Ali A. Ghorbanpour Khamseh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ali A. Ghorbanpour Khamseh has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
M. H. Khani
Nuclear Fuel Cycle Research School, Nuclear Science and Technology Research Institute, Tehran, Iran
2 shared publicationsSohrab Ali Ghorbanian
Faculty of Chemical Engineering, School of Engineering, University of Tehran, Tehran, Iran
2 shared publications- Younes Amini
Nuclear Fuel Cycle Research School, Nuclear Science and Technology Research Institute, Tehran, Iran
2 shared publications Ahmad Ghadiri
Nuclear Fuel Cycle Research School, Nuclear Science and Technology Research Institute, Tehran, Iran
1 shared publicationAli Norouzi
Materials and Nuclear Fuel Research School, Nuclear Science and Technology Research Institute, Tehran, Iran
1 shared publicationFatemeh Mansourzadeh
Materials and Nuclear Fuel Research School, Nuclear Science and Technology Research Institute, Tehran, Iran
1 shared publication
Latest Publications
- Open Access
- 15 May 2025
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 1-11
Enhancing the adsorption of strontium (II) using TOPO impregnated Dowex 50 W-X8 resin
In this research work, the adsorption of strontium ions from aqueous solutions was studied using Dowex 50 W-X8 resin loaded with TOPO extractant. This study introduces a novel TOPO-impregnated adsorbent with potential applications for efficient and cost-effective nuclear wastewater treatment. The influence of effective operational parameters such as initial pH of the solution, adsorbent dosage, initial strontium concentration in the solution, and contact time was evaluated. In order to investigate the kinetics of the adsorption process, pseudo-first-order and pseudo-second-order models were used. The results indicated a very good agreement between the experimental data and the pseudo-first-order kinetic model. Langmuir and Freundlich models were used to model the equilibrium of the adsorption. Langmuir isotherm model showed good agreement with the experimental data. The maximum adsorption capacity of Dowex 50 W-X8 resin loaded with TOPO for strontium sorption was obtained 163.43 mg/g of adsorbent calculated by the Langmuir model. The result of the present study showed that Dowex 50 W-X8 resin loaded with TOPO extractant can be an effective adsorbent for the sorption of strontium from aqueous solutions and industrial wastewater.
- 15 May 2025
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 1-11
Open AccessEnhancing the adsorption of strontium (II) using TOPO impregnated Dowex 50 W-X8 resin
In this research work, the adsorption of strontium ions from aqueous solutions was studied using Dowex 50 W-X8 resin loaded with TOPO extractant. This study introduces a novel TOPO-impregnated adsorbent with potential applications for efficient and cost-effective nuclear wastewater treatment. The influence of effective operational parameters such as initial pH of the solution, adsorbent dosage, initial strontium concentration in the solution, and contact time was evaluated. In order to investigate the kinetics of the adsorption process, pseudo-first-order and pseudo-second-order models were used. The results indicated a very good agreement between the experimental data and the pseudo-first-order kinetic model. Langmuir and Freundlich models were used to model the equilibrium of the adsorption. Langmuir isotherm model showed good agreement with the experimental data. The maximum adsorption capacity of Dowex 50 W-X8 resin loaded with TOPO for strontium sorption was obtained 163.43 mg/g of adsorbent calculated by the Langmuir model. The result of the present study showed that Dowex 50 W-X8 resin loaded with TOPO extractant can be an effective adsorbent for the sorption of strontium from aqueous solutions and industrial wastewater.
- 3 February 2024
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 333 (3) , 1243-1252
Solvent extraction of uranium from leach liquor using dibutyl carbitol: optimization of parameters by response surface methodology
- 3 February 2024
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 333 (3) , 1243-1252
Solvent extraction of uranium from leach liquor using dibutyl carbitol: optimization of parameters by response surface methodology
- 5 July 2023
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 332 (8) , 3325-3334
Statistical analysis, equilibrium and dynamic study on the biosorption of strontium ions on Chlorella vulgaris
- 5 July 2023
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 332 (8) , 3325-3334
Statistical analysis, equilibrium and dynamic study on the biosorption of strontium ions on Chlorella vulgaris
- Open Access
- 24 May 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-12
Investigation of kinetic, isotherm and adsorption efficacy of thorium by orange peel immobilized on calcium alginate
In this research work the thorium uptake on immobilized protonated orange peel was studied in a batch system. The effects of effective parameters such as biosorbent dosage, initial metal ion concentration, and contact time on the biosorption of thorium were analyzed. The biosorption capacity of the immobilized orange peel for thorium at optimal conditions of initial pH 3.8, biosorbent dosage 8 g/L, and initial thorium concentration 170 mg/L was found to be 18.65 mg/g. According to the results of contact time, the biosorption process reached equilibrium after around 10 h of contact. Investigation of the kinetics showed that the biosorption of thorium onto immobilized orange peel follows the pseudo-second-order model. The Langmuir and Freundlich isotherms were used to model the experimental equilibrium data. The results showed better agreement by the Langmuir isotherm. The maximum absorption capacity of immobilized protonated orange peel for thorium adsorption was predicted by the Langmuir isotherm at 29.58 mg/g.
- 24 May 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-12
Open AccessInvestigation of kinetic, isotherm and adsorption efficacy of thorium by orange peel immobilized on calcium alginate
In this research work the thorium uptake on immobilized protonated orange peel was studied in a batch system. The effects of effective parameters such as biosorbent dosage, initial metal ion concentration, and contact time on the biosorption of thorium were analyzed. The biosorption capacity of the immobilized orange peel for thorium at optimal conditions of initial pH 3.8, biosorbent dosage 8 g/L, and initial thorium concentration 170 mg/L was found to be 18.65 mg/g. According to the results of contact time, the biosorption process reached equilibrium after around 10 h of contact. Investigation of the kinetics showed that the biosorption of thorium onto immobilized orange peel follows the pseudo-second-order model. The Langmuir and Freundlich isotherms were used to model the experimental equilibrium data. The results showed better agreement by the Langmuir isotherm. The maximum absorption capacity of immobilized protonated orange peel for thorium adsorption was predicted by the Langmuir isotherm at 29.58 mg/g.
- 24 January 2023
- Published by Walter de Gruyter GmbH in Chemical Product and Process Modeling
- Vol. 18 (4) , 657-670
Intensification of thorium biosorption onto protonated orange peel using the response surface methodology
In this research work, intensifying the possibility of protonated orange peel to uptake thorium (IV) ions from aqueous solutions in a batch system was investigated and optimized using the response surface methodology. The effect of three independent process variables including thorium initial concentration, pH, and biosorbent dosage was assessed based on the central composite design. The validity of the quadratic model was verified by the coefficient of determination. The optimization results showed that the rate of thorium (IV) uptake under optimal conditions is 183.95 mg/g. The modeling results showed that the experimental data of thorium biosorption kinetics are fitted well by the pseudo-second-order model. According to the results, the biosorption process reached equilibrium after around 4 h of contact. The Langmuir isotherm describes the experimental biosorption equilibrium data well. The maximum absorption capacity of protonated orange peel for thorium adsorption was estimated by the Langmuir isotherm at 236.97 mg/g. Thermodynamic studies show that thorium adsorption on protonated orange peel is thermodynamically feasible, spontaneous, and endothermic.
- 24 January 2023
- Published by Walter de Gruyter GmbH in Chemical Product and Process Modeling
- Vol. 18 (4) , 657-670
Intensification of thorium biosorption onto protonated orange peel using the response surface methodology
In this research work, intensifying the possibility of protonated orange peel to uptake thorium (IV) ions from aqueous solutions in a batch system was investigated and optimized using the response surface methodology. The effect of three independent process variables including thorium initial concentration, pH, and biosorbent dosage was assessed based on the central composite design. The validity of the quadratic model was verified by the coefficient of determination. The optimization results showed that the rate of thorium (IV) uptake under optimal conditions is 183.95 mg/g. The modeling results showed that the experimental data of thorium biosorption kinetics are fitted well by the pseudo-second-order model. According to the results, the biosorption process reached equilibrium after around 4 h of contact. The Langmuir isotherm describes the experimental biosorption equilibrium data well. The maximum absorption capacity of protonated orange peel for thorium adsorption was estimated by the Langmuir isotherm at 236.97 mg/g. Thermodynamic studies show that thorium adsorption on protonated orange peel is thermodynamically feasible, spontaneous, and endothermic.
- 1 August 2018
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 317 (2) , 871-879
Experimental and modeling investigation of thorium biosorption by orange peel in a continuous fixed-bed column
- 1 August 2018
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 317 (2) , 871-879
Experimental and modeling investigation of thorium biosorption by orange peel in a continuous fixed-bed column
- 2 March 2018
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 53 (13) , 2074-2087
Comparison of optimum tapered cascade and optimal square cascade for separation of xenon isotopes using enhanced TLBO algorithm
The present study is conducted to propose a new code for optimizing a multicomponent isotope separation cascade. An efficient code is developed using an enhanced TLBO algorithm with a novel mutation for calculating the optimal parameters. The results indicate that by implementing a new objective function derived from the combination of D function with total interstage flow rates, the optimum tapered cascade is more efficient than the optimal square one. Also, the best feed locations for the separation of the middle components in the square cascade are the middle stages.
- 2 March 2018
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 53 (13) , 2074-2087
Comparison of optimum tapered cascade and optimal square cascade for separation of xenon isotopes using enhanced TLBO algorithm
The present study is conducted to propose a new code for optimizing a multicomponent isotope separation cascade. An efficient code is developed using an enhanced TLBO algorithm with a novel mutation for calculating the optimal parameters. The results indicate that by implementing a new objective function derived from the combination of D function with total interstage flow rates, the optimum tapered cascade is more efficient than the optimal square one. Also, the best feed locations for the separation of the middle components in the square cascade are the middle stages.