol)‐stabilized PP maintains its tensile strength even after aging at 120°C for 800 hours. Oxidation induction time and onset oxidation temperature of PP/oligo(4‐methoxyphenol) are higher than both virgin PP and PP/4‐methoxyphenol, as well as PP stabilized with commercially available 6‐di‐tert‐buty‐4‐methylphenol or 1076. These results indicate that oligo(4‐methoxyphenol) can effectively improve the thermo‐oxidative resistance of PP. Noting that oligo(4‐methoxyphenol) is synthesized via enzymatic polymerization in water under mild condition with a facile procedure, oligo(4‐methoxyphenol) is thus proposed as a new efficiency and readily available antioxidant for PP.
- 4 December 2012
- Published by Wiley in Polymer International
- Vol. 62 (9) , 1277-1282
Enzymatic synthesis of soluble phenol polymer in water using anionic surfactant as additive
In phosphate–citric acid buffer (pH = 8.0) containing sodium dodecylbenzenesulfonate (SDBS) as a surfactant, enzymatic polymerization of phenol catalyzed by horseradish peroxidase (HRP) is efficiently performed. The as‐synthesized phenol polymer is completely soluble in organic solvents such as dimethylfomamide, dimethylsulfoxide, acetone and tetrahydrofuran. The aqueous micelle system provides a new environmentally friendly method for HRP‐catalyzed phenol polymerization. The effects of the dosage of SDBS and reaction temperature on the yield of the target phenol polymer are investigated. The soluble phenol polymer is composed of phenylene and oxyphenylene units as determined using infrared and 1 H NMR spectral analyses. The number‐average molecular weight calculated from gel permeation chromatography (GPC) is in the range 900–1500 g mol−1 and the dispersity in the range 3.4–6.3. In all cases, the values of weight‐average molecular weight characterized using GPC–static light scattering are tens of thousands. It is concluded that a branched structure is produced in the aqueous micelle system. The phenol polymer prepared possesses good thermal stability for it is completely decomposed at a temperature as high as 628 °C in air.
- 4 December 2012
- Published by Wiley in Polymer International
- Vol. 62 (9) , 1277-1282
Enzymatic synthesis of soluble phenol polymer in water using anionic surfactant as additive
In phosphate–citric acid buffer (pH = 8.0) containing sodium dodecylbenzenesulfonate (SDBS) as a surfactant, enzymatic polymerization of phenol catalyzed by horseradish peroxidase (HRP) is efficiently performed. The as‐synthesized phenol polymer is completely soluble in organic solvents such as dimethylfomamide, dimethylsulfoxide, acetone and tetrahydrofuran. The aqueous micelle system provides a new environmentally friendly method for HRP‐catalyzed phenol polymerization. The effects of the dosage of SDBS and reaction temperature on the yield of the target phenol polymer are investigated. The soluble phenol polymer is composed of phenylene and oxyphenylene units as determined using infrared and 1 H NMR spectral analyses. The number‐average molecular weight calculated from gel permeation chromatography (GPC) is in the range 900–1500 g mol−1 and the dispersity in the range 3.4–6.3. In all cases, the values of weight‐average molecular weight characterized using GPC–static light scattering are tens of thousands. It is concluded that a branched structure is produced in the aqueous micelle system. The phenol polymer prepared possesses good thermal stability for it is completely decomposed at a temperature as high as 628 °C in air.