Haiyun Bi

As direct geomorphic evidence and records of earthquakes on the surface, coseismic surface ruptures have long been a key focus in earthquake research. However, compared with strike-slip and normal faults, studies on reverse-fault surface ruptures remain relatively scarce. In this study, surface rupture characteristics of the most recent earthquake on the Kumysh thrust fault in eastern Tianshan were investigated using high-resolution topographic data, including 0.5 m- and 5 cm-resolution Digital Elevation Models (DEMs) generated from the WorldView-2 satellite stereo image pairs and Unmanned Aerial Vehicle (UAV) images, respectively. We carefully mapped the spatial geometry of the surface rupture and measured 120 vertical displacements along the rupture strike. Using the moving-window method and statistical analysis, both moving-mean and moving-maximum coseismic displacement curves were obtained for the entire rupture zone. Results show that the most recent rupture on the Kumysh Fault extends ~25 km with an overall NWW strike, exhibits complex spatial geometry, and can be subdivided into five secondary segments, which are discontinuously distributed in arcuate shapes across both piedmont alluvial fans and mountain fronts. Reverse fault scarps dominate the rupture pattern. The along-strike coseismic displacements generally form three asymmetric triangles, with an average displacement of 0.9–1.1 m and a maximum displacement of 2.8–3.2 m, yielding an estimated earthquake magnitude of M_w 6.6–6.7. This study not only highlights the strong potential of high-resolution remote sensing data for investigating surface earthquake ruptures, but also provides an additional example to the relatively underexplored reverse-fault surface ruptures.

Strong earthquake activity along fault zones can lead to the displacement of geomorphic units such as gullies and terraces while preserving earthquake event data through changes in sedimentary records near faults. The quantitative analysis of these characteristics facilitates the reconstruction of significant earthquake activity history along the fault zone. Recent advancements in acquisition technology for high-precision and high-resolution topographic data have enabled more precise identification of displacements caused by fault activity, allowing for a quantitative assessment of the characteristics of strong earthquakes on faults. The 1920 Haiyuan earthquake, which occurred on the Haiyuan fault in the northeastern Tibetan Plateau, resulted in a surface rupture zone extending nearly 240 km. Although clear traces of surface rupture have been well preserved along the fault, debate regarding the maximum displacement is ongoing. In this study, we focused on two typical offset geomorphic sites along the middle segment of the Haiyuan fault that were previously identified as having experienced the maximum displacement during the Haiyuan earthquake. High-precision geomorphologic images of the two sites were obtained through unmanned aerial vehicle (UAV) surveys, which were combined with light detection and ranging (LiDAR) data along the fault zone. Our findings revealed that the maximum horizontal displacement of the Haiyuan earthquake at the Shikaguan site was approximately 5 m, whereas, at the Tangjiapo site, it was approximately 6 m. A cumulative offset probability distribution (COPD) analysis of high-density fault displacement measurements along the ruptures indicated that the smallest offset clusters on either side of the Ganyanchi Basin were 4.5 and 5.1 m long. This analysis further indicated that the average horizontal displacements of the Haiyuan earthquake were approximately 4–6 m. Further examination of multiple gullies and geomorphic unit displacements at the Shikatougou site, along with a detailed COPD analysis of dense displacement measurements within a specified range on both sides, demonstrated that the cumulative displacement within 30 m of this section of the Haiyuan fault exhibited at least five distinct displacement clusters. These dates may represent the results of five strong earthquake events in this fault segment over the past 10,000–13,000 years. The estimated magnitude, derived from the relationship between displacement and magnitude, ranged from M_w 7.4 to 7.6, with an uneven recurrence interval of approximately 2500–3200 years.

Slip from paleoearthquakes is preserved in geomorphology in the form of displaced landforms. By recovering the surface slip distribution of displaced landforms along a fault, we can constrain the earthquake rupture histories and recurrence characteristics on the fault, thus benefiting seismic hazard assessment. In this study, 1‐m‐resolution airborne Light Detection and Ranging data were obtained along about 185 km of the Sertengshan Piedmont Fault, which is a dip‐slip normal fault located at the northern margin of the Hetao Graben around the Ordos Block in Northern China. A total of 601 vertical displacements were measured on different geomorphic surfaces along the fault strike. Through statistical analysis of the displacement measurements, it is inferred that at least five to seven large earthquakes have ruptured this fault, displaying a remarkably regular slip increment of ∼2 m. Compared with the slip, the recurrence intervals of paleoearthquakes exposed by previous paleoseismic excavations are less regular, which may be due to the different recording capacity of geomorphic and paleoseismic markers. By recovering the surface slip distributions of several recent events, we identified several large full‐rupture earthquakes that may have broken two adjacent segments together and smaller partial‐rupture events that have ruptured only a part of the segment, thus suggesting a bimodal rupture behavior for the fault. Our estimates indicate that rupturing of the Sertengshan Piedmont Fault may yield a large earthquake of M_w 7.1–7.5, leading to significant seismic hazards in the densely populated Hetao Graben area.

Fault scarps preserve important information about past earthquakes on a fault, and thus can be applied to investigate the fault slip histories and rupture patterns. In this study, the morphology of fault scarps was used to constrain the paleoseismicity of the Wulashan Piedmont Fault located on the northern margin of the Ordos Block based on high-resolution LiDAR topography. We constructed the vertical displacement distribution of the fault through measuring the heights of a large number of scarp profiles extracted on different geomorphic surfaces along the fault. Through statistical analysis of the dense collection of vertical displacement dataset, a total of seven paleoseismic events were identified which followed a characteristic slip pattern with an average slip of ∼1.0 m. We further detected slope breaks in the fault scarp morphology to quantify the number of paleoearthquakes that occurred on the scarps, and discriminated at least five individual surface-breaking events. Both the number and slip of paleoearthquakes recognized from the morphology of fault scarps were in good agreement with previous paleoseismic trenching records. Based on the empirical scaling relationship between moment magnitude and rupture parameters, a moment magnitude ofM_w6.7–7.5 was determined for the paleoearthquakes occurred on the fault. With the fault slip rate derived by previous studies, we estimated an average recurrence interval of 1.3–1.8 kyr for the paleoseismic events, which is very close to the elapsed time since the most recent earthquake, indicating a high potential seismic hazard on the Wulashan Piedmont Fault.

Sea ice concentration (SIC) plays a significant role in climate change research and ship’s navigation in polar regions. Satellite-based SIC products have become increasingly abundant in recent years; however, the uncertainty of these products still exists and needs to be further investigated. To comprehensively evaluate the consistency of the SIC derived from different SIC algorithms in long time series and the whole polar regions, we compared four passive microwave (PM) satellite SIC products with the ERA-Interim sea ice fraction dataset during the period of 2015–2018. The PM SIC products include the SSMIS/ASI, AMSR2/BT, the Chinese FY3B/NT2, and FY3C/NT2. The results show that the remotely sensed SIC products derived from different SIC algorithms are generally in good consistency. The spatial and temporal distribution of discrepancy among satellite SIC products for both Arctic and Antarctic regions are also observed. The most noticeable difference for all the four SIC products mostly occurs in summer and at the marginal ice zone, indicating that large uncertainties exist in satellite SIC products in such period and areas. The SSMIS/ASI and AMSR2/BT show relatively better consistency with ERA-Interim in the Arctic and Antarctic, respectively, but they exhibit opposite bias (dry/wet) relative to the ERA-Interim data. The sea ice extent (SIE) and sea ice area (SIA) derived from PM and ERA-Interim SIC were also compared. It is found that the difference of PM SIE and SIA varies seasonally, which is in line with that of PM SIC, and the discrepancy between PM and ERA-Interim data is larger in Arctic than in Antarctic. We also noticed that different algorithms have different performances in different regions and periods; therefore, the hybrid of multiple algorithms is a promising way to improve the accuracy of SIC retrievals. It is expected that our findings can contribute to improving the satellite SIC algorithms and thus promote the application of these useful products in global climate change studies.

High‐resolution topographic data sets have now become increasingly available, which allows for remotely measuring and analyzing offset features and their associated slip distributions at a very high resolution along a fault, hence providing important insights into the fault behavior. The West Helanshan Fault is a Holocene active right‐lateral strike‐slip fault located at the junction of the Tibetan Plateau, Alashan, and Ordos blocks. In this study, a 2‐m‐resolution DEM of the West Helanshan Fault was built from the WorldView‐3 stereo satellite images (0.5 m). Combined with the high‐resolution topography acquired from the Unmanned Aerial Vehicle (UAV) images based on the Structure from Motion (SfM) method, a total of 180 lateral offsets and 201 vertical displacements were acquired along ~50 km of the fault. By statistical analysis of the offset observations and constructing the cumulative slip profiles, we conclude that large paleoearthquakes have produced characteristic slip accumulation along the fault with a right‐lateral slip of ~3 m and a vertical slip of ~1 m, rupturing at least two segments of the fault simultaneously, which corresponds to a moment magnitude ofM_w7.1 ~ 7.5. The cumulative slip profiles suggest that the fault has likely propagated northward over its lifetime, and the south segment may be the most mature section of the fault where larger coseismic slip of earthquake ruptures may occur. The ratio of lateral to vertical displacement has remained constant (~3:1) through multiple successive events, indicating that the fault has maintained the same kinematic style over the last few thousands of years.

Reconstruction of the along‐fault slip distribution provides an insight into the long‐term rupture patterns of a fault, thereby enabling more accurate assessment of its future behavior. The increasing wealth of high‐resolution topographic data, such as Light Detection and Ranging and photogrammetric digital elevation models, allows us to better constrain the slip distribution, thus greatly improving our understanding of fault behavior. The South Heli Shan Fault is a major active fault on the northeastern margin of the Tibetan Plateau. In this study, we built a 2 m resolution digital elevation model of the South Heli Shan Fault based on high‐resolution GeoEye‐1 stereo satellite imagery and then measured 302 vertical displacements along the fault, which increased the measurement density of previous field surveys by a factor of nearly 5. The cumulative displacements show an asymmetric distribution along the fault, comprising three major segments. An increasing trend from west to east indicates that the fault has likely propagated westward over its lifetime. The topographic relief of Heli Shan shows an asymmetry similar to the measured cumulative slip distribution, suggesting that the uplift of Heli Shan may result mainly from the long‐term activity of the South Heli Shan Fault. Furthermore, the cumulative displacements divide into discrete clusters along the fault, indicating that the fault has ruptured in several large earthquakes. By constraining the slip‐length distribution of each rupture, we found that the events do not support a characteristic recurrence model for the fault.