AWAndreas Will

Andreas Will

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Andreas Will has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Impact of 440 GeV Proton beams on Superconductors in a Cryogenic Environment

    by A. Will, A. Bernhard, M. Bonura, B. Bordini, M. Mentink, A.-S. Mueller, A. Oslandsbotn, R. Schmidt, J. Schubert, C. Senatore, et al.

    The superconducting magnets used in high energy particle accelerators such as CERN’s LHC can be impacted by the circulating beam in case of specific failures. This leads to interaction of the beam particles with the magnet components, like the superconducting coils, through direct beam impact or via secondary particle showers. The interaction causes energy deposition in the timescale of microseconds and induces large thermal gradients within the superconductors, which are in the order of 100 K/mm. To investigate the effect on the superconductors, an experiment at CERN’s HiRadMat facility was designed and executed, exposing short samples of Nb-Ti and Nb3Sn strands in a cryogenic environment to microsecond 440 GeV proton beams. The irradiated samples were extracted and analyzed for their critical transport current I c. This paper describes the results and analysis of the measurements of I c as well as thermo-mechanical simulations of the Nb3Sn strands to evaluate the degradation of I c as a function of the mechanical strain present during and after the beam impact.


  • Open Access

    Characterization of the radiation tolerance of cryogenic diodes for the High Luminosity LHC inner triplet circuit

    by Andreas Will, G D’angelo, R Denz, D Hagedorn, A Monteuuis, E Ravaioli, F Rodriguez Mateos, A Siemko, K Stachon, A Verweij, et al.

    Cryogenic bypass diodes are part of the baseline powering layout for the circuits of the new Nb3Sn based final focus magnets of the high luminosity Large Hadron Collider. They will protect the magnets against excessive transient voltages during a nonuniform quenching process. The diodes are located inside an extension to the magnet cryostat, operated in superfluid helium and exposed to ionizing radiation. Therefore, the radiation tolerance of different types of diodes has been tested at cryogenic temperatures in CERN’s CHARM irradiation test facility during its 2018 run. The forward bias characteristics, the turn-on voltage and the reverse blocking voltage of each diode were measured weekly at 4.2 K and 77 K, as a function of the accumulated radiation dose. The diodes were submitted to a total dose close to 12 kGy and a 1 MeV neutron equivalent fluence of 2.2×1014  cm−2. After the end of the irradiation program the annealing behavior of the diodes was tested by increasing the temperature slowly to 293 K. This paper describes the experimental setup, the measurement procedure and the analysis of the measurements performed during the irradiation program as well as the results of the annealing study.


  • Performance of the Large Hadron Collider's Cryogenic Bypass Diodes Over the First Two Physics Runs, Future Projects, and Perspectives

    by Giorgio D'ANgelo, Zinour Charifoulline, Reiner Denz, Mathieu Favre, Dietrich Hagedorn, Arnaud Monteuuis, Felix Rodriguez-Mateos, Andrzej Siemko, Krzysztof Stachon, Arjan Verweij, et al.

    Cryogenic bypass diodes have been installed in all superconducting dipole magnets (1232) and quadrupole magnets (392) of the Large Hadron Collider (LHC) at CERN, and operated during the physics runs since 2009. The bypass diodes are a fundamental ingredient of the quench protection system for those main dipoles and quadrupoles magnets. The diodes are located inside the magnet cryostats, operating in superfluid helium and exposed to ionizing radiation. The connection between the superconducting magnet and the bypass diode is made through a mechanical clamping system and copper bus bars. Since their first installation, all LHC diodes have undergone at least two full thermal cycles (from 1.9 K to room temperature and back to superfluid helium temperature). The evolution of electrical parameters as well as improvements and modifications made over a period of 10 years are reviewed in this paper. With CERN preparing for LHC's High Luminosity era, the long-term strategy for cold diodes is presented, based on the overall results and experience gathered so far, including the studies related to the tolerance with respect to the radiation doses and neutron fluences expected.